Propane reforming on Ni–Ru/GDC catalyst: H2 production for IT-SOFCs under SR and ATR conditions

Abstract Steam and auto-thermal reforming of propane over a Ni–Ru/GDC catalyst prepared by hydrothermal method were investigated under intermediate temperature solid oxide fuel cell (IT-SOFC) operating conditions. Such an approach is propaedeutical for the application of the catalyst in IT-SOFC. At reaction temperature higher than 700 °C, under both steam reforming (SR) and auto-thermal reforming (ATR), high propane conversion and syngas (H 2  + CO) productivity were obtained. In SR significant amount of filamentous carbon was formed mainly at 600 °C, with subsequent catalyst deactivation. In ATR, coke formation was completely depressed and the catalyst resulted to be very stable in all investigated reaction conditions. Notwithstanding the oxygen storage capability and redox properties of ceria in promoting both oxygen activation and carbon residues gasification, without oxygen in gas phase the concentration of oxygen vacancies itself were not able to inhibit carbon deposition. On the other hand, the presence of oxygen in the reaction stream slightly negatively reflects on syngas production, since it promotes CO 2 and H 2 O formation; however, the loss in selectivity is widely compensated by the absence of deactivation phenomena.

[1]  T. Paryjczak,et al.  Characterization of alumina supported nickel-ruthenium systems , 1995 .

[2]  Raymond J. Gorte,et al.  Ceria-Based Anodes for the Direct Oxidation of Methane in Solid Oxide Fuel Cells , 1995 .

[3]  H. Williams,et al.  Effects of composition and processing method on the low temperature conductivity of samaria-doped ceria electrolytes , 1999 .

[4]  George R. Gavalas,et al.  Methane partial oxidation on Pt/CeO2 and Pt/Al2O3 catalysts , 2002 .

[5]  S. Imamura,et al.  Effect of cerium on the mobility of oxygen on manganese oxides , 1996 .

[6]  H. Uchida,et al.  High Performance Catalyzed‐Reaction Layer for Medium Temperature Operating Solid Oxide Fuel Cells , 1994 .

[7]  R. Gorte,et al.  Evidence for a Second CO Oxidation Mechanism on Rh/Ceria , 1993 .

[8]  Young-Sam Oh,et al.  Methane reforming over Ni/Ce-ZrO2 catalysts: effect of nickel content , 2002 .

[9]  Takashi Hibino,et al.  Ru-catalyzed anode materials for direct hydrocarbon SOFCs , 2003 .

[10]  V. Choudhary,et al.  Energy efficient conversion of methane to syngas over NiO-MgO solid solution , 2000 .

[11]  A. Holmen,et al.  Production of hydrogen by short contact time partial oxidation and oxidative steam reforming of propane , 2005 .

[12]  N. Sammes,et al.  Physical, chemical and electrochemical properties of pure and doped ceria , 2000 .

[13]  M. Watanabe,et al.  High‐Performance Electrode for Medium‐Temperature Solid Oxide Fuel Cell Control of Microstructure of Ceria‐Based Anodes with Highly Dispersed Ruthenium Electrocatalysts , 1999 .

[14]  Scott A. Barnett,et al.  Use of a catalyst layer for propane partial oxidation in solid oxide fuel cells , 2005 .

[15]  J. Walmsley,et al.  Small-scale hydrogen production from propane , 2005 .

[16]  E. Tanabe,et al.  Filamentous carbon prepared by the catalytic pyrolysis of CH4 on Ni/SiO2 , 2002 .

[17]  D. Trimm,et al.  The influence of water on the reduction and reoxidation of ceria , 1993 .

[18]  H. Inaba,et al.  Sintering behaviors of ceria and gadolinia-doped ceria , 1998 .

[19]  I. Riess,et al.  Density and Ionic Conductivity of Sintered (CeO2)0.82(GdO1.5)o.18 , 1981 .

[20]  M. Vannice,et al.  Characterization of Ni/TiO2 catalysts by TEM, X-ray diffraction, and chemisorption techniques , 1981 .

[21]  Subir Roychoudhury,et al.  Catalytic partial “oxidation of methane to syngas” at elevated pressures , 2005 .

[22]  Ta-Jen Huang,et al.  Study of Ni-samaria-doped ceria anode for direct oxidation of methane in solid oxide fuel cells , 2003 .

[23]  Julian R.H. Ross,et al.  The effect of O2 addition on the carbon dioxide reforming of methane over Pt/ZrO2 catalysts , 1998 .

[24]  S. Jiang,et al.  A review of anode materials development in solid oxide fuel cells , 2004 .

[25]  P. C. Das,et al.  Carbon monoxide hydrogenation over various titania-supported Ru–Ni bimetallic catalysts , 2004 .

[26]  V. Choudhary,et al.  High-temperature stable and highly active/selective supported NiCoMgCeOx catalyst suitable for autothermal reforming of methane to syngas , 2005 .

[27]  V. Choudhary,et al.  Partial oxidation of methane to syngas with or without simultaneous CO2 and steam reforming reactions over Ni/AlPO4 , 1998 .

[28]  Suttichai Assabumrungrat,et al.  Catalytic steam reforming of methane, methanol, and ethanol over Ni/YSZ : The possible use of these fuels in internal reforming SOFC , 2007 .

[29]  Brian C. H. Steele,et al.  Appraisal of Ce1−yGdyO2−y/2 electrolytes for IT-SOFC operation at 500°C , 2000 .

[30]  R. Gorte,et al.  Evidence for Low-Temperature Oxygen Migration from Ceria to Rh , 1993 .

[31]  R. Kikuchi,et al.  Effect of precious metal addition to Ni-YSZ cermet on reforming of CH4 and electrochemical activity as SOFC anode , 2003 .

[32]  S. Badwal,et al.  Investigation of the stability of ceria-gadolinia electrolytes in solid oxide fuel cell environments , 1999 .

[33]  J. Rynkowski,et al.  Reforming of methane with carbon dioxide over supported bimetallic catalysts containing Ni and noble metal: I. Characterization and activity of SiO2 supported Ni–Rh catalysts , 2005 .

[34]  M. Dokiya,et al.  Electrical and Ionic Conductivity of Gd‐Doped Ceria , 2000 .

[35]  Gao Qing Lu,et al.  A Comprehensive Study on Carbon Dioxide Reforming of Methane over Ni/γ-Al2O3 Catalysts , 1999 .

[36]  Umit S. Ozkan,et al.  Deactivation characteristics of lanthanide-promoted sol–gel Ni/Al2O3 catalysts in propane steam reforming , 2005 .

[37]  J. Rostrup-Nielsen,et al.  Innovation and science in the process industry: Steam reforming and hydrogenolysis , 1999 .

[38]  S. Takenaka,et al.  Ni/SiO2 catalyst effective for methane decomposition into hydrogen and carbon nanofiber , 2003 .

[39]  A. Trovarelli,et al.  Catalytic Properties of Ceria and CeO2-Containing Materials , 1996 .

[40]  S. Assabumrungrat,et al.  Hydrogen production from steam and autothermal reforming of LPG over high surface area ceria , 2006 .

[41]  A. M. Efstathiou,et al.  Characterization of Carbonaceous Species Formed during Reforming of CH4with CO2over Ni/CaO–Al2O3Catalysts Studied by Various Transient Techniques , 1996 .