Class AB CMOS amplifiers with high efficiency

A new class AB CMOS operational-amplifier principle is presented. A transconductance amplifier based on this principle exhibits small-signal characteristics comparable to those of a conventional OTA. It has, however, a superior current efficiency and its settling time is not slew-rate limited. The new class AB principle can also be used in an output stage with a well-defined quiescent current, a rail-to-rail output swing, and a good driving capability. A two-stage amplifier with both the input and output stages based on the new principle has been realized. It features a rail-to-rail input and output common-mode range, a gain-bandwidth of 370-kHz, a settling time of less than 5 mu s independent of the applied step, and a power consumption of 247 mu W. It drives a resistive load of 3 k Omega in parallel with a capacitive load of 400 pF when operated on a 2.5-V/-2.5-V power supply. >

[1]  K. E. Brehmer,et al.  Large swing CMOS power amplifier , 1983 .

[2]  R. Klinke,et al.  A Very High Slew-Rate Dynamic CMOS Operational Amplifier , 1988, ESSCIRC '88: Fourteenth European Solid-State Circuits Conference.

[3]  Willy Sansen,et al.  The current efficiency of MOS transconductance amplifiers , 1984 .

[4]  W. Sansen,et al.  Class AB CMOS Operational Amplifiers with Very High Efficiency , 1989, ESSCIRC '89: Proceedings of the 15th European Solid-State Circuits Conference.

[5]  Willy Sansen,et al.  A CMOS large-swing low-distortion three-stage class AB power amplifier , 1990 .

[6]  Bedrich J. Hosticka,et al.  Dynamic CMOS amplifiers , 1980 .

[7]  B. Hosticka,et al.  A very-high-slew-rate CMOS operational amplifier , 1989 .

[8]  H.J. De Man,et al.  Adaptive biasing CMOS amplifiers , 1982, IEEE Journal of Solid-State Circuits.

[9]  P.R. Gray,et al.  A programmable CMOS dual channel interface processor for telecommunications applications , 1984, IEEE Journal of Solid-State Circuits.

[10]  J. N. Babanezhad.  A rail-to-rail CMOS op amp , 1988 .

[11]  M.G.R. Degrauwe,et al.  A rail-to-rail input/output CMOS power amplifier , 1989, 1989 Proceedings of the IEEE Custom Integrated Circuits Conference.

[12]  R. Castello,et al.  A high-performance micropower switched-capacitor filter , 1985, IEEE Journal of Solid-State Circuits.

[13]  D. Monticelli.  A quad CMOS single-supply op amp with rail-to-rail output swing , 1986 .

[14]  C.A.T. Salama,et al.  An efficient CMOS buffer for driving large capacitive loads , 1986 .

[15]  A. de la Plaza,et al.  Power-supply rejection in differential switched-capacitor filters , 1984 .

[16]  J. Fisher,et al.  A Highly Linear CMOS Buffer Amplifier , 1987, ESSCIRC '86: Twelfth European Solid-State Circuits Conference.