CHF characteristics of R-134a flowing upward in uniformly heated vertical tube

Abstract An experimental study of the critical heat flux (CHF) using R-134a in uniformly heated vertical tube was performed and 182 CHF data points were obtained from the present work to investigate the CHF characteristics of R-134a. The investigated flow parameters in R-134a were: (1) outlet pressures of 13, 16.5, 23.9 bar, (2) mass fluxes of 285–1300 kg/m 2  s, (3) subcooling temperatures of 5–40 °C. The CHF tests were performed in a 17.04 mm I.D. test section with heated length of 3 m. The parametric trends of CHF show a general agreement with previous understanding in the water. To assess the suitability of the CHF test using R-134a for modeling the CHF in water, Bowring correlation and Katto correlation were used in the present investigation. It was found that the present test results coincided well with the data predicted with both correlations. It demonstrates that the R-134a can be used as the CHF modeling fluid of water for the investigated flow conditions and geometric condition.

[1]  K. Becker,et al.  BURNOUT CONDITIONS FOR ROUND TUBES AT ELEVATED PRESSURES , 1972 .

[2]  D. C. Groeneveld,et al.  Critical heat flux measurements in a round tube for CFCs and CFC alternatives , 1993 .

[3]  M. Shah.  Improved general correlation for critical heat flux during upflow in uniformly heated vertical tubes , 1987 .

[4]  Y. Katto,et al.  An improved version of the generalized correlation of critical heat flux for the forced convective boiling in uniformly heated vertical tubes , 1984 .

[5]  Y. Katto.  A generalized correlation of critical heat flux for the forced convection boiling in vertical uniformly heated round tubes , 1978 .

[6]  Soon Heung Chang,et al.  Parametric trends analysis of the critical heat flux based on artificial neural networks , 1996 .

[7]  M. Mohammed Shah,et al.  A generalized graphical method for predicting chf in uniformly heated vertical tubes , 1979 .

[8]  U. Müller,et al.  Critical heat flux in uniformly heated vertical tubes , 1997 .

[9]  D. C. Groeneveld,et al.  Comparison of CHF measurements in R-134a cooled tubes and the water CHF look-up table , 2001 .

[10]  S. Y. Ahmad.  Fluid to fluid modeling of critical heat flux: A compensated distortion model , 1973 .

[11]  Two-Phase Heat Transfer to New Refrigerants. , 1994 .

[12]  E. Royer,et al.  The 1995 look-up table for critical heat flux in tubes , 1996 .

[13]  Y. Katto,et al.  An analytical investigation on CHF of flow boiling in uniformly heated vertical tubes with special reference to governing dimensionless groups , 1982 .

[14]  Won-Pil Baek,et al.  Visualization of the subcooled flow boiling of R-134a in a vertical rectangular channel with an electrically heated wall , 2004 .

[15]  Y. Katto,et al.  On the heat-flux/exit-quality type correlation of chf of forced convection boiling in uniformly heated vertical tubes , 1981 .