Applicability of Angular Orientations of Gating Designs to Quality of Sand Casting Components Using Two-Cavity Mould Set-Up

[1]  H. Al‐Lohedan,et al.  Experimental and simulation analysis on multi-gate variants in sand casting process , 2021, Journal of Manufacturing Processes.

[2]  C. Hong,et al.  Computer Modelling of Heat and Fluid Flow in Materials Processing , 2019 .

[3]  Han Wang,et al.  Numerical simulation and experimental investigation of a thin-wall magnesium alloy casting based on a rapid prototyping core making method , 2018 .

[4]  Xu Shen,et al.  A shrinkage cavity prediction model for gravity castings based on pressure distribution: A casting steel case , 2017 .

[5]  Guang Yang,et al.  Numerical modeling and experiment of counter-gravity casting for titanium alloys , 2016 .

[6]  K. H. Renukananda,et al.  Multi-Gate Systems in Casting Process: Comparative Study of Liquid Metal and Water Flow , 2016 .

[7]  Joseph C. Chen,et al.  Taguchi-Based Six Sigma Defect Reduction of Green Sand Casting Process: An Industrial Case Study , 2014 .

[8]  Jiqiang Li,et al.  Method for improvement of die-casting die: combination use of CAE and biomimetic laser process , 2013 .

[9]  W. Hwang,et al.  Design of die casting process of top cover of automobile generator through numerical simulations and its experimental validation , 2011 .

[10]  Ana Reis,et al.  Modeling of shrinkage defects during solidification of long and short freezing materials , 2008 .

[11]  Dianzhong Li,et al.  Centrifugal casting of TiAl exhaust valves , 2008 .

[12]  S. Ferhathullah Hussainy,et al.  Influence of process parameters on quality of Al7SiMg alloy casting using statistical techniques , 2016 .