E25 stratified torch ignition engine performance, CO2 emission and combustion analysis

Vehicular emissions significantly increase atmospheric air pollution and the greenhouse effect. This fact associated with the fast growth of the global motor vehicle fleet demands technological solutions from the scientific community in order to achieve a decrease in fuel consumption and CO2 emission, especially of fossil fuels to comply with future legislation. To meet this goal, a prototype stratified torch ignition engine was designed from a commercial baseline engine. In this system, the combustion starts in a pre-combustion chamber where the pressure increase pushes the combustion jet flames through a calibrated nozzle to be precisely targeted into the main chamber. These combustion jet flames are endowed with high thermal and kinetic energy being able to promote a stable lean combustion process. The high kinetic and thermal energy of the combustion jet flame results from the load stratification. This is carried out through direct fuel injection in the pre-combustion chamber by means of a prototype gasoline direct injector (GDI) developed for low fuel flow rate. During the compression stroke, lean mixture coming from the main chamber is forced into the pre-combustion chamber and, a few degrees before the spark timing, fuel is injected into the pre-combustion chamber aiming at forming a slightly rich mixture cloud around the spark plug which is suitable for the ignition and kernel development. The performance of the torch ignition engine running with E25 is presented for different mixture stratification levels, engine speed and load. The performance data such as combustion phasing, specific fuel consumption, thermal efficiency and the specific emissions of CO2 are carefully analyzed and discussed in this paper. The results obtained in this work show a significant increase in the torch ignition engine’s performance in comparison with the baseline engine which was used as a workhorse for the prototype engine construction.

[1]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[2]  Havva Balat,et al.  Recent trends in global production and utilization of bio-ethanol fuel , 2009 .

[3]  Jun Li,et al.  Effect of injection and ignition timings on performance and emissions from a spark-ignition engine fueled with methanol , 2010 .

[4]  Elisa Toulson,et al.  Applying alternative fuels in place of hydrogen to the jet ignition process , 2008 .

[5]  Ritchie Daniel,et al.  Gaseous and particulate matter emissions of biofuel blends in dual-injection compared to direct-injection and port injection , 2013 .

[6]  Nam-Ho Kim,et al.  A study on the combustion and emission characteristics of an SI engine under full load conditions with ethanol port injection and gasoline direct injection , 2015 .

[7]  B. Vaglieco,et al.  Use of Renewable Oxygenated Fuels in Order to Reduce Particle Emissions from a GDI High Performance Engine , 2011 .

[8]  Joel D. Kaufman,et al.  The spatial relationship between traffic-generated air pollution and noise in 2 US cities. , 2009, Environmental research.

[9]  Ayhan Demirbas,et al.  Biofuels: Securing the Planet’s Future Energy Needs , 2008 .

[10]  C. Gruenig,et al.  Investigations on Pre-Chamber Spark Plug with Pilot Injection , 2007 .

[11]  H. Sajjad,et al.  Production of palm and Calophyllum inophyllum based biodiesel and investigation of blend performance and exhaust emission in an unmodified diesel engine at high idling conditions , 2013 .

[12]  William P. Attard,et al.  Spark ignition and pre-chamber turbulent jet ignition combustion visualization , 2012 .

[13]  Tadeu Cavalcante Cordeiro de Melo,et al.  Hydrous ethanol–gasoline blends – Combustion and emission investigations on a Flex-Fuel engine , 2012 .

[14]  J. Mcauley.  Global sustainability and key needs in future automotive design. , 2003, Environmental science & technology.

[15]  José Guilherme Coelho Baeta,et al.  Exploring the limits of a down-sized ethanol direct injection spark ignited engine in different configurations in order to replace high-displacement gasoline engines , 2015 .

[16]  William P. Attard,et al.  A Review of Pre-Chamber Initiated Jet Ignition Combustion Systems , 2010 .

[17]  M. A. Wakil,et al.  Experimental investigation of performance and regulated emissions of a diesel engine with Calophyllum inophyllum biodiesel blends accompanied by oxidation inhibitors , 2014 .

