Formation of a Nanorod-Assembled TiO2 Actinomorphic-Flower-like Microsphere Film via Ta Doping Using a Facile Solution Immersion Method for Humidity Sensing

This study fabricated tantalum (Ta)-doped titanium dioxide with a unique nanorod-assembled actinomorphic-flower-like microsphere structured film. The Ta-doped TiO2 actinomorphic-flower-like microsphere (TAFM) was fabricated via the solution immersion method in a Schott bottle with a home-made improvised clamp. The samples were characterised using FESEM, HRTEM, XRD, Raman, XPS, and Hall effect measurements for their structural and electrical properties. Compared to the undoped sample, the rutile-phased TAFM sample had finer nanorods with an average 42 nm diameter assembled to form microsphere-like structures. It also had higher oxygen vacancy sites, electron concentration, and mobility. In addition, a reversed double-beam photoacoustic spectroscopy measurement was performed for TAFM, revealing that the sample had a high electron trap density of up to 2.5 μmolg−1. The TAFM showed promising results when employed as the resistive-type sensing film for a humidity sensor, with the highest sensor response of 53,909% obtained at 3 at.% Ta doping. Adding rGO to 3 at.% TAFM further improved the sensor response to 232,152%.

[1]  M. H. Abdullah,et al.  Optimization of Aluminum Dopant Amalgamation Immersion Time on Structural, Electrical, and Humidity-Sensing Attributes of Pristine ZnO for Flexible Humidity Sensor Application , 2022, Chemosensors.

[2]  A. Achour,et al.  X-ray Photoelectron Spectroscopy (XPS) Analysis of Ultrafine Au Nanoparticles Supported over Reactively Sputtered TiO2 Films , 2022, Nanomaterials.

[3]  A. S. Ismail,et al.  Heterojunction of SnO2 nanosheet/arrayed ZnO nanorods for humidity sensing , 2022, Materials Chemistry and Physics.

[4]  M. H. Mamat,et al.  Evaluating Different TiO2 Nanoflower-Based Composites for Humidity Detection , 2022, Sensors.

[5]  M. H. Abdullah,et al.  Effects of Varying the Amount of Reduced Graphene Oxide Loading on the Humidity Sensing Performance of Zinc Oxide/Reduced Graphene Oxide Nanocomposites on Cellulose Filter Paper , 2022, SSRN Electronic Journal.

[6]  A. Ismail,et al.  Mesoporous TiO2 enhanced by anchoring Mn3O4 for highly efficient photocatalyst toward photo-oxidation of ciprofloxacin , 2022, Optical Materials.

[7]  Yong Zhang,et al.  High-sensitive humidity sensor based on MoS2/graphene oxide quantum dot nanocomposite , 2022, Materials Chemistry and Physics.

[8]  T. A. Hameed,et al.  Optimization, structural, optical and magnetic properties of TiO2/CoFe2O4 nanocomposites , 2022, Ceramics International.

[9]  G. Granozzi,et al.  Suppressed charge carrier trap states and double photon absorption in substitutional Ta-doped TiO2-NT array , 2022, Nano Today.

[10]  J. Xiong,et al.  Humidity Sensor Based on rGO-SDS Composite Film , 2022, Micromachines.

[11]  Ningdong Feng,et al.  Aluminum-Doped TiO2 with Dominant {001} Facets: Microstructure and Property Evolution and Photocatalytic Activity , 2022, The Journal of Physical Chemistry C.

[12]  H. Bi,et al.  High‐performance flexible humidity sensors for breath detection and non‐touch switches , 2022, Nano Select.

[13]  Tingkai Zhao,et al.  Enhanced electromagnetic wave absorption properties integrating diverse loss mechanism of 3D porous Ni/NiO microspheres , 2022, Journal of Alloys and Compounds.

[14]  Guojian Yang,et al.  Highly sensitive humidity sensor based on the solid solution Zr0.2Ti0.8O2 nanofibers , 2022, Journal of Alloys and Compounds.

[15]  Hongyan Zhang,et al.  Preparation and Research of a High-Performance ZnO/SnO2 Humidity Sensor , 2021, Sensors.

[16]  Prateek,et al.  Hydrothermal synthesis and Ta doping of TiO2 nanorods: Effect of soaking time and doping on optical and charge transfer properties for enhanced SERS activity , 2021, Materials Chemistry and Physics.

