On the response of flexible risers to loads imposed by hydraulic collars

Abstract Even though hydraulic collars are largely used to install flexible risers, neither the loads imposed by this equipment nor the response of the risers to these loads have been previously studied. Hence, this paper presents a three-dimensional nonlinear finite element (FE) model to predict the response of flexible risers to loads imposed by hydraulic collars and also provides a set of equations to predict these loads. The FE model relies on an analogy between helical tendons and orthotropic shells to simulate the inner carcass and the pressure armour of flexible risers. Shell elements are used to represent the polymeric layers and three-dimensional beam elements simulate the wires of the tensile armours. Material, geometric and contact nonlinearities are addressed. Contact interactions between the layers of the riser are handled by surface to surface contact elements with a contact detection algorithm based on the pinball technique and contact forces evaluated with the augmented Lagrangian method. A 9.5″ flexible riser is analyzed and the numerical results are compared to those from the experimental tests. The agreement between all results indicates that the proposed FE model is an efficient approach to predict the response of flexible risers to loads imposed by hydraulic collars and, moreover, may be used to analyze the response of such structures to other types of loads.

[1]  S. Sævik,et al.  Theoretical and experimental studies of the axisymmetric behaviour of complex umbilical cross-sections , 2005 .

[2]  C. L. Bournazel,et al.  CALCULATION OF STRESSES AND SLIP IN STRUCTURAL LAYERS OF UNBONDED FLEXIBLE PIPES , 1987 .

[3]  T. Hill,et al.  The Future for Flexible Pipe Riser Technology in Deep Water: Case Study , 2006 .

[4]  J. F. Besseling.  A theory of elastic, plastic and creep deformations of an initially isotropic material showing anisotropic strain-hardening, creep recovery, and secondary creep , 1958 .

[5]  Mohammed Raoof,et al.  Analysis of Multilayered Structural Strands , 1988 .

[6]  Mark O. Neal,et al.  Contact‐impact by the pinball algorithm with penalty and Lagrangian methods , 1991 .

[7]  Michael Case,et al.  Higher Order Effects on Bending of Helical Armor Wire Inside an Unbonded Flexible Pipe , 2005 .

[8]  Antoine Felix-Henry,et al.  Validation of a Computer Model for Flexible Pipe Crushing Resistance Calculations , 2008 .

[9]  Wing Kam Liu,et al.  Nonlinear Finite Elements for Continua and Structures , 2000 .

[10]  David J. Benson,et al.  A single surface contact algorithm for the post-buckling analysis of shell structures , 1990 .

[11]  E. Neto,et al.  Flexible Pipe for Ultra-Deepwater Applications: The Roncador Experience , 2001 .

[12]  J. A. Witz,et al.  On the axial-torsional structural behaviour of flexible pipes, umbilicals and marine cables , 1992 .

[13]  Murilo Augusto Vaz,et al.  A nonlinear formulation for the axisymmetric response of umbilical cables and flexible pipes , 2002 .

[14]  P Estrier.  UPDATED METHOD FOR THE DETERMINATION OF THE SERVICE LIFE OF FLEXIBLE RISERS , 1992 .

[15]  S. Timoshenko,et al.  THEORY OF PLATES AND SHELLS , 1959 .