Power-Combining Transformer Techniques for Fully-Integrated CMOS Power Amplifiers

Fully integrated CMOS power amplifiers (PAs) with parallel power-combining transformer are presented. For the high power CMOS PA design, two types of transformers, series-combining and parallel-combining, are fully analyzed and compared in detail to show the parasitic resistance and the turn ratio as the limiting factor of power combining. Based on the analysis, two kinds of parallel-combining transformers, a two-primary with a 1:2 turn ratio and a three-primary with a 1:2 turn ratio, are incorporated into the design of fully-integrated CMOS PAs in a standard 0.18-mum CMOS process. The PA with a two-primary transformer delivers 31.2 dBm of output power with 41% of power-added efficiency (PAE), and the PA with a three-primary transformer achieves 32 dBm of output power with 30% of PAE at 1.8 GHz with a 3.3-V power supply.

[1]  Songcheol Hong,et al.  CMOS RF power amplifier with reconfigurable transformer , 2006 .

[2]  Ali Hajimiri,et al.  Fully integrated CMOS power amplifier design using the distributed active-transformer architecture , 2002, IEEE J. Solid State Circuits.

[3]  J. Laskar,et al.  A Monolithic Voltage-Boosting Parallel-Primary Transformer Structures for Fully Integrated CMOS Power Amplifier Design , 2007, 2007 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium.

[4]  D. Valderas,et al.  A New Methodology for the On-Wafer Characterization of RF Integrated Transformers , 2007, IEEE Transactions on Microwave Theory and Techniques.

[5]  D. Rutledge,et al.  An optimized design of distributed active transformer , 2005, IEEE Transactions on Microwave Theory and Techniques.

[6]  R. A. Hadaway,et al.  Monolithic transformers for silicon RF IC design , 1998, Proceedings of the 1998 Bipolar/BiCMOS Circuits and Technology Meeting (Cat. No.98CH36198).

[7]  J. Laskar,et al.  A 1.8-GHz 2-Watt Fully Integrated CMOS Push-Pull Parallel-Combined Power Amplifier Design , 2007, 2007 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium.

[8]  Ali Hajimiri,et al.  Distributed active transformer-a new power-combining and impedance-transformation technique , 2002 .

[9]  Changsik Yoo,et al.  A common-gate switched 0.9-W class-E power amplifier with 41% PAE in 0.25-/spl mu/m CMOS , 2001 .

[10]  Gang Liu,et al.  A 5.8 GHz Linear Power Amplifier in a Standard 90nm CMOS Process using a 1V Power Supply , 2007, 2007 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium.

[11]  Ali Hajimiri,et al.  The class-E/F family of ZVS switching amplifiers , 2003 .

[12]  A. Hajimiri.  Fully integrated RF CMOS power amplifiers - a prelude to full radio integration , 2005, 2005 IEEE Radio Frequency integrated Circuits (RFIC) Symposium - Digest of Papers.

[13]  E. Chen,et al.  A 1.9-GHz DECT CMOS power amplifier with fully integrated multilayer LTCC passives , 2001, IEEE Microwave and Wireless Components Letters.

[14]  Changkun Park,et al.  A 1.9-GHz CMOS Power Amplifier Using Three-Port Asymmetric Transmission Line Transformer for a Polar Transmitter , 2007, IEEE Transactions on Microwave Theory and Techniques.

[15]  Paul R. Gray,et al.  A 1.9-GHz, 1-W CMOS class-E power amplifier for wireless communications , 1999 .

[16]  J. Paramesh,et al.  A four-antenna receiver in 90-nm CMOS for beamforming and spatial diversity , 2005, IEEE Journal of Solid-State Circuits.

[17]  J. Laskar,et al.  A High Power CMOS Switch Using Substrate Body Switching in Multistack Structure , 2007, IEEE Microwave and Wireless Components Letters.

[18]  R. Berenguer,et al.  A Fully Integrated 26.5 dBm CMOS Power Amplifier for IEEE 802.11a WLAN Standard with on-chip "power inductors" , 2006, 2006 IEEE MTT-S International Microwave Symposium Digest.