Evolution of Rolls-royce Air-cooled Turbine Blades and Feature Analysis

Abstract During past few decades there has been significant increase in turbine entry temperature (TET) in order to improve gas turbine ability and efficiency, which represents a huge challenge to turbine blades. Rolls-Royce maintains world-leading technology and capability in gas turbines design and manufacture, this study mainly focuses on the evolution of air-cooled turbine blades fabricated by Rolls-Royce, which shows that turbine blade developments are increasingly dependent on the improvement of material science and blade cooling technology. Moreover, its unique blade tip designs which minimize over-tip leakage are also reviewed. Future developments to improve turbine blade ability and reliability including high temperature materials, blade cooling technology and CFD analyzing approach are discussed.

[1]  T. Arts.  Turbine blade tip design and tip clearance treatment, January 19-23, 2004 , 2004 .

[2]  Qiang Zhang,et al.  Aerothermal Performance of a Cooled Winglet at Engine Representative Mach and Reynolds Numbers , 2011 .

[3]  Howard Hodson,et al.  The Reduction of Over Tip Leakage Loss in Unshrouded Axial Turbines Using Winglets and Squealers , 2014 .

[4]  Srinath V. Ekkad,et al.  Gas Turbine Heat Transfer and Cooling Technology , 2012 .

[5]  John D. Denton,et al.  The 1993 IGTI Scholar Lecture: Loss Mechanisms in Turbomachines , 1993 .

[6]  Neil William Harvey,et al.  An Investigation Into a Novel Turbine Rotor Winglet: Part 2 — Numerical Simulation and Experimental Results , 2006 .

[7]  Clifford Goodman,et al.  American Society of Mechanical Engineers , 1988 .

[8]  H. Hodson,et al.  Effects of Endwall Motion on the Aero-Thermal Performance of a Winglet Tip in a HP Turbine , 2012 .

[9]  R. Bhattacharya.  Advanced Thermal Barrier Coating , 2000 .

[10]  J. Michael Owen.  Developments in Aeroengines , 2001 .

[11]  R. Arthey,et al.  Development of Single Crystal Alloys for Specific Engine Applications , 1986 .

[12]  Achmed Schulz,et al.  Adiabatic Wall Effectiveness Measurements of Film-Cooling Holes With Expanded Exits , 1997 .

[13]  R. J. Goldstein,et al.  Effects of hole geometry and density on three-dimensional film cooling , 1974 .

[14]  Mark Stokes,et al.  Effects of Winglet Geometry on the Aerodynamic Performance of Tip Leakage Flow in a Turbine Cascade , 2013 .

[15]  Neil William Harvey,et al.  An Investigation Into a Novel Turbine Rotor Winglet: Part I — Design and Model Rig Test Results , 2006 .