Lamb wave based ultrasonic imaging of interface delamination in a composite T-joint

Abstract In this article, the complete characterization of the interface delamination in a composite T-joint using ultrasonic guided Lamb waves is discussed. Correlation between the numerically simulated and experimentally obtained B-scans was established. In the B-scan images, different Zones were identified and could be utilized for differentiating the healthy and delaminated T-joints. The length and the width of delamination were computed from traversing the transducers in two orthogonal directions (i.e. called the B-scans, and the D-scans). For the first time, backward propagating mode (called “Turning Lamb Modes”) that are generated at corner of the T-joint was observed and verfied. Using a single linear line scan of the “Turning Lamb Modes”, both the width and length of interface delamination could be computed. In the present study, the experiments were carried out employing air-coupled ultrasonic transducers.

[1]  Krishnan Balasubramaniam,et al.  Structural health monitoring of composite structures using Lamb wave tomography , 2004 .

[2]  J. Rose.  Ultrasonic Waves in Solid Media , 1999 .

[3]  Li Cheng,et al.  Predicting delamination of composite laminates using an imaging approach , 2009 .

[4]  Chun-Gon Kim,et al.  The propagation of Lamb waves in a laminated composite plate with a variable stepped thickness , 2006 .

[5]  Michel Castaings,et al.  The use of electrostatic, ultrasonic, air-coupled transducers to generate and receive Lamb waves in anisotropic, viscoelastic plates , 1998 .

[6]  Keith Worden,et al.  Signal Processing for Damage Detection , 2009 .

[7]  Krishnan Balasubramaniam,et al.  Structural health monitoring of anisotropic plates using ultrasonic guided wave STMR array patches , 2009 .

[8]  K. Balasubramaniam,et al.  Interaction of the primary anti-symmetric Lamb mode (Ao) with symmetric delaminations: numerical and experimental studies , 2009 .

[9]  Wing Kong Chiu,et al.  Structural health monitoring of composite structures using stress wave methods , 2005 .

[10]  B. S. Wong,et al.  Experimental evaluation of delaminations in composite plates by the use of Lamb waves , 1995 .

[11]  S. I. Rokhlin,et al.  Coupling of Lamb waves with the aperture between two elastic sheets , 1983 .

[12]  Krishnan Balasubramaniam,et al.  Interaction of guided Lamb waves with an asymmetrically located delamination in a laminated composite plate , 2010 .

[13]  Constantinos Soutis,et al.  Non-destructive inspection of sandwich and repaired composite laminated structures , 2005 .

[14]  M. Hinders,et al.  Ultrasonic Lamb wave diffraction tomography. , 2001, Ultrasonics.

[15]  Krishnan Balasubramaniam,et al.  Delamination Size Detection using Time of Flight of Anti-symmetric (Ao) and Mode Converted Ao mode of Guided Lamb Waves , 2010 .

[16]  D. Hutchins,et al.  Air-coupled piezoelectric detection of laser-generated ultrasound , 1994 .

[17]  M. Schwartz.  Encyclopedia of smart materials , 2002 .

[18]  R Kazys,et al.  3D analysis of interaction of Lamb waves with defects in loaded steel plates. , 2006, Ultrasonics.

[19]  T. Kundu,et al.  C-scan and L-scan generated images of the concrete/GFRP composite interface , 1999 .

[20]  Peter Cawley,et al.  Single Sided Inspection of Composite Materials Using Air Coupled Ultrasound , 1998 .

[21]  Zhongqing Su,et al.  A built-in active sensor network for health monitoring of composite structures , 2006 .

[22]  Lin Ye,et al.  Some aspects of numerical simulation for Lamb wave propagation in composite laminates , 2006 .

[23]  K. Craig,et al.  Damage detection in composite structures using piezoelectric materials (and neural net) , 1994 .

[24]  Sabu John,et al.  Damage detection in T-joint composite structures , 2006 .

[25]  D. Hutchins,et al.  Lamb wave tomography of advanced composite laminates containing damage , 1994 .

[26]  G. Feltrin,et al.  Delamination detection in an I-section glass fiber reinforced plastic beam with an optical fiber-based stress wave method , 2009 .

[27]  L. Ye,et al.  Quantitative assessment of through-thickness crack size based on Lamb wave scattering in aluminium plates , 2008 .

[28]  J. Takatsubo,et al.  Lamb wave method for quick inspection of impact-induced delamination in composite laminates , 2004 .

[29]  D. Marshall,et al.  Review of progress in quantitative non-destructive evaluation: edited by D. O. Thompson and D. E. Chimenti; published by Plenum, New York, 1983; 1853 pp.; price, U.S. $225.00 , 1985 .

[30]  D. Thompson,et al.  Review of Progress in Quantitative Nondestructive Evaluation , 1982 .

[31]  Jan Drewes Achenbach,et al.  Group delay measurements using modally selective Lamb wave transducers for detection and sizing of delaminations in composites , 2008 .