Energy and exergy analysis of photovoltaic-thermal collector with and without glass cover

In photovoltaic-thermal (PV/T) technology, the use of glass cover on the flat-plate hybrid solar collector is favorable to the photothermic process but not to the photovoltaic process. Because of the difference in the usefulness of electricity and thermal energy, there is often no straight forward answer on whether a glazed or unglazed collector system is more suitable for a specific application. This glazing issue was tackled in this paper from the viewpoint of thermodynamics. Based on experimental data and validated numerical models, a study of the appropriateness of glass cover on a thermosyphon-based water-heating PV/T system was carried out. The influences of six selected operating parameters were evaluated. From the first law point of view, a glazed PV/T system is found always suitable if we are to maximize the quantity of either the thermal or the overall energy output. From the exergy analysis point of view however, the increase of PV cell efficiency, packing factor, water mass to collector area ratio, and wind velocity are found favorable to go for an unglazed system, whereas the increase of on-site solar radiation and ambient temperature are favorable for a glazed system.

[1]  U. Dehesa-Carrasco,et al.  Photovoltaic solar panel for a hybrid PV/thermal system , 2004 .

[2]  R. Petela.  Exergy of undiluted thermal radiation , 2003 .

[3]  Gilles Fraisse,et al.  Energy performance of water hybrid PV/T collectors applied to combisystems of Direct Solar Floor type , 2007 .

[4]  Y. Tripanagnostopoulos,et al.  Hybrid photovoltaic/thermal solar systems , 2002 .

[5]  Shintaro Yokoyama,et al.  Field experiments and analyses on a hybrid solar collector , 2003 .

[6]  Arvind Tiwari,et al.  Performance evaluation of solar PV/T system: An experimental validation , 2006 .

[7]  Arvind Tiwari,et al.  Energy and exergy efficiencies of a hybrid photovoltaic–thermal (PV/T) air collector , 2007 .

[8]  R. Petela.  Exergy of Heat Radiation , 1964 .

[9]  D. C. Spanner,et al.  Introduction to Thermodynamics , 1964 .

[10]  A. Bejan.  Advanced Engineering Thermodynamics , 1988 .

[11]  Tatsuo Tani,et al.  Annual exergy evaluation on photovoltaic-thermal hybrid collector , 1997 .

[12]  Kamaruzzaman Sopian,et al.  Performance analysis of photovoltaic thermal air heaters , 1996 .

[13]  Tin-Tai Chow,et al.  An experimental study of façade-integrated photovoltaic/water-heating system , 2007 .

[14]  M. Bakker,et al.  Performance and costs of a roof-sized PV/thermal array combined with a ground coupled heat pump , 2005 .

[15]  S. Jeter.  Maximum conversion efficiency for the utilization of direct solar radiation , 1981 .

[16]  Jie Ji,et al.  Hybrid photovoltaic-thermosyphon water heating system for residential application , 2006 .

[17]  H. P. Garg,et al.  SOME ASPECTS OF A PV/T COLLECTOR/FORCED CIRCULATION FLAT PLATE SOLAR WATER HEATER WITH SOLAR CELLS , 1995 .

[18]  Arif Hepbasli,et al.  A key review on exergetic analysis and assessment of renewable energy resources for a sustainable future , 2008 .

[19]  E. C. Kern,et al.  Combined photovoltaic and thermal hybrid collector systems , 1978 .

[20]  M. Wolf,et al.  Performance analyses of combined heating and photovoltaic power systems for residences , 1976 .

[21]  Keith Lovegrove,et al.  Development of an approach to compare the ‘value’ of electrical and thermal output from a domestic PV/thermal system , 2003 .