[18]  G. Hong,et al.  Investigation to Leveraging Effect of Ethanol Direct Injection (EDI) in a Gasoline Port Injection (GPI) Engine , 2013 .

[19]  J. Seinfeld,et al.  Atmospheric Chemistry and Physics: From Air Pollution to Climate Change , 1997 .

[20]  J. Samet,et al.  Air Pollution and Cardiovascular Disease: A Statement for Healthcare Professionals From the Expert Panel on Population and Prevention Science of the American Heart Association , 2004, Circulation.

[21]  William P. Attard,et al.  A Turbulent Jet Ignition Pre-Chamber Combustion System for Large Fuel Economy Improvements in a Modern Vehicle Powertrain , 2010 .

[22]  Silvana Di Iorio,et al.  Characterization of Ethanol-Gasoline Blends Combustion processes and Particle Emissions in a GDI/PFI Small Engine , 2014 .

[23]  C. Nilsson,et al.  The influence of oxygenated fuels on emissions of aldehydes and ketones from a two-stroke spark ignition engine , 2011 .

[24]  L. Gussak,et al.  The Role of Chemical Activity and Turbulence Intensity in Prechamber-Torch Organization of Combustion of a Stationary Flow of a Fuel-Air Mixture , 1983 .

[25]  Donald C. Siegla,et al.  High Chemical Activity of Incomplete Combustion Products and a Method of Prechamber Torch Ignition for Avalanche Activation of Combustion in Internal Combustion Engines , 1975 .

[26]  Harry C. Watson,et al.  Modeling Alternative Prechamber Fuels in Jet Assisted Ignition of Gasoline and LPG , 2009 .

[27]  Arkadiusz Jamrozik,et al.  Lean combustion by a pre-chamber charge stratification in a stationary spark ignited engine , 2015 .

[28]  Ayhan Demirbas,et al.  Biofuels sources, biofuel policy, biofuel economy and global biofuel projections , 2008 .

[29]  Wen Tong Chong,et al.  Experimental study on performance and exhaust emissions of a diesel engine fuelled with Ceiba pentandra biodiesel blends , 2013 .

[30]  Chang-Gi Kim,et al.  Performance and exhaust emission characteristics of a spark ignition engine using ethanol and ethanol-reformed gas , 2010 .

[31]  I. M. Rizwanul Fattah,et al.  Production and comparison of fuel properties, engine performance, and emission characteristics of biodiesel from various non-edible vegetable oils: A review , 2014 .

[32]  G. Cha,et al.  Influence of oxygenate content on particulate matter emission in gasoline direct injection engine , 2013 .

[33]  M. Demirbas,et al.  Biowastes-to-biofuels , 2011 .

[34]  Shizuo Yagi,et al.  Research and Development of the Honda CVCC Engine , 1974 .

[35]  Michael Bassett,et al.  A New Combustion System Achieving High Drive Cycle Fuel Economy Improvements in a Modern Vehicle Powertrain , 2011 .

[36]  N. Qureshi,et al.  An economic evaluation of biological conversion of wheat straw to butanol: A biofuel , 2013 .

[37]  Aleš Hribernik,et al.  Numerical and experimental study of combustion, performance and emission characteristics of a heavy-duty DI diesel engine running on diesel, biodiesel and their blends. , 2014 .

[38]  Yakup Sekmen,et al.  The effects of ethanol―unleaded gasoline blends on engine performance and exhaust emissions in a spark-ignition engine , 2009 .

[39]  J. Cape,et al.  Responses of herbaceous plants to urban air pollution: effects on growth, phenology and leaf surface characteristics. , 2009, Environmental pollution.

[40]  William P. Attard,et al.  Flame Kernel Development for a Spark Initiated Pre-Chamber Combustion System Capable of High Load, High Efficiency and Near Zero NOx Emissions , 2010 .

[41]  C. D. Rakopoulos,et al.  Combustion heat release analysis of ethanol or n-butanol diesel fuel blends in heavy-duty DI diesel engine , 2011 .