论文信息 - Low-Leakage Shaft-End Seals for Utility-Scale Supercritical CO2 Turboexpanders - 字舞流文

Low-Leakage Shaft-End Seals for Utility-Scale Supercritical CO2 Turboexpanders

J. Jeffrey Moore | Grant O. Musgrove | Timothy C. Allison | Edip Sevincer | Azam Mihir Thatte | Rahul Anil Bidkar | J. Moore | T. Allison | Edip Sevincer | R. A. Bidkar | A. Mann | A. Thatte | Jifeng Wang | Jifeng Wang | Andrew Mann | Maxwell Peter | G. Musgrove | Maxwell Peter

[1] Evaluation of a Film Riding Hybrid Seal , 2006 .

[2] Mehmet Demiroglu,et al. Fundamental Design Issues of Brush Seals for Industrial Applications , 2001 .

[3] F. White. Viscous Fluid Flow , 1974 .

[4] Robert Fuller,et al. Turbomachinery for Supercritical CO2 Power Cycles , 2012 .

[5] William A. Michael. A Gas Film Lubrication Study - Part II: Numerical Solution of the Reynolds Equation for Finite Slider Bearings , 1959, IBM J. Res. Dev..

[6] Irebert R. Delgado,et al. High-Speed, High-Temperature Finger Seal Test Results , 2002 .

[7] Eric M. Clementoni,et al. Startup and Operation of a Supercritical Carbon Dioxide Brayton Cycle , 2014 .

[8] Bruce M. Steinetz,et al. Sealing in Turbomachinery , 2006 .

[9] Sean Lyons,et al. Waste Heat to Power (WH2P) Applications Using a Supercritical CO2-Based Power Cycle , 2012 .

[10] O. E. Baljé,et al. Turbomachines—A Guide to Design Selection and Theory , 1981 .

[11] John Munson,et al. Development of film riding face seals for a gas turbine engine , 1992 .

[12] Yann Le Moullec,et al. Conceptual study of a high efficiency coal-fired power plant with CO2 capture using a supercritical CO2 Brayton cycle , 2013 .

[13] Bugra Han Ertas,et al. Compliant Hybrid Journal Bearings Using Integral Wire Mesh Dampers , 2008 .

[14] Mahmut Faruk Aksit,et al. Advanced Seals for Industrial Turbine Applications: Dynamic Seal Development , 2002 .

[15] I. Delgado,et al. Preliminary Test Results of a Non-Contacting Finger Seal on a Herringbone-Grooved Rotor , 2008 .

[16] Luis San Andrés,et al. Measurements of leakage, structural stiffness and energy dissipation parameters in a shoed brush seal , 2005 .

[17] Christopher DellaCorte,et al. Design, Fabrication, and Performance of Open Source Generation I and II Compliant Hydrodynamic Gas Foil Bearings , 2008 .

[18] Irebert R. Delgado,et al. Leakage and Power Loss Test Results for Competing Turbine Engine Seals , 2004 .

[19] A. O. Lebeck,et al. Principles and Design of Mechanical Face Seals , 1991 .