Performance and operational effectiveness of evacuated flat plate solar collectors compared with conventional thermal, PVT and PV panels

Abstract The concept of an evacuated flat plate (EFP) collector was proposed over 40 years ago but, despite its professed advantages, very few manufacturers have developed commercial versions. This situation suggests both technical difficulties in manufacturing a competitively-priced sealed for life panel and a lack of awareness of the benefits of such panels. This paper demonstrates an evacuated flat plate simulation that closely models experimental efficiency measurements. Having established the validity of the model, it compares published data for a commercial EFP collector with predictions for an optimal design to investigate whether any further efficiency improvement might be possible. The optimised design is then evaluated against alternative solar energy devices by modelling a number of possible applications. These comparisons should inform choices about solar options for delivering heat: EFP collectors are well-suited to some of these applications. Evacuated flat plate collectors are a possible alternative to concentrating collectors for Organic Rankine Cycle power generation. The annual output for all the modelled collectors was found to be a quadratic function of delivery temperature: this enabled a novel optimisation of ORC source temperature. Predictions for concentrating and non-concentrating ORC plant are compared with a PV/thermal alternative. The ORC output is significantly less than a PV panel would achieve; applications needing both heat and power are better served by PVT panels. This is an original and novel result.

[1]  Sanjay Agrawal,et al.  Energy and exergy analysis of hybrid micro-channel photovoltaic thermal module , 2011 .

[2]  Gianpiero Colangelo,et al.  Innovation in flat solar thermal collectors: A review of the last ten years experimental results , 2016 .

[3]  Philip C. Eames,et al.  Design and commissioning of a virtual image solar simulator for testing thermal collectors , 2018 .

[4]  C. Benvenuti.  The SRB solar thermal panel , 2013 .

[5]  J. I. Rosell,et al.  Hybrid photovoltaic–thermal solar collectors dynamic modeling , 2013 .

[6]  H. Barshilia,et al.  Review of physical vapor deposited (PVD) spectrally selective coatings for mid- and high-temperature solar thermal applications , 2012 .

[7]  A. Sayigh.  Solar Energy Engineering , 1977 .

[8]  P. Ma,et al.  Optical simulation, corrosion behavior and long term thermal stability of TiC-based spectrally selective solar absorbers , 2017 .

[9]  Xinxing Lin,et al.  Effects of thermal mass and flow rate on forced-circulation solar hot-water system: Comparison of water-in-glass and U-pipe evacuated-tube solar collectors , 2013 .

[10]  V. Jirka,et al.  Glazed PVT Collector with Polysiloxane Encapsulation of PV Cells: Performance and Economic Analysis , 2015 .

[11]  P. Gómez‐Romero,et al.  Electrochemical deposition of black nickel solar absorber coatings on stainless steel AISI316L for thermal solar cells , 2005 .

[12]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[13]  Frank Buttinger,et al.  Development of a new flat stationary evacuated CPC-collector for process heat applications , 2010 .

[14]  Michel Bernier,et al.  SEASONAL STORAGE OF SOLAR ENERGY IN BOREHOLE HEAT EXCHANGERS , 2009 .

[15]  U Frei,et al.  Comparison of three different collectors for process heat applications , 1994, Other Conferences.

[16]  Cheng Zheng,et al.  Design and analysis of a medium-temperature, concentrated solar thermal collector for air-conditioning applications , 2017 .

[17]  Patrick Salagnac,et al.  Experimental study of a micro combined heat and power system with a solar parabolic trough collector coupled to a steam Rankine cycle expander , 2016 .

[18]  N. Ehrmann,et al.  Selectively coated high efficiency glazing for solar-thermal flat-plate collectors , 2012 .

[19]  J. Busby.  UK shallow ground temperatures for ground coupled heat exchangers , 2015 .

[20]  Shay Cohen,et al.  Development of a solar collector with a stationary spherical reflector/tracking absorber for industrial process heat , 2016 .

[21]  Marco Pellegrini,et al.  Photovoltaic/thermal (PV/T) solar system: Experimental measurements, performance analysis and economic assessment , 2017 .

[22]  N. Benz,et al.  HIGH EFFICIENCY EVACUATED FLAT-PLATE SOLAR COLLECTOR FOR PROCESS STEAM PRODUCTION 1 Paper presented , 1999 .

[23]  Jean-Louis Scartezzini,et al.  Novel black selective coating for tubular solar absorbers based on a sol-gel method , 2013 .

[24]  Mawufemo Modjinou,et al.  A numerical and experimental study of micro-channel heat pipe solar photovoltaics thermal system , 2017 .

[25]  Jie Sun,et al.  Test of a solar parabolic trough collector with rotatable axis tracking , 2017 .

