Heat transfer enhancement in a hybrid microchannel-photovoltaic cell using Boehmite nanofluid ☆

Abstract Experiments were conducted to investigate the cooling performance of water-based Boehmite (AlOOH · xH2O) nanofluid in a hybrid photovoltaic (PV) cell. A Perspex plate consists of 40 parallel rectangular microchannels with a hydraulic diameter of 783 μm, a length of 24 cm, a width of 1.8 mm and a depth of 500 μm attached to the back of the cell. Cooling performances of water, as the base fluid, and three different concentrations of nanofluid (0.01, 0.1 and 0.3 wt.%) were compared. The nanofluid thermal performance has been assessed from the obtained results for outlet flow temperature and the average PV surface temperature. The average PV surface temperature decreased from 62.29 °C to 32.5 °C at zero and 300 ml/min of flow rate for 0.01 wt.% nanofluid, respectively. Moreover, the highest improving in the electrical efficiency was achieved about 27% for 0.01 wt.% concentration of the nanofluid at this flow rate.

[1]  Peiwen Li,et al.  CFD study of liquid-cooled heat sinks with microchannel flow field configurations for electronics, fuel cells, and concentrated solar cells , 2011 .

[2]  Robert A. Taylor,et al.  Nanofluid-based direct absorption solar collector , 2010 .

[3]  S. Phillpot,et al.  Mechanisms of heat flow in suspensions of nano-sized particles (nanofluids) , 2002 .

[4]  J. I. Rosell,et al.  Effect of a hybrid jet impingement/micro-channel cooling device on the performance of densely packed PV cells under high concentration , 2011 .

[5]  Mahmood Yaghoubi,et al.  Influence of channel geometry on the performance of a counter flow microchannel heat exchanger , 2009 .

[6]  Kamaruzzaman Sopian,et al.  Performance analysis of a double-pass photovoltaic/thermal (PV/T) solar collector with CPC and fins , 2005 .

[7]  Suresh V. Garimella,et al.  Flow regime-based modeling of heat transfer and pressure drop in microchannel flow boiling , 2012 .

[8]  Adel A. Hegazy,et al.  Comparative study of the performances of four photovoltaic/thermal solar air collectors. , 2000 .

[9]  K. A. Moharram,et al.  Enhancing the performance of photovoltaic panels by water cooling , 2013 .

[10]  E. Skoplaki,et al.  ON THE TEMPERATURE DEPENDENCE OF PHOTOVOLTAIC MODULE ELECTRICAL PERFORMANCE: A REVIEW OF EFFICIENCY/ POWER CORRELATIONS , 2009 .

[11]  K. Kelly,et al.  Design and fabrication of a cross flow micro heat exchanger , 2000, Journal of Microelectromechanical Systems.

[12]  Sanjay Agrawal,et al.  Energy and exergy analysis of hybrid micro-channel photovoltaic thermal module , 2011 .

[13]  Piyanut Nitiapiruk,et al.  Performance characteristics of a microchannel heat sink using TiO2/water nanofluid and different thermophysical models☆ , 2013 .

[14]  Sun Ho Jang,et al.  Fabrication and thermal optimization of LED solar cell simulator , 2010 .

[15]  Byung-Il Choi,et al.  General correlation of a natural convective heat sink with plate-fins for high concentrating photovoltaic module cooling , 2012 .

[16]  Li Zhu,et al.  The performance and long-term stability of silicon concentrator solar cells immersed in dielectric liquids , 2013 .

[17]  R. Saidur,et al.  Analysis of entropy generation using nanofluid flow through the circular microchannel and minichannel heat sink , 2013 .

[18]  Huaqing Xie,et al.  Investigation on Heat Transfer Performances of Nanofluids in Solar Collector , 2011 .

[19]  Tin-Tai Chow,et al.  Hybrid photovoltaic and thermal solar-collector designed for natural circulation of water , 2006 .

[20]  Robert A. Taylor,et al.  Applicability of nanofluids in high flux solar collectors , 2011 .

[21]  Sung Jin Kim,et al.  Three-dimensional numerical optimization of a manifold microchannel heat sink , 2003 .

[22]  Mohammad Nurul Alam Hawlader,et al.  An active cooling system for photovoltaic modules , 2012 .

[23]  Norshah Hafeez Shuaib,et al.  Heat transfer in rectangular microchannels heat sink using nanofluids , 2010 .

[24]  H. Mohammed,et al.  Thermal performance of optimized interrupted microchannel heat sink (IMCHS) using nanofluids , 2012 .

[25]  S. Garimella,et al.  Investigation of heat transfer in rectangular microchannels , 2005 .

[26]  H. Mohammed,et al.  Generality of Brownian motion velocity of two phase approach in interrupted microchannel heat sink , 2013 .

[27]  H. Tyagi,et al.  Predicted Efficiency of a Low-Temperature Nanofluid-Based Direct Absorption Solar Collector , 2009 .

[28]  C. Dey,et al.  Cooling of photovoltaic cells under concentrated illumination: a critical review , 2005 .

[29]  J. J. Vadasz,et al.  Heat transfer enhancement in nano-fluids suspensions: Possible mechanisms and explanations , 2005 .

[30]  M. Hasanuzzaman,et al.  Evaluation of the effect of nanofluid-based absorbers on direct solar collector , 2012 .

[31]  Haisheng Chen,et al.  Heat Transfer Intensification Using Nanofluids , 2007 .

[32]  Yuan Wang,et al.  Irradiance characteristics and optimization design of a large-scale solar simulator , 2011 .

[33]  H. Mohammed,et al.  The impact of various nanofluid types on triangular microchannels heat sink cooling performance , 2011 .

[34]  Karl W. Böer,et al.  Cadmium sulfide enhances solar cell efficiency , 2011 .

[35]  E. Radziemska,et al.  Thermally affected parameters of the current–voltage characteristics of silicon photocell , 2002 .

[36]  J. Fish,et al.  Role of Brownian motion hydrodynamics on nanofluid thermal conductivity , 2006 .

[37]  I. Mudawar,et al.  Assessment of the effectiveness of nanofluids for single-phase and two-phase heat transfer in micro-channels , 2007 .

[38]  G. P. Peterson,et al.  Mixing effect on the enhancement of the effective thermal conductivity of nanoparticle suspensions (nanofluids) , 2007 .

[39]  Elias Papanicolaou,et al.  Multi-objective design optimization of a micro heat sink for Concentrating Photovoltaic/Thermal (CPVT) systems using a genetic algorithm , 2013 .

[40]  Ali Koşar,et al.  Hydrodynamic Cavitation and Boiling in Refrigerant (R-123) Flow Inside Microchannels , 2007 .