Bond strength of whitetoppings and bonded overlays constructed with self-compacting high-performance concrete

[1]  Mark D. Semon,et al.  POSTUSE REVIEW: An Introduction to Error Analysis: The Study of Uncertainties in Physical Measurements , 1982 .

[2]  N. G. Shrive,et al.  Factors Affecting Bond Between New and Old Concrete , 1988 .

[3]  E. R. Cohen.  An Introduction to Error Analysis: The Study of Uncertainties in Physical Measurements , 1998 .

[4]  Nemkumar Banthia,et al.  SHEAR STRENGTH OF STEEL FIBER-REINFORCED CONCRETE , 2002 .

[5]  Scott T Smith,et al.  Intermediate crack-induced debonding in RC beams and slabs , 2003 .

[6]  F Perez Jimenez,et al.  EVALUATION OF THE EFFECT OF TACK COATS. LCB SHEAR TEST , 2003 .

[7]  Vincent Sabathier,et al.  Interface Between an Old Concrete and a Bonded Overlay: Debonding Mechanism , 2004 .

[8]  Fernando A. Branco,et al.  CONCRETE-TO-CONCRETE BOND STRENGTH. INFLUENCE OF THE ROUGHNESS OF THE SUBSTRATE SURFACE , 2004 .

[9]  F Perez Jimenez,et al.  Assessing heat-adhesive emulsions for tack coats , 2005 .

[10]  Julio F. Davalos,et al.  Interface evaluations of overlay-concrete bi-layer composites by a direct shear test method , 2005 .

[11]  S. H. Carpenter,et al.  Interface Bonding between Hot-Mix Asphalt and Various Portland Cement Concrete Surfaces , 2008 .

[12]  B. Bissonnette,et al.  Parameters affecting the debonding risk of bonded overlays used on reinforced concrete slab subjected to flexural loading , 2009 .

[13]  S. Cavalaro,et al.  Manual para el proyecto, construcción y gestión de pavimentos bicapa de hormigón , 2010 .

[14]  C. Czaderski,et al.  Front and Side View Image Correlation Measurements on FRP to Concrete Pull-Off Bond Tests , 2010 .

[15]  Javier León,et al.  Estimation of bond strength envelopes for old-to-new concrete interfaces based on a cylinder splitting test , 2011 .

[16]  A. D. Cea,et al.  Bi-layer diaphragm walls: Evolution of concrete-to-concrete bond strength at early ages , 2012 .

[17]  D. Dias‐da‐Costa,et al.  Effect of surface preparation and bonding agent on the concrete-to-concrete interface strength , 2012 .

[18]  Armelle Chabot,et al.  A Four-Point Bending Test for the Bonding Evaluation of Composite Pavement , 2012 .

[19]  Mani Maran Ratnam,et al.  The relationship between substrate roughness parameters and bond strength of ultra high-performance fiber concrete , 2013 .

[20]  Andrea Prota,et al.  Influence of surface roughness on the bond of FRP laminates to concrete , 2013 .

[21]  Armelle Chabot,et al.  Mechanical analysis of a mixed mode debonding test for “composite” pavements , 2013 .

[22]  Mohamed Nurulnizam.  Comparison of methods for evaluating bond strength between concrete substrate and repair materials , 2013 .

[23]  Hisham Jashami,et al.  Thin ECC overlay systems for rehabilitation of rigid concrete pavements , 2013 .

[24]  Nemkumar Banthia,et al.  A study of some factors affecting bond in cementitious fiber reinforced repairs , 2014 .

[25]  Julio F. Davalos,et al.  High Performance Fiber Reinforced Concrete: Development and Evaluation as a Repairing Material , 2014 .

[26]  Devin K. Harris,et al.  Bond Performance between Ultrahigh-Performance Concrete and Normal-Strength Concrete , 2014 .

[27]  R. Zerbino,et al.  Mechanical response of fiber reinforced concrete overlays over asphalt concrete substrate: Experimental results and numerical simulation , 2015 .

[28]  Redzuan Abdullah,et al.  Friction and cohesion coefficients of composite concrete-to-concrete bond , 2015 .

[29]  Jun Young Park,et al.  Analysis of in situ bond strength of bonded concrete overlay , 2016 .

[30]  Abd Elmoaty M. Abd Elmoaty,et al.  Slant shear bond strength between self compacting concrete and old concrete , 2017 .