Depth-resolved registration of transesophageal echo to x-ray fluoroscopy using an inverse geometry fluoroscopy system.

PURPOSE Image registration between standard x-ray fluoroscopy and transesophageal echocardiography (TEE) has recently been proposed. Scanning-beam digital x-ray (SBDX) is an inverse geometry fluoroscopy system designed for cardiac procedures. This study presents a method for 3D registration of SBDX and TEE images based on the tomosynthesis and 3D tracking capabilities of SBDX. METHODS The registration algorithm utilizes the stack of tomosynthetic planes produced by the SBDX system to estimate the physical 3D coordinates of salient key-points on the TEE probe. The key-points are used to arrive at an initial estimate of the probe pose, which is then refined using a 2D/3D registration method adapted for inverse geometry fluoroscopy. A phantom study was conducted to evaluate probe pose estimation accuracy relative to the ground truth, as defined by a set of coregistered fiducial markers. This experiment was conducted with varying probe poses and levels of signal difference-to-noise ratio (SDNR). Additional phantom and in vivo studies were performed to evaluate the correspondence of catheter tip positions in TEE and x-ray images following registration of the two modalities. RESULTS Target registration error (TRE) was used to characterize both pose estimation and registration accuracy. In the study of pose estimation accuracy, successful pose estimates (3D TRE < 5.0 mm) were obtained in 97% of cases when the SDNR was 5.9 or higher in seven out of eight poses. Under these conditions, 3D TRE was 2.32 ± 1.88 mm, and 2D (projection) TRE was 1.61 ± 1.36 mm. Probe localization error along the source-detector axis was 0.87 ± 1.31 mm. For the in vivo experiments, mean 3D TRE ranged from 2.6 to 4.6 mm and mean 2D TRE ranged from 1.1 to 1.6 mm. Anatomy extracted from the echo images appeared well aligned when projected onto the SBDX images. CONCLUSIONS Full 6 DOF image registration between SBDX and TEE is feasible and accurate to within 5 mm. Future studies will focus on real-time implementation and application-specific analysis.

[1]  Michael A. Speidel,et al.  Hough Forests for Real-Time, Automatic Device Localization in Fluoroscopic Images: Application to TAVR , 2015, MICCAI.

[2]  Dorin Comaniciu,et al.  Ultrasound and Fluoroscopic Images Fusion by Autonomous Ultrasound Probe Detection , 2012, MICCAI.

[3]  Terry M. Peters,et al.  US–Fluoroscopy Registration for Transcatheter Aortic Valve Implantation , 2012, IEEE Transactions on Biomedical Engineering.

[4]  Michael A Speidel,et al.  Three-dimensional tracking of cardiac catheters using an inverse geometry x-ray fluoroscopy system. , 2010, Medical physics.

[5]  Tobias Funk,et al.  Detector, collimator and real-time reconstructor for a new scanning-beam digital x-ray (SBDX) prototype , 2015, Medical Imaging.

[6]  Michael A Speidel,et al.  Comparison of entrance exposure and signal-to-noise ratio between an SBDX prototype and a wide-beam cardiac angiographic system. , 2006, Medical physics.

[7]  Tobias Funk,et al.  Calibration-free coronary artery measurements for interventional device sizing using inverse geometry x-ray fluoroscopy: in vivo validation , 2014, Journal of medical imaging.

[8]  Thomas Langø,et al.  Accuracy of electromagnetic tracking with a prototype field generator in an interventional OR setting. , 2012, Medical physics.

[9]  Michael A. Speidel,et al.  Efficient feature-based 2D/3D registration of transesophageal echocardiography to x-ray fluoroscopy for cardiac interventions , 2014, Medical Imaging.

[10]  YingLiang Ma,et al.  Registration of 3D trans-esophageal echocardiography to X-ray fluoroscopy using image-based probe tracking , 2012, Medical Image Anal..

[11]  Douglas Stanton,et al.  3D TEE Registration with X-Ray Fluoroscopy for Interventional Cardiac Applications , 2009, FIMH.

[12]  Wolfgang Birkfellner,et al.  Wobbled splatting—a fast perspective volume rendering method for simulation of x-ray images from CT , 2005, Physics in medicine and biology.

[13]  Michael A. Speidel,et al.  Monoplane stereoscopic imaging method for inverse geometry x-ray fluoroscopy , 2013, Medical Imaging.

[14]  Michael A Speidel,et al.  Scanning-beam digital x-ray (SBDX) technology for interventional and diagnostic cardiac angiography. , 2006, Medical physics.

[15]  Dimitre Hristov,et al.  Feasibility of low-dose single-view 3D fiducial tracking concurrent with external beam delivery. , 2012, Medical physics.

[16]  Vijay Parthasarathy,et al.  MRI - 3D ultrasound - X-ray image fusion with electromagnetic tracking for transendocardial therapeutic injections: In-vitro validation and in-vivo feasibility , 2013, Comput. Medical Imaging Graph..

[17]  Alejandro F. Frangi,et al.  Muliscale Vessel Enhancement Filtering , 1998, MICCAI.

[18]  Robert H. Anderson,et al.  Anatomy of the Aortic Valvar Complex and Its Implications for Transcatheter Implantation of the Aortic Valve , 2008, Circulation. Cardiovascular interventions.

[19]  Michael A. Speidel,et al.  Robust 5DOF Transesophageal Echo Probe Tracking at Fluoroscopic Frame Rates , 2015, MICCAI.