Thermal shock resistance and failure analysis of plasma-sprayed thick 8YSZ-Al2O3 composite coatings

[1]  R. Peng,et al.  Influence of YSZ layer thickness on the durability of gadolinium zirconate/YSZ double-layered thermal barrier coatings produced by suspension plasma spray , 2019, Surface and Coatings Technology.

[2]  Chang-jiu Li,et al.  Prolong the durability of La2Zr2O7/YSZ TBCs by decreasing the cracking driving force in ceramic coatings , 2018, Journal of the European Ceramic Society.

[3]  R. S. Mulik,et al.  Hot corrosion behavior of plasma sprayed 8YSZ-alumina- CNT composite coating in Na2SO4–60% V2O5 molten salt environment , 2018, Ceramics International.

[4]  Chen Jingjie,et al.  Microstructure and mechanical properties of plasma sprayed Al 2 O 3 -YSZ composite coatings , 2018 .

[5]  R. S. Mulik,et al.  Mechanical property evaluation of carbon nanotubes reinforced plasma sprayed YSZ-alumina composite coating , 2018 .

[6]  Guanjun Yang,et al.  Epitaxial Growth and Cracking Mechanisms of Thermally Sprayed Ceramic Splats , 2018, Journal of Thermal Spray Technology.

[7]  Longhui Deng,et al.  Effect of spraying power on microstructure and property of nanostructured YSZ thermal barrier coatings , 2018 .

[8]  R. S. Mulik,et al.  Effect of carbon nanotubes and aluminum oxide on the properties of a plasma sprayed thermal barrier coating , 2018 .

[9]  Ling Zhu,et al.  Fabrication and property of novel double-layer coating deposited on polyimide matrix composites by atmospheric plasma spraying , 2017 .

[10]  Chang-jiu Li,et al.  Gradient thermal cyclic behaviour of La2Zr2O7/YSZ DCL-TBCs with equivalent thermal insulation performance , 2017 .

[11]  S. Sharma,et al.  Thermophysical Behavior of Thermal Sprayed Yttria Stabilized Zirconia Based Composite Coatings , 2017 .

[12]  Guanjun Yang,et al.  Strain-induced stiffness-dependent structural changes and the associated failure mechanism in TBCs , 2017 .

[13]  T. Yuan,et al.  Failure analysis of fine-lamellar structured YSZ based thermal barrier coatings with submicro/nano-grains , 2017 .

[14]  Shuangjian Li,et al.  Comparative study on wear behavior of plasma sprayed Al2O3 coatings sliding against different counterparts , 2017 .

[15]  Xiaohong Shi,et al.  Effect of spraying power on oxidation resistance and mechanical properties of plasma sprayed La-Mo-Si coating , 2017 .

[16]  Qingmin Yu,et al.  Residual stress distribution along interfaces in thermal barrier coating system under thermal cycles , 2017 .

[17]  S. Björklund,et al.  Failure analysis of Gd2Zr2O7/YSZ multi-layered thermal barrier coatings subjected to thermal cyclic fatigue , 2016 .

[18]  Jun Li,et al.  Microstructural evolution of plasma sprayed submicron-/nano-zirconia-based thermal barrier coatings , 2016 .

[19]  Chizi Liu,et al.  Influence of cracks in APS-TBCs on stress around TGO during thermal cycling: A numerical simulation study , 2016 .

[20]  S. Björklund,et al.  Thermal conductivity and thermal cyclic fatigue of multilayered Gd2Zr2O7/YSZ thermal barrier coatings processed by suspension plasma spray , 2015 .

[21]  Z. Han,et al.  Particle in-flight behavior and its influence on the microstructure and properties of supersonic-atmospheric-plasma-sprayed nanostructured thermal barrier coatings , 2015 .

[22]  R. Eriksson,et al.  A diffusion-based oxide layer growth model using real interface roughness in thermal barrier coatings for lifetime assessment , 2015 .

[23]  Kun Liu,et al.  Particle in-flight behavior and its influence on the microstructure and mechanical property of plasma sprayed La2Ce2O7 thermal barrier coatings , 2015 .

[24]  C. Blasi,et al.  Microstructure and mechanical properties of plasma sprayed alumina-based coatings , 2014 .

[25]  Liping Huang,et al.  Fabrication and Characterization of Amorphous Alumina-Yttria-Stabilized Zirconia Coatings by Air Plasma Spraying , 2014, Journal of Thermal Spray Technology.

[26]  Julian D. Osorio,et al.  Microstructure characterization of thermal barrier coating systems after controlled exposure to a high temperature , 2014 .

[27]  P. Fauchais,et al.  Comparison between metallic and ceramic splats: Influence of viscosity and kinetic energy on the particle flattening , 2013 .

[28]  Xizhi Fan,et al.  Effect of Bond Coats on Thermal Shock Resistance of Thermal Barrier Coatings Deposited Onto Polymer Matrix Composites Via Air Plasma Spray Process , 2013, Journal of Thermal Spray Technology.

