Optimized Power Error Comparison Strategy for Direct Power Control of the Open-Winding Brushless Doubly Fed Wind Power Generator

This paper presents the simulation and experimental evaluation of a novel power error comparison direct power control (PEC-DPC) strategy of the open-winding brushless doubly fed reluctance generator (OW-BDFRG) for wind energy conversion systems. As one of the promising candidates for limited speed range application of pump-alike and wind turbine with partially rated converter. The emerging OW-BDFRG employed for the proposed PEC-DPC is fed via dual low-cost two-level converters, while the DPC concept is derived from the fundamental dynamic analyses of the calculated and controllable electrical power and flux of the BDFRG with two stators measurable voltage and current. Compared to the traditional two-level and three-level converter systems, the OW-BDFRG requires lower rated capacity of power devices and switching frequency converter, though have more flexible switching mode, higher reliability, redundancy, and fault tolerance capability. The performance correctness and effectiveness of the proposed DPC strategy with the selected and optimized switching vector scheme are evaluated and confirmed on a 25 kW generator test rig.

[1]  Milutin Jovanovic,et al.  Wind power applications of doubly-fed reluctance generators with parameter-free hysteresis control , 2017 .

[2]  Hassan M. H. Farh,et al.  Maximum Power Extraction from Utility-Interfaced Wind Turbines , 2013 .

[3]  Yijie Zhou,et al.  Zero-Sequence Current Suppression Strategy for Open Winding PMSG Fed by Semicontrolled Converter , 2016, IEEE Transactions on Power Electronics.

[4]  Wenping Cao,et al.  A New Sensorless Speed Control Scheme for Doubly Fed Reluctance Generators , 2016, IEEE Transactions on Energy Conversion.

[5]  Milutin Jovanovic,et al.  Brushless doubly-fed machines: Opportunities and challenges , 2018, Chinese Journal of Electrical Engineering.

[6]  Hirofumi Akagi,et al.  A New Neutral-Point-Clamped PWM Inverter , 1981, IEEE Transactions on Industry Applications.

[7]  Yijie Zhou,et al.  Zero-Sequence Current Suppression Strategy of Open-Winding PMSG System With Common DC Bus Based on Zero Vector Redistribution , 2015, IEEE Transactions on Industrial Electronics.

[8]  Sul Ademi,et al.  Control of Brushless Doubly-Fed Reluctance Generators for Wind Energy Conversion Systems , 2015, IEEE Transactions on Energy Conversion.

[9]  Milutin Jovanovic,et al.  Practical Implementation of Sensorless Torque and Reactive Power Control of Doubly Fed Machines , 2012, IEEE Transactions on Industrial Electronics.

[10]  V. T. Somasekhar,et al.  Effect of Zero-Vector Placement in a Dual-Inverter Fed Open-End Winding Induction Motor Drive With Alternate Sub-Hexagonal Center PWM Switching Scheme , 2008, IEEE Transactions on Power Electronics.

[11]  Ahmadreza Tabesh,et al.  Control of DFIG Wind Power Generators in Unbalanced Microgrids Based on Instantaneous Power Theory , 2017, IEEE Transactions on Smart Grid.

[12]  Milutin Jovanovic Sensored and sensorless speed control methods for brushless doubly fed reluctance motors , 2009 .

[13]  Peter Tavner,et al.  Low voltage ride-through of DFIG and brushless DFIG: Similarities and differences , 2014 .

[14]  Fengge Zhang,et al.  Parameter Calculation and Analysis of a Novel Wind Power Generator , 2017, IEEE Transactions on Magnetics.

[15]  E. Levi,et al.  Encoderless direct torque controller for limited speed range applications of brushless doubly fed reluctance motors , 2006, IEEE Transactions on Industry Applications.

[16]  R. E. Betz,et al.  Theoretical Analysis of Control Properties for the Brushless Doubly Fed Reluctance Machine , 2002, IEEE Power Engineering Review.

[17]  Sul Ademi,et al.  Vector Control Methods for Brushless Doubly Fed Reluctance Machines , 2015, IEEE Transactions on Industrial Electronics.

[18]  Xin Wang,et al.  Indirect Stator-Quantities Control for the Brushless Doubly Fed Induction Machine , 2014, IEEE Transactions on Power Electronics.

[19]  Longya Xu,et al.  Design and control of a high-efficiency Doubly-Fed Brushless machine for wind power generator application , 2010, 2010 IEEE Energy Conversion Congress and Exposition.

[20]  Seyed M. Madani,et al.  Super-Twisting Sliding Mode Direct Power Control of a Brushless Doubly Fed Induction Generator , 2018, IEEE Transactions on Industrial Electronics.

[21]  M. Jovanovic,et al.  Toward a Generic Torque and Reactive Power Controller for Doubly Fed Machines , 2012, IEEE Transactions on Power Electronics.

[22]  R.E. Betz,et al.  The use of doubly fed reluctance machines for large pumps and wind turbines , 2001, Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248).

[23]  G. D. Marques,et al.  Stator Flux Active Damping Methods for Field-Oriented Doubly Fed Induction Generator , 2012, IEEE Transactions on Energy Conversion.

[24]  Longya Xu,et al.  Parameter and performance comparison of doubly-fed brushless machine with cage and reluctance rotors , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[25]  Fengge Zhang,et al.  Developing a New SVPWM Control Strategy for Open-Winding Brushless Doubly Fed Reluctance Generators , 2015, IEEE Transactions on Industry Applications.