[17]  T. Raguram,et al.  Synthesis and characterisation of Cu - Doped TiO2 nanoparticles for DSSC and photocatalytic applications , 2021, International Journal of Hydrogen Energy.

[18]  Deniz Kadir Takcı.  Synthesis, characterization and dielectric properties of rutile TiO2 nanoflowers , 2021, Journal of Crystal Growth.

[19]  P. Chammingkwan,et al.  Nanostructured magnesium oxide microspheres for efficient carbon dioxide capture , 2021 .

[20]  V. Vignoli,et al.  The Effect of Au Nanoparticle Addition on Humidity Sensing with Ultra-Small TiO2 Nanoparticles , 2021, Chemosensors.

[21]  B. Ohtani,et al.  Combined Spectroscopic Methods of Determination of Density of Electronic States: Comparative Analysis of Diffuse Reflectance Spectroelectrochemistry and Reversed Double-Beam Photoacoustic Spectroscopy , 2021, The journal of physical chemistry letters.

[22]  Ruirui Liu,et al.  Fabrication of {001}-facet enriched anatase TiO2/TiOF2 heterostructures with controllable morphology for enhanced photocatalytic activity , 2021 .

[23]  M. Othman,et al.  Effects of TiO2 phase and nanostructures as photoanode on the performance of dye-sensitized solar cells , 2021, Bulletin of Materials Science.

[24]  Yanhuai Ding,et al.  TiO2 nanobelts with ultra-thin mixed C/SiO coating as high-performance photo/photoelectrochemical hydrogen evolution materials , 2021 .

[25]  Haitao Zhao,et al.  Modulating Oxygen Vacancies of TiO2 Nanospheres by Mn-Doping to Boost Electrocatalytic N2 Reduction , 2021 .

[26]  M. M. Rehman,et al.  High-Performance Humidity Sensor Based on the Graphene Flower/Zinc Oxide Composite , 2021, Nanomaterials.

[27]  Xingzhong Yuan,et al.  Photocatalytic removal of antibiotics by MOF-derived Ti3+- and oxygen vacancy-doped anatase/rutile TiO2 distributed in a carbon matrix , 2021, Chemical Engineering Journal.

[28]  A. Mohamed,et al.  Dependence of photocatalysis on electron trapping in Ag-doped flowerlike rutile-phase TiO2 film by facile hydrothermal method , 2020 .

[29]  Hui Tong,et al.  Down-conversion Ce-doped TiO2 nanorod arrays and commercial available carbon based perovskite solar cells: Improved performance and UV photostability , 2020 .

[30]  M. H. Mamat,et al.  The utilization of waste cooking palm oil as a green carbon source for the growth of multilayer graphene , 2020, Journal of the Australian Ceramic Society.

[31]  Chengji Zhao,et al.  High sensitive and fast response humidity sensor based on polymer composite nanofibers for breath monitoring and non-contact sensing , 2020 .

[32]  Wei Hu,et al.  Ultrasensitive and reversible room-temperature resistive humidity sensor based on layered two-dimensional titanium carbide , 2020 .

[33]  V. Vignoli,et al.  RH Sensing by Means of TiO2 Nanoparticles: A Comparison among Different Sensing Techniques Based on Modeling and Chemical/Physical Interpretation , 2020 .

[34]  Nugraha,et al.  Hollow Zinc Oxide Microsphere–Multiwalled Carbon Nanotube Composites for Selective Detection of Sulfur Dioxide , 2020 .

[35]  Yadong Jiang,et al.  Halloysite nanotubes: Natural, environmental-friendly and low-cost nanomaterials for high-performance humidity sensor , 2020 .

[36]  K. V. Rao,et al.  Investigation of uni-directional nanorods composed microspheres and branched TiO2 nanorods towards solar cell application , 2020 .

[37]  A. Mohamed,et al.  Fabrication, structural, optical, electrical, and humidity sensing characteristics of hierarchical NiO nanosheet/nanoball-flower-like structure films , 2020, Journal of Materials Science: Materials in Electronics.

[38]  K. Gao,et al.  SnO2 core-shell hollow microspheres co-modification with Au and NiO nanoparticles for acetone gas sensing , 2020 .

[39]  S. Walia,et al.  Humidity sensing and breath analyzing applications of TiO2 slanted nanorod arrays , 2020 .

[40]  A. S. Ismail,et al.  Coupling heterostructure of thickness-controlled nickel oxide nanosheets layer and titanium dioxide nanorod arrays via immersion route for self-powered solid-state ultraviolet photosensor applications , 2020 .

[41]  B. Meng,et al.  High Performance Humidity Sensor Based on Urchin-like Composite of Ti3C2 MXene-derived TiO2 Nanowires. , 2019, ACS applied materials & interfaces.

[42]  K. McKenna,et al.  Screening Doping Strategies To Mitigate Electron Trapping at Anatase TiO2 Surfaces , 2019, The journal of physical chemistry. C, Nanomaterials and interfaces.

[43]  Haoyu Fu,et al.  Fabrication of Sb2S3 sensitized TiO2 nanorod array solar cells using spin-coating assisted successive ionic layer absorption and reaction , 2019, Materials Today Communications.

[44]  A. S. Ismail,et al.  Structural modification of ZnO nanorod array through Fe-doping: Ramification on UV and humidity sensing properties , 2019, Nano-Structures & Nano-Objects.

[45]  Dongjin Lee,et al.  Highly stable and sensitive resistive flexible humidity sensors by means of roll-to-roll printed electrodes and flower-like TiO2 nanostructures , 2019, Ceramics International.

[46]  D. Zhao,et al.  Mesoporous TiO2 Microspheres with Precisely Controlled Crystallites and Architectures , 2018, Chem.

[47]  Xincun Dou,et al.  2D TiO2 nanosheets for ultrasensitive humidity sensing application benefited by abundant surface oxygen vacancy defects , 2018, Sensors and Actuators B: Chemical.

[48]  A. S. Ismail,et al.  Modulation of Sn concentration in ZnO nanorod array: intensification on the conductivity and humidity sensing properties , 2018, Journal of Materials Science: Materials in Electronics.

[49]  B. Wang,et al.  A Novel Silicon Carbide Nanosheet for High‐Performance Humidity Sensor , 2018 .

[50]  Raju Kumar Gupta,et al.  Effect of tantalum doping in a TiO2 compact layer on the performance of planar spiro-OMeTAD free perovskite solar cells , 2018 .

[51]  B. Ohtani,et al.  Reversed double-beam photoacoustic spectroscopy of metal-oxide powders for estimation of their energy-resolved distribution of electron traps and electronic-band structure , 2017 .

[52]  Y. Wang,et al.  Novel quantum dot and nano-sheet TiO 2 (B) composite for enhanced photocatalytic H 2 – Production without Co-Catalyst , 2017 .

[53]  Raju Kumar Gupta,et al.  Dual Functional Ta-Doped Electrospun TiO2 Nanofibers with Enhanced Photocatalysis and SERS Detection for Organic Compounds. , 2017, ACS applied materials & interfaces.

[54]  Wei Zhou,et al.  Electronic structure and optical properties of Ta-doped and (Ta, N)-codoped SrTiO3 from hybrid functional calculations , 2017 .

[55]  P. Mazzolini,et al.  Vibrational–Electrical Properties Relationship in Donor-Doped TiO2 by Raman Spectroscopy , 2016 .

[56]  L. P. Eksperiandova,et al.  Recent trends of ceramic humidity sensors development: A review , 2016 .

[57]  H. Fan,et al.  Colossal permittivity and impedance analysis of niobium and aluminum co-doped TiO2 ceramics , 2016 .

[58]  P. Li,et al.  Fabrication and characterization of an ultrasensitive humidity sensor based on metal oxide/graphene hybrid nanocomposite , 2016 .

[59]  Yun Liu,et al.  Colossal Dielectric Permittivity in (Nb+Al) Codoped Rutile TiO2 Ceramics: Compositional Gradient and Local Structure , 2015 .

[60]  A. Mohamed,et al.  Quasi-aligned carbon nanotubes synthesised from waste engine oil , 2015 .

[61]  Nan Zhang,et al.  Defective TiO2 with oxygen vacancies: synthesis, properties and photocatalytic applications. , 2013, Nanoscale.

[62]  Hongzhi Wang,et al.  Facile synthesis of rutile TiO2 nanorod microspheres for enhancing light-harvesting of dye-sensitized solar cells , 2013 .

[63]  A. Fujishima,et al.  Influence of Nb dopant on the structural and optical properties of nanocrystalline TiO2 thin films , 2012 .

[64]  B. Ohtani,et al.  Photocatalytic Activity of Amorphous−Anatase Mixture of Titanium(IV) Oxide Particles Suspended in Aqueous Solutions , 1997 .