Heat Transfer From a Rotating Disc

The local heat transfer from a plane rotating disc enclosed in a casing has been studied experimentally. The disc of 800 mm diameter can be run up to 2000 min−1 at axial distances between disc and casing varied between 5 and 55 mm. Centrifugal or alternatively centripetal flow of cooling air at rates up to m = 1 kg/s can be applied, both with or without an inlet swirl.With the disc rotating in a closed casing (m = 0 kg/s) the influence of the characteristic dimensionless groups on the local heat transfer has been investigated. At a fixed radius, a variation of the local Reynolds Number by either speed or density results in corresponding changes of the heat transfer. However, with a variation of the radius different heat transfer-Re relations are found. In fact, the temperature distribution in the gas caused by the heat flux results in an additional influence of free convection, to be expressed by a Grashof Number. This is confirmed by a comparison of the experimental results with calculations based on Reynolds Analogy and measured friction coefficients. The discrepancies found can be explained only, if in addition to the limitations of the analogy, the influence of free convection is taken into account. Additional results of ongoing experiments concerning the influence of the geometry of the cavity between disc and casing, of the coolant flow rate and of the swirl are presented.Copyright © 1990 by ASME