[26]  Mervyn Smyth,et al.  The potential applications and advantages of powering solar air-conditioning systems using concentrator augmented solar collectors , 2012 .

[27]  W Zima,et al.  Modelling of liquid flat-plate solar collector operation in transient states , 2011 .

[28]  S. Deng,et al.  A limiting efficiency of subcritical Organic Rankine cycle under the constraint of working fluids , 2018 .

[29]  Antonio Lecuona,et al.  Flat plate thermal solar collector efficiency: Transient behavior under working conditions. Part I: Model description and experimental validation , 2011 .

[30]  P. Eames,et al.  Optimal passage size for solar collector microchannel and tube-on-plate absorbers , 2017 .

[31]  Christos N. Markides,et al.  An Assessment of Solar–Thermal Collector Designs for Small-Scale Combined Heating and Power Applications in the United Kingdom , 2015 .

[32]  Jian Wang,et al.  Medium-temperature Solar Collectors with All-glass Solar Evacuated Tubes , 2015 .

[33]  T. Beikircher,et al.  Advanced solar flat plate collectors with full area absorber, front side film and rear side vacuum super insulation , 2015 .

[34]  J. Scartezzini,et al.  Optical and morphological characterisation of low refractive index materials for coatings on solar collector glazing , 2013 .

[35]  Daniel S. Codd,et al.  Techno-economic analysis of hybrid PV/T systems for process heat using electricity to subsidize the cost of heat , 2017 .

[36]  S. Quoilin,et al.  Performance and design optimization of a low-cost solar organic Rankine cycle for remote power generation , 2011 .

[37]  Josua P. Meyer,et al.  Optimal thermal and thermodynamic performance of a solar parabolic trough receiver with different nanofluids and at different concentration ratios , 2017 .

[38]  P. Eames,et al.  Design and fabrication of a hydroformed absorber for an evacuated flat plate solar collector , 2018, Applied Thermal Engineering.

[39]  Lun Jiang,et al.  Novel double-stage high-concentrated solar hybrid photovoltaic/thermal (PV/T) collector with nonimaging optics and GaAs solar cells reflector , 2016 .

[40]  Enrico Zambolin,et al.  Experimental analysis of thermal performance of flat plate and evacuated tube solar collectors in stationary standard and daily conditions , 2010 .

[41]  Rémi Revellin,et al.  Organic Rankine cycle design and performance comparison based on experimental database , 2017 .

[42]  Alan S. Fung,et al.  Solar community heating and cooling system with borehole thermal energy storage – Review of systems , 2016 .

[43]  J. J. Alvarado-Gil,et al.  Electrodeposition and characterization of nanostructured black nickel selective absorber coatings for solar–thermal energy conversion , 2015, Journal of Materials Science: Materials in Electronics.

[44]  P. Eames,et al.  Simulator testing of evacuated flat plate solar collectors for industrial heat and building integration , 2018 .

[45]  Oliver Kinnane,et al.  Concrete solar collectors for façade integration: An experimental and numerical investigation , 2017 .

[46]  Gianpiero Colangelo,et al.  Experimental test of an innovative high concentration nanofluid solar collector , 2015 .

[47]  G. Mcdonald.  Spectral reflectance properties of black chrome for use as a solar selective coating , 1975 .

[48]  Robert A. Taylor,et al.  A hybrid PV/T collector using spectrally selective absorbing nanofluids , 2017 .

[49]  Jiankai Dong,et al.  An experimental investigation on a small-sized parabolic trough solar collector for water heating in cold areas , 2016 .

[50]  Mahmood Alam,et al.  Energy and economic analysis of Vacuum Insulation Panels (VIPs) used in non-domestic buildings , 2017 .

[51]  Trevor Hyde,et al.  An evacuated enclosure design for solar thermal energy applications , 2014 .

[52]  John Kaiser Calautit,et al.  A review of solar driven absorption cooling with photovoltaic thermal systems , 2017 .

[53]  Christos N. Markides,et al.  Hybrid PV and solar-thermal systems for domestic heat and power provision in the UK: Techno-economic considerations , 2016 .

[54]  Marco Beccali,et al.  Use of finite element models for estimating thermal performance of façade-integrated solar thermal collectors , 2016 .

[55]  Mohd. Kaleem Khan,et al.  Performance enhancement of solar collectors—A review , 2015 .

[56]  Ishan Purohit,et al.  Technical and economic potential of concentrating solar thermal power generation in India , 2017 .

[57]  Jun Zhao,et al.  Experimental investigations on solar chimney for optimal heat collection to be utilized in organic Rankine cycle , 2015 .

[58]  Francesco Melino,et al.  A novel solar concentrator system for combined heat and power application in residential sector , 2017 .