A Finite-Element Approach to Analyze the Thermal Effect of Defects on Silicon-Based PV Cells

The paper introduces the issue of the typical defects in photovoltaic (PV) cells and focuses the attention on three specific defects: linear edge shunt, hole, and conductive intrusion. These defects are modeled by means of finite-element method and implemented in Comsol Multiphysics environment to analyze the temperature distribution in the whole defected PV cell. All the three typologies of silicon-based PV cells are considered: monocrystalline, polycrystalline, and amorphous. Numerical issues (simulation times, degrees of freedom, mesh elements, and grid dependence analysis) are reported.

[1]  Jawad Faiz,et al.  Static-, Dynamic-, and Mixed-Eccentricity Fault Diagnoses in Permanent-Magnet Synchronous Motors , 2009, IEEE Transactions on Industrial Electronics.

[2]  Otwin Breitenstein,et al.  Material-induced shunts in multicrystalline silicon solar cells , 2007 .

[3]  Otwin Breitenstein,et al.  Shunts due to laser scribing of solar cells evaluated by highly sensitive lock-in thermography , 2001 .

[4]  Paolo Maffezzoni,et al.  Modeling and Simulation of a Hybrid Photovoltaic Module Equipped With a Heat-Recovery System , 2009, IEEE Transactions on Industrial Electronics.

[5]  William Gerard Hurley,et al.  A thermal model for photovoltaic panels under varying atmospheric conditions , 2010 .

[6]  Jasmin Smajic,et al.  Coupled Electromagnetic–Thermal Effects of Stray Flux: Software Solution for Industrial Applications , 2010, IEEE Transactions on Industrial Electronics.

[7]  Abdellatif Miraoui,et al.  Fast Computation of Electromagnetic Vibrations in Electrical Machines via Field Reconstruction Method and Knowledge of Mechanical Impulse Response , 2012, IEEE Transactions on Industrial Electronics.

[8]  Fabrizio Marignetti,et al.  Design of Axial Flux PM Synchronous Machines Through 3-D Coupled Electromagnetic Thermal and Fluid-Dynamical Finite-Element Analysis , 2008, IEEE Transactions on Industrial Electronics.

[9]  S. Vergura,et al.  Typical defects of PV-cells , 2010, 2010 IEEE International Symposium on Industrial Electronics.

[10]  Otwin Breitenstein,et al.  Quantitative evaluation of shunts in solar cells by lock‐in thermography , 2003 .

[11]  J. A. Kratochvil,et al.  Applications for infrared imaging equipment in photovoltaic cell, module, and system testing , 2000, Conference Record of the Twenty-Eighth IEEE Photovoltaic Specialists Conference - 2000 (Cat. No.00CH37036).

[12]  Peter N. Gorley,et al.  Photovoltaic solar cells performance at elevated temperatures , 2005 .

[13]  E. Skoplaki,et al.  ON THE TEMPERATURE DEPENDENCE OF PHOTOVOLTAIC MODULE ELECTRICAL PERFORMANCE: A REVIEW OF EFFICIENCY/ POWER CORRELATIONS , 2009 .

[14]  Ha Herbert Zondag,et al.  Flat-plate PV-Thermal collectors and systems : a review , 2008 .

[15]  S. Vergura,et al.  3-D PV-cell model by means of FEM , 2009, 2009 International Conference on Clean Electrical Power.

[16]  M. Werner,et al.  Shunt types in crystalline silicon solar cells , 2004 .

[17]  Ernani Sartori,et al.  Convection coefficient equations for forced air flow over flat surfaces , 2006 .