Investigation of IMC thickness effect on the lead-free solder ball attachment strength: comparison between ball shear test and cold bump pull test results

Ball pull test has emerged to be an attractive alternative to the traditional ball shear method for characterizing the attachment strength of solder interconnection. Since it is a relatively new development, so far there is not industrial standard to regulate this testing method. This paper discusses the effect of IMC growth after soldering and thermal aging at 150 degC. The attachment strength of solder balls with thermal aging is investigated by ball shear and cold bump pull (CBP) tests. The test configuration and the experimental data are reported in detail. The test results indicate that the CBP test method can reveal the brittle failure of solder joints with a higher sensitivity, especially under the fast pulling speed. As a result, the effect of IMC growth can be identified more easily. In addition to the correlation between the IMC thickness and the solder ball attachment strength, the micro-structure of IMC and the failure modes were discussed as well

[1]  S. Lee,et al.  Effects of Testing Conditions and Multiple Reflows on Cold Bump Pull Test of Pb-free Solder Balls , 2005, 2005 6th International Conference on Electronic Packaging Technology.

[2]  F. Che,et al.  Intermetallic Growth and Failure Study for Sn-Ag-Cu/ENIG PBGA Solder Joints Subject to Thermal Cycling , 2005, Proceedings Electronic Components and Technology, 2005. ECTC '05..

[3]  K. Newman,et al.  BGA brittle fracture - alternative solder joint integrity test methods , 2005, Proceedings Electronic Components and Technology, 2005. ECTC '05..

[4]  Tsgereda Alazar,et al.  On Measurement of Effective Silicon Backend Strength Using Bump Pull/Shear Techniques , 2005 .

[5]  G. Raiser,et al.  Solder Joint Reliability Improvement Using the Cold Ball Pull Metrology , 2005 .

[6]  K. Paik,et al.  Interfacial reactions and bump reliability of various Pb-free solder bumps on electroless Ni-P UBMs , 2004, 2004 Proceedings. 54th Electronic Components and Technology Conference (IEEE Cat. No.04CH37546).

[7]  Y. Chan,et al.  Effect of 0.5 wt % Cu addition in Sn–3.5%Ag solder on the dissolution rate of Cu metallization , 2003 .

[8]  John H. Lau,et al.  Electronics Manufacturing: with Lead-Free, Halogen-Free, and Conductive-Adhesive Materials , 2002 .

[9]  K. Paik,et al.  Investigation of flip chip under bump metallization systems of Cu pads , 2002 .

[10]  K. Lee,et al.  Microstructure, joint strength and failure mechanisms of SnPb and Pb-free solders in BGA packages , 2002 .

[11]  Xingjia Huang,et al.  Characterization and analysis on the solder ball shear testing conditions , 2001, 2001 Proceedings. 51st Electronic Components and Technology Conference (Cat. No.01CH37220).

[12]  Rao Tummala,et al.  Fundamentals of Microsystems Packaging , 2001 .