The energy absorbed during the axial collapse of a variety of structures made in steel, aluminum alloy, and glass fiber reinforced plastic (GFRP) was examined with respect to changes produced by foam filling reinforcement. A simple model was devised which permits reasonable estimates of the axial collapse load for a structure and an assessment of the weight-effectiveness of foam filling for that structure. Design charts are given, from which the dimensions can be derived for sections made in either steel or aluminum alloys of any particular strength level, in order to establish foam weight-effectiveness. Foam filling is primarily of value only in sections made from high density, low strength materials, e.g. mild steel. It becomes weight-effective in sections having a thickness-to-section size ratio of less than about .02. In the case of brittle materials (e.g. GFRP), foam filling promotes the crush stability of the structure. Such stability improvements may be the major need for foam filling in these sections and also in large, thin-wall metal sections.
[1]
H E Postlethwaite,et al.
Use of collapsible structural elements as impact isolators, with special references to automotive applications
,
1970
.
[2]
P. H. Thornton.
Energy Absorption by the Structural Collapse of Spot-Welded Sheet Metal Sections
,
1980
.
[3]
S. J. Green,et al.
High-velocity deformation properties of polyurethane foams
,
1969
.
[4]
J. Melvin,et al.
Compression of Cellular Plastics at High Strain Rates
,
1971
.
[5]
P. H. Thornton.
The collapse of square section tubes in bending
,
1979
.
[6]
P. H. Thornton,et al.
Energy Absorption in Composite Structures
,
1979
.
[7]
P. H. Thornton.
Energy absorption by structural collapse in dual phase steel tubes
,
1979
.
[8]
C. L. Magee,et al.
The Interplay of Geometric and Materials Variables in Energy Absorption
,
1977
.
[9]
W. Johnson,et al.
Impact Behaviour of Small Scale Model Motor Coaches
,
1972
.