Acoustic source localization in anisotropic plates.

[1]  S. Cowin,et al.  On the Identification of Material Symmetry for Anisotropic Elastic Materials , 1987 .

[2]  Wolfgang Sachse,et al.  Location of pointlike acoustic emission sources in anisotropic plates , 1989 .

[3]  D. S. Kupperman.  Detector relies on sound to locate underground pipe leaks , 1990 .

[4]  T. Woodward,et al.  Find that leak , 1999 .

[5]  Fu-Kuo Chang,et al.  Diagnosis of impact damage in composite structures with built-in piezoelectrics network , 2000, Smart Structures.

[6]  Constantinos Soutis,et al.  Damage detection in composite materials using lamb wave methods , 2002 .

[7]  Steve Gibson,et al.  Damage detection in structures from vibration and wave propagation data , 2003, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[8]  Victor Giurgiutiu,et al.  Lamb wave generation with piezoelectric wafer active sensors for structural health monitoring , 2003, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[9]  Keith Worden,et al.  EXPERIMENTAL VALIDATION OF A STRUCTURAL HEALTH MONITORING METHODOLOGY: PART II. NOVELTY DETECTION ON A GNAT AIRCRAFT , 2003 .

[10]  W. Staszewski,et al.  Impact damage location in composite structures using optimized sensor triangulation procedure , 2003 .

[11]  Sauvik Banerjee,et al.  Acoustic emission waveforms in composite laminates under low velocity impact , 2003, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[12]  Randolph L. Moses,et al.  Source localization with isotropic arrays , 2004, IEEE Signal Processing Letters.

[13]  Keith Worden,et al.  An automatic impact monitor for a composite panel employing smart sensor technology , 2005 .

[14]  Jonghyun Park,et al.  System identification method for monitoring impact events , 2005, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[15]  Fabrizio Ricci,et al.  A Conceptual Structural Health Monitoring System based on Vibration and Wave Propagation , 2005 .

[16]  M. Fink,et al.  In solid localization of finger impacts using acoustic time-reversal process , 2005 .

[17]  Stephen D Holland,et al.  Locating air leaks in manned spacecraft using structure-borne noise. , 2007, The Journal of the Acoustical Society of America.

[18]  Manabu Enoki,et al.  Acquisition and Analysis of Continuous Acoustic Emission Waveform for Classification of Damage Sources in Ceramic Fiber Mat , 2007 .

[19]  T. Kundu,et al.  Point of impact prediction in isotropic and anisotropic plates from the acoustic emission data. , 2007, The Journal of the Acoustical Society of America.

[20]  M. Fink,et al.  Acoustic impact localization in plates: properties and stability to temperature variation , 2007, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[21]  T. Kundu,et al.  Locating point of impact in anisotropic fiber reinforced composite plates. , 2008, Ultrasonics.

[22]  Wing Kong Chiu,et al.  Optimal placement of sensors for sub-surface fatigue crack monitoring , 2009 .

[23]  Jonghyun Park,et al.  Monitoring Impact Events Using a System-Identification Method , 2009 .

[24]  Tribikram Kundu,et al.  An Introduction to Failure Mechanisms and Ultrasonic Inspection , 2010 .

[25]  Fu-Kuo Chang,et al.  Sensor Network Optimization for a Passive Sensing Impact Detection Technique , 2010 .

[26]  Steven D. Glaser,et al.  Beamforming array techniques for acoustic emission monitoring of large concrete structures , 2010 .

[27]  Tribikram Kundu,et al.  An improved algorithm for detecting point of impact in anisotropic inhomogeneous plates. , 2011, Ultrasonics.

[28]  Salvatore Salamone,et al.  Validation of the piezoelectric rosette technique for locating impacts in complex aerospace panels , 2011, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.