Reduction of Wind Turbine Noise using Optimized Airfoils and Trailing-Edge Serrations

Acoustic field measurements were carried out on a 94-m-diam three-bladed wind turbine with one standard blade, one blade with trailing-edge serrations, and one blade with an optimized airfoil shape. A large horizontal microphone array, positioned at a distance of about one rotor diameter from the turbine, was used to locate and quantify the noise sources in the rotor plane and on the individual blades. The acoustic source maps show that for an observer at the array position, the dominant source for the baseline blade is trailing-edge noise from the blade outboard region. Because of convective amplification and directivity, practically all of this noise is produced during the downward movement of the blade, which causes the typical swishing noise during the passage of the blades. Both modified blades show a significant trailing-edge noise reduction at low frequencies, which is more prominent for the serrated blade. However, the modified blades also show tip noise at high frequencies, which is mainly radiated during the upward part of the revolution and is most important at low wind speeds due to high tip loading. Nevertheless, average overall noise reductions of 0.5 and 3.2 dB are obtained for the optimized blade and the serrated blade, respectively.

[1]  Stewart A. L. Glegg,et al.  The prediction of broadband noise from wind turbines , 1987 .

[2]  A. Debruijn,et al.  Determination of the acoustic source power levels of wind turbines , 1984 .

[3]  Thomas F. Brooks,et al.  Airfoil self-noise and prediction , 1989 .

[4]  Ewald Krämer,et al.  Design and Wind-Tunnel Verification of Low-Noise Airfoils for Wind Turbines , 2006 .

[5]  Harm Smit,et al.  New data acquisition system for microphone array measurements in wind tunnels , 2001 .

[6]  Thorsten Lutz,et al.  Trailing-Edge Noise Measurements Using a Hot-Wire Based Coherent Particle Velocity Method , 2006 .

[7]  Thierry Maeder,et al.  SIROCCO: Silent rotors by acoustic optimisation , 2007 .

[8]  Michaela Herr,et al.  Design Criteria for Low-Noise Trailing-Edges , 2007 .

[9]  F. Fahy,et al.  Mechanics of flow-induced sound and vibration , 1989 .

[10]  Martin Lowson,et al.  Wind turbine noise: analysis of results from a new measurement technique , 1998 .

[11]  M. S. Howe.  A review of the theory of trailing edge noise , 1978 .

[12]  R. Parchen,et al.  Serrated Trailing Edge Noise (STENO) , 1998 .

[13]  Siegfried Wagner,et al.  Prediction and reduction of wind turbine noise - An overview of research activities in Europe , 2000 .

[14]  Pieter Sijtsma,et al.  Location of rotating sources by phased array measurements , 2001 .

[15]  Martin Lowson,et al.  Theory and experiment for wind turbine noise , 1994 .

[16]  Thomas F. Brooks,et al.  Rotor Broadband Noise Prediction with Comparison to Model Data , 2001 .

[17]  Harvey H. Hubbard,et al.  Aeroacoustics of large wind turbines , 1991 .

[18]  Stefan Oerlemans,et al.  Aeroacoustic wind tunnel tests of wind turbine arfoils , 2004 .

[19]  Pieter Sijtsma,et al.  Nationaal Lucht-en Ruimtevaartlaboratorium National Aerospace Laboratory NLR NLR-TP-2007-798 Location and quantification of noise sources on a wind turbine , 2008 .

[20]  R. Amiet.  Acoustic radiation from an airfoil in a turbulent stream , 1975 .

[21]  Michael S. Howe,et al.  Noise produced by a sawtooth trailing edge , 1991 .

[22]  R. H. Schlinker,et al.  Helicopter rotor trailing edge noise , 1981 .

[23]  C. Burrus,et al.  Array Signal Processing , 1989 .

[24]  Gianfranco Guidati,et al.  Comparison of measured and predicted airfoil self-noise with application to wind turbine noise reduction , 1997 .

[25]  Ann P. Dowling,et al.  Sound and Sources of Sound , 1983 .

[26]  Gianfranco Guidati,et al.  Wind Turbine Noise , 1996 .

[27]  S. Oerlemans,et al.  Quantification of Airframe Noise Using Microphone Arrays in Open and Closed wind Tunnels , 2007 .

[28]  Michel Roger,et al.  Competing Broadband Noise Mechanisms in Low-Speed Axial Fans , 2004 .

[29]  Gianfranco Guidati,et al.  Simulation and measurement of inflow-turbulence noise on airfoils , 1997 .

[30]  F. W. Grosveld,et al.  Prediction of broadband noise from large horizontal axis wind turbine generators , 1984 .

[31]  S. Wagner,et al.  Experimental demonstration of wind turbine noise reduction through optimized airfoil shape and trailing-edge serrations , 2001 .

[32]  Michaela Herr,et al.  Experimental investigations in low-noise trailing-edge design , 2004 .

[33]  S. Oerlemans.  Prediction of wind turbine noise and comparison with experiment , 2007 .

[34]  Thomas F. Brooks,et al.  Effects of Angle of Attack and Velocity on Trailing Edge Noise , 2004 .

[35]  Gianfranco Guidati,et al.  Prediction of Turbulent Inflow and Trailing-Edge Noise for Wind Turbines , 2005 .

[36]  R. Parchen,et al.  Results of a wind tunnel study on the reduction of airfoil self-noise by the application of serrated blade trailing edges , 1996 .