Infrared thermography for detection of laminar–turbulent transition in low-speed wind tunnel testing

This work presents the details of a system for experimentally identifying laminar-to-turbulent transition using infrared thermography applied to large, metal models in low-speed wind tunnel tests. Key elements of the transition detection system include infrared cameras with sensitivity in the 7.5- to 14.0-µm spectral range and a thin, insulating coat for the model. The fidelity of the system was validated through experiments on two wind-turbine blade airfoil sections tested at Reynolds numbers between Re = 1.5 × 106 and 3 × 106. Results compare well with measurements from surface pressure distributions and stethoscope observations. However, the infrared-based system provides data over a much broader range of conditions and locations on the model. This paper chronicles the design, implementation and validation of the infrared transition detection system, a subject which has not been widely detailed in the literature to date.

[1]  J. A. Schetz,et al.  BOUNDARY LAYER CODES FOR STUDENTS IN JAVA , 1998 .

[2]  W. Saric,et al.  Crossflow-vortex instability and transition on a 45 deg swept wing , 1989 .

[3]  G. Carlomagno,et al.  Boundary layer diagnostics by means of an infrared scanning radiometer , 1990 .

[4]  Ruxandra Botez,et al.  Transition Point Detection from the Surface Pressure Distribution for Controller Design , 2008 .

[5]  Y. Le Sant,et al.  An overview of infrared thermography techniques used in large wind tunnels , 2002 .

[6]  Giorgio Guglieri,et al.  Experimental analysis of surface flow on a delta wing by infrared thermography , 1995 .

[7]  Walter G Vincenti,et al.  Wall interference in a two-dimensional-flow wind tunnel, with consideration of the effect of compressibility , 1944 .

[8]  John Foss,et al.  Springer Handbook of Experimental Fluid Mechanics , 2007 .

[9]  Robert S. Ehrmann,et al.  Influence of 2D Steps and Distributed Roughness on Transition on a NACA 63(3)-418 , 2014 .

[10]  J. Gregory,et al.  Passive Trip Evaluation Using Infrared Thermography , 2012 .

[11]  Thomas J. Mueller,et al.  Fixed and Flapping Wing Aerodynamics for Micro Air Vehicle Applications , 2001 .

[12]  Analysis of boundary layer separation phenomena by infrared thermography Use of acoustic and/or mechanical devices to avoid or reduce the laminar separation bubble effects , 2009 .

[13]  James G. Coder,et al.  Comparisons of Theoretical Methods for Predicting Airfoil Aerodynamic Characteristics , 2014 .

[14]  David E. West,et al.  Quantitative Boundary-Layer Transition Measurements Using IR Thermography , 2014 .

[15]  Yuzuru Yokokawa.  Transition Measurement on Metallic Aircraft Model in Typical Lowspeed Wind Tunnel , 2005 .

[16]  Eric J. Gaidos.  Remote infrared thermography for boundary layer measurements , 1990 .

[17]  R. Schmitt,et al.  Experimental investigation of three dimensional separation on an ellipsoid-cylinder body at incidence , 1985 .

[18]  Guenter S. Bauer,et al.  Two-dimensional and dynamic (2DD) method of visualization of the flow characteristics in a convection boundary layer using infrared thermography , 2000, Defense, Security, and Sensing.

[19]  W. Saric,et al.  Infrared thermography investigations in transitional supersonic boundary layers , 2007 .

[20]  Aurelien Borgoltz,et al.  Transition Detection for Low Speed Wind Tunnel Testing using Infrared Thermography , 2014 .