Experimental and numerical investigation of a backside convective cooling mechanism on photovoltaic panels

In this paper, two generic photovoltaic (PV) panels (poly-Si and mono-Si) were experimentally tested in typical Mediterranean climatic conditions. The focus of the applied experimental approach was to examine the effect of backside convective thermal profile and its impact on temperature distribution, i.e. on panel electrical efficiency. Therefore, a series of measurements was made in 2015, from April to July, as well as CFD modeling in order to obtain a detailed analysis of the possible working regimes. According to the obtained experimental and CFD results, the present design of typical PV panels have an unfavorable impact on PV panel electrical efficiency. Namely, typical contemporary panel designs lead to two typical backside convective air temperature profiles which have a direct impact on the effectiveness of natural cooling. As shown in the obtained measurements, the specific convective profiles at the backside of PV panels have a significant influence on the degradation rate of panel electrical efficiency in the estimated amount of 2.5% up to 4.5%. The results of the research discussed in this paper signal the need to provide a possible redesign of the backside surface in conventional PV panels, in order to increase their average efficiency (more efficient backside thermal dissipation).

[1]  Huan-Liang Tsai,et al.  Modeling and validation of refrigerant-based PVT-assisted heat pump water heating (PVTA–HPWH) system , 2015 .

[2]  D. Petreus,et al.  A novel MPPT (maximum power point tracking) algorithm based on a modified genetic algorithm specialized on tracking the global maximum power point in photovoltaic systems affected by partial shading , 2014 .

[3]  Abdul Hai Alami,et al.  Effects of evaporative cooling on efficiency of photovoltaic modules , 2014 .

[4]  T. Senthilkumar,et al.  Passive cooling of standalone flat PV module with cotton wick structures , 2013 .

[5]  Hongxing Yang,et al.  Thermal regulation of photovoltaic cladding , 1997 .

[6]  Ruobing Liang,et al.  Performance evaluation of new type hybrid photovoltaic/thermal solar collector by experimental study , 2015 .

[7]  F. Menter.  Two-equation eddy-viscosity turbulence models for engineering applications , 1994 .

[8]  Zdeslav Matić.  Solar Radiation Atlas For The Area Of The Republic Of Croatia , 2004 .

[9]  Christopher J. Smith,et al.  Global analysis of photovoltaic energy output enhanced by phase change material cooling , 2014 .

[10]  Shafiqur Rehman,et al.  Performance evaluation of a PV (photovoltaic) module by back surface water cooling for hot climatic conditions , 2013 .

[11]  Kuei-Hsiang Chao,et al.  An extension theory-based maximum power tracker using a particle swarm optimization algorithm , 2014 .

[12]  Jan Carmeliet,et al.  CFD analysis of convective heat transfer at the surfaces of a cube immersed in a turbulent boundary layer , 2010 .

[13]  Jonas Allegrini,et al.  A review of modelling approaches and tools for the simulation of district-scale energy systems , 2015 .

[14]  Palanichamy Gandhidasan,et al.  Comparative study of double-pass flat and compound parabolic concentrated photovoltaic–thermal systems with and without fins , 2015 .

[15]  Christophe Menezo,et al.  Modeling of coupled spectral radiation, thermal and carrier transport in a silicon photovoltaic cell , 2006 .

[16]  Mohammad Nurul Alam Hawlader,et al.  An active cooling system for photovoltaic modules , 2012 .

[17]  Lei Cao,et al.  Dynamic performances modeling of a photovoltaic–thermal collector with water heating in buildings , 2013 .

[18]  Oussama Rejeb,et al.  A numerical investigation of a photovoltaic thermal (PV/T) collector , 2015 .

[19]  Wei Liu,et al.  A novel maximum power point tracking strategy based on optimal voltage control for photovoltaic systems under variable environmental conditions , 2015 .

[20]  I. Dincer,et al.  Thermodynamic analysis of a combined PV/T–fuel cell system for power, heat, fresh water and hydrogen production , 2014 .

[21]  Horia Hangan,et al.  Numerical simulation of wind effects on a stand-alone ground mounted photovoltaic (PV) system , 2014 .

[22]  Masoud Rahimi,et al.  Using a wind-driven ventilator to enhance a photovoltaic cell power generation , 2014 .

[23]  Sandro Nižetić,et al.  Water spray cooling technique applied on a photovoltaic panel: The performance response , 2016 .

[24]  Shaowu Li.  A maximum power point tracking method with variable weather parameters based on input resistance for photovoltaic system , 2015 .

[25]  Elif Ertekin,et al.  Phonon transport on two-dimensional graphene/boron nitride superlattices , 2014 .

[26]  S. C. Solanki,et al.  Photovoltaic modules and their applications: A review on thermal modelling , 2011 .

[27]  Girish Kumar Singh,et al.  Solar power generation by PV (photovoltaic) technology: A review , 2013 .

[28]  N. H. Saad,et al.  Enhancing the maximum power point tracking techniques for photovoltaic systems , 2014 .

[29]  Z. Salam,et al.  An improved perturb and observe (P&O) maximum power point tracking (MPPT) algorithm for higher efficiency , 2015 .

[30]  Hua Wang,et al.  A Laboratory experimental study on effect of porous medium on salt diffusion of salt gradient solar pond , 2015 .

[31]  Ashish Mittal,et al.  Computational fluid dynamics analysis and experimental validation of improvement in overall energy efficiency of a solar photovoltaic panel by thermal energy recovery , 2014 .

[32]  Laura Schaefer,et al.  Performance evaluation of a PVT/ORC (photovoltaic thermal/organic Rankine cycle) system with optimization of the ORC and evaluation of several PV (photovoltaic) materials , 2015 .