[29]  C. Moreau,et al.  Enhancement of amorphous phase formation in alumina–YSZ coatings deposited by suspension plasma spray process , 2013 .

[30]  C. Moreau,et al.  Thermal Cycling of Suspension Plasma Sprayed Alumina- YSZ Coatings Containing Amorphous Phases , 2012 .

[31]  Lei Jin,et al.  Thermal cyclic life and failure mechanism of nanostructured 13 wt%Al2O3 doped YSZ coating prepared by atmospheric plasma spraying , 2012 .

[32]  Huimin Xie,et al.  Cross-Sectional Residual Stresses in Thermal Spray Coatings Measured by Moiré Interferometry and Nanoindentation Technique , 2012, Journal of Thermal Spray Technology.

[33]  C. Moreau,et al.  Amorphous and crystalline phase formation during suspension plasma spraying of the alumina–zirconia composite , 2011 .

[34]  C. Moreau,et al.  High‐Temperature Performance of Alumina–Zirconia Composite Coatings Containing Amorphous Phases , 2011 .

[35]  C. Moreau,et al.  Structural considerations in plasma spraying of the alumina–zirconia composite , 2011 .

[36]  M. Sohi,et al.  Oxidation resistance of YSZ-alumina composites compared to normal YSZ TBC coatings at 1100 °C , 2011 .

[37]  S. Sampath,et al.  Influence of substrate surface conditions on the deposition and spreading of molten droplets , 2011 .

[38]  Je-hyun Lee,et al.  Thermal cycling behavior and interfacial stability in thick thermal barrier coatings , 2010 .

[39]  Y. Zhou,et al.  Effect of Young's modulus evolution on residual stress measurement of thermal barrier coatings by X-ray diffraction , 2010 .

[40]  M. Sohi,et al.  Microstructural stability of zirconia–alumina composite coatings during hot corrosion test at 1050 °C , 2010 .

[41]  C. Zamani,et al.  Phase transformation studies on YSZ doped with alumina. Part 2: Yttria segregation , 2010 .

[42]  A. Cirera,et al.  Phase transformation studies on YSZ doped with alumina. Part 1: Metastable phases , 2010 .

[43]  Qinghe Yu,et al.  Microstructure and Thermal Properties of Nanostructured 4 wt.%Al2O3-YSZ Coatings Produced by Atmospheric Plasma Spraying , 2010 .

[44]  F. Zhao,et al.  Thermal stability of nanostructured 13 wt% Al2O3–8 wt% Y2O3–ZrO2 thermal barrier coatings , 2010 .

[45]  N. Toplan,et al.  Thermal cycle properties of plasma sprayed YSZ/Al2O3 thermal barrier coatings , 2009 .

[46]  J. Guilemany,et al.  Influence of liquid nitrogen quenching on the evolution of metastable phases during plasma spraying of (ZrO2–5 wt.% Y2O3)–20 wt.% Al2O3 coatings , 2009 .

[47]  J. Guilemany,et al.  Microstructure and mechanical properties of near-eutectic ZrO2–60 wt.% Al2O3 produced by quenched plasma spraying , 2009 .

[48]  Limin He,et al.  Failure of the plasma-sprayed coating of lanthanum hexaluminate , 2008 .

[49]  P. Xiao,et al.  Residual stresses in thermal barrier coatings measured by photoluminescence piezospectroscopy and indentation technique , 2006 .

[50]  N. Padture,et al.  Coatings of metastable ceramics deposited by solution-precursor plasma spray: II. Ternary ZrO2–Y2O3–Al2O3 system , 2006 .

[51]  U. Schulz,et al.  The effect of coating thickness on the thermal conductivity of EB-PVD PYSZ thermal barrier coatings , 2006 .

[52]  Fang Wu,et al.  Thick ceramic thermal barrier coatings with high durability deposited using solution-precursor plasma spray , 2005 .

[53]  D. Stöver,et al.  Thermophysical properties and thermal cycling behavior of plasma sprayed thick thermal barrier coatings , 2005 .

[54]  Yung‐Chin Yang,et al.  Measurements of residual stresses in plasma-sprayed hydroxyapatite coatings on titanium alloy , 2005 .

[55]  P. Xiao,et al.  Residual stresses and constrained sintering of YSZ/Al2O3 composite coatings , 2004 .

[56]  Yan-sheng Yin,et al.  Fabrication and properties of Fe3Al–Al2O3 graded coatings , 2003 .

[57]  E. Jordan,et al.  Thermal Barrier Coatings for Gas-Turbine Engine Applications , 2002, Science.

[58]  David Rowcliffe,et al.  The morphology of thermal cracks in brittle materials , 2002 .

[59]  S. Tuurna,et al.  An Improved Deposition Process for Very Thick Porous Thermal Barrier Coatings , 2002, International Thermal Spray Conference.

[60]  Y. Kim,et al.  Amorphous phase formation of the pseudo-binary Al2O3–ZrO2 alloy during plasma spray processing , 1999 .

[61]  P. Alpuim,et al.  Thermal stability of zirconia/alumina thin coatings produced by magnetron sputtering , 1997 .