Operation of a cyclonic preheater in the Ca-looping for CO2 capture.

Calcium looping is an emerging technology for CO2 capture that makes use of the calcium oxide as a sorbent. One of its main issues is the significant energy consumption in the calciner, where the regeneration of the sorbent takes place. Nevertheless, as a high temperature looping technology, the surplus heat flows may be used to reduce the energy needs in this reactor. The addition of a cyclonic preheater similar to those used in the cement industry is proposed in this work. A calcium looping system was modeled and simulated to assess the advantages and disadvantages of the inclusion of a cyclonic preheater. Despite the negative effect on the maximum average capture capacity of the sorbent, a reduction on the coal and oxygen consumptions and on the extra CO2 generated in the calciner is obtained.

[1]  Borja Arias,et al.  Investigation of SO2 Capture in a Circulating Fluidized Bed Carbonator of a Ca Looping Cycle , 2013 .

[2]  Gemma Grasa,et al.  Modelling the continuous calcination of CaCO3 in a Ca-looping system , 2013 .

[3]  Fabio Montagnaro,et al.  Fluidized bed calcium looping: The effect of SO2 on sorbent attrition and CO2 capture capacity , 2012 .

[4]  J. Valverde,et al.  Enhancement of fast CO2 capture by a nano-SiO2/CaO composite at Ca-looping conditions. , 2012, Environmental science & technology.

[5]  Luis M. Romeo,et al.  Energy penalty reduction in the calcium looping cycle , 2012 .

[6]  Changlei Qin,et al.  Fabrication of CaO-based sorbents for CO₂ capture by a mixing method. , 2012, Environmental science & technology.

[7]  Borja Arias,et al.  Kinetics of Calcination of Partially Carbonated Particles in a Ca-Looping System for CO2 Capture , 2012 .

[8]  Nicholas H. Florin,et al.  Influence of high-temperature steam on the reactivity of CaO sorbent for CO₂ capture. , 2012, Environmental science & technology.

[9]  Borja Arias,et al.  Experimental Validation of the Calcium Looping CO2 Capture Process with Two Circulating Fluidized Bed Carbonator Reactors , 2011 .

[10]  J. C. Abanades,et al.  Experimental investigation of a circulating fluidized‐bed reactor to capture CO2 with CaO , 2011 .

[11]  Mónica Alonso,et al.  Sorbent attrition in a carbonation/calcination pilot plant for capturing CO2 from flue gases , 2010 .

[12]  Juan Carlos Abanades,et al.  Average activity of CaO particles in a calcium looping system , 2010 .

[13]  Vasilije Manovic,et al.  Competition of sulphation and carbonation reactions during looping cycles for CO2 capture by CaO-based sorbents. , 2010, The journal of physical chemistry. A.

[14]  J. C. Abanades,et al.  Modelling of a fluidized bed carbonator reactor to capture CO2 from a combustion flue gas , 2009 .

[15]  Eric Croiset,et al.  Process analysis of CO2 capture from flue gas using carbonation/calcination cycles , 2008 .

[16]  Junfu Lu,et al.  Particle Holdup and Average Residence Time in the Cyclone of a CFB Boiler , 2008 .

[17]  J. C. Abanades,et al.  Cost structure of a postcombustion CO2 capture system using CaO. , 2007, Environmental science & technology.

[18]  Vivek V. Ranade,et al.  Rotary Cement Kiln Simulator (RoCKS): Integrated modeling of pre-heater, calciner, kiln and clinker cooler , 2007 .

[19]  J. Carlos Abanades,et al.  CO2 Capture Capacity of CaO in Long Series of Carbonation/Calcination Cycles , 2006 .

[20]  E. J. Anthony,et al.  Fluidized bed combustion systems integrating CO2 capture with CaO. , 2005, Environmental science & technology.

[21]  Jose Manuel Valverde,et al.  Ca-based synthetic materials with enhanced CO2 capture efficiency , 2013 .