Detection of transverse cracks in CFRP composites using embedded fiber Bragg grating sensors

In the present research, fiber Bragg grating (FBG) sensors were applied for the detection of transverse cracks, which cause strain distribution within the gage length, in carbon fiber reinforced plastic (CFRP) cross-ply laminates. An uncoated FBG sensor was embedded in 0° ply on the border of 90° ply in a CFRP cross-ply laminate. The reflection spectra from the FBG sensor were measured at various tensile stresses. As a result, the reflection spectrum became broad and had some peaks with an increase of the transverse crack density in the 90° ply. After the crack density was saturated, the spectrum became narrow and had one large peak again. In order to confirm that the change in the spectrum was caused by transverse cracks, the spectra were calculated theoretically. The calculated result reproduced the change in the measured spectrum very well. These results show that the occurrence of transverse cracks can be detected from the change in the form of the reflection spectrum, and that the spectrum width at the half