Experimental investigation of two-phase distribution in parallel micro-T channels under adiabatic condition

Abstract The present work investigated the phase distribution of a gas–liquid flow in five parallel micro-T channels oriented horizontally and examined the flow behavior in header and branch channels, all with trapezoidal cross-section. The hydraulic diameters of the header and the branch channels were 0.611 mm and 0.438 mm, respectively. Pure water and 0.03 wt% SDS aqueous solution were selected as the liquid phase to study the effect of surface tension on gas–liquid flow in parallel micro-T channels. The inlet superficial velocity of gas (nitrogen) and liquid ranges were 0.161–20.080 m/s and 0.017–0.937 m/s, respectively. It was noticed that the added surfactant could facilitate the flow while higher surface tension of pure water led to the blockage of partial branch channels. It was indicated that the distribution characteristics of two-phase in branch channels highly depended on inlet flow patterns. At inlet of slug flow, a significant proportion of gas was rich in the second branch channel at high inlet gas superficial velocity. But when the inlet flow shifted to annular flow, a large amount of liquid flowed into the first and the last branch channels while gas was rich in the middle three channels. For inlet slug-annular flow, the distribution of gas and liquid took on a transitional characteristic.

[1]  Honggi Cho,et al.  MASS FLOW RATE DISTRIBUTION AND PHASE SEPARATION OF R-22 IN MULTI-MICROCHANNEL TUBES UNDER ADIABATIC CONDITION , 2004 .

[2]  Masahiro Kawaji,et al.  The effect of channel diameter on adiabatic two-phase flow characteristics in microchannels ☆ , 2004 .

[3]  Kui He,et al.  The effect of surface tension on phase distribution of two-phase flow in a micro-T-junction , 2011 .

[4]  L. Luo,et al.  Hydrodynamics and mass transfer characteristics in gas–liquid flow through a rectangular microchannel , 2007 .

[5]  Saif A. Khan,et al.  Transport and reaction in microscale segmented gas-liquid flow. , 2004, Lab on a chip.

[6]  Huaizhi Li,et al.  Asymmetrical breakup of bubbles at a microfluidic T-junction divergence: feedback effect of bubble collision , 2012 .

[7]  Mikio Suo,et al.  Two phase flow in capillary tubes , 1964 .

[8]  M. Vaillancourt,et al.  Two-Phase Flow Regime Transitions in Microchannels: A Comparative Experimental Study , 2005 .

[9]  Liu Qi,et al.  Gas-liquid two-phase flow division at a micro-T-junction , 2010 .

[10]  Asterios Gavriilidis,et al.  Mass transfer during Taylor flow in microchannels with and without chemical reaction , 2010 .

[11]  Ibrahim Hassan,et al.  Adiabatic two phase flow distribution and visualization in scaled microchannel heat sinks , 2007 .

[12]  Ziping Feng,et al.  Two-phase flow in microchannels , 2002 .

[13]  Said I. Abdel-Khalik,et al.  Gas–liquid two-phase flow in microchannels Part I: two-phase flow patterns , 1999 .

[14]  S. Hsieh,et al.  Liquid flow in a micro-channel , 2006 .

[15]  Jun Kyoung Lee,et al.  Distribution of two-phase annular flow at header–channel junctions , 2002 .

[16]  Kui He,et al.  Phase splitting of a slug–annular flow at a horizontal micro-T-junction , 2011 .

[17]  Saif A. Khan,et al.  Microfluidic emulsions with dynamic compound drops. , 2009, Lab on a chip.

[18]  Nae-Hyun Kim,et al.  Two-phase flow distribution of air–water annular flow in a parallel flow heat exchanger , 2006 .

[19]  Kui He,et al.  The effect of flow pattern on split of two-phase flow through a micro-T-junction , 2011 .

[20]  Jinfang Chen,et al.  Phase split of nitrogen/non-Newtonian fluid two-phase flow at a micro-T-junction , 2011 .

[21]  Transport of wetting liquid plugs in bifurcating microfluidic channels. , 2007, Journal of colloid and interface science.

[22]  Jun Kyoung Lee.  Two-phase flow behavior inside a header connected to multiple parallel channels , 2009 .

[23]  Dorian Liepmann,et al.  Effect of Flow on Complex Biological Macromolecules in Microfluidic Devices , 2001 .

[24]  Youguang Ma,et al.  Bubble formation and breakup mechanism in a microfluidic flow-focusing device , 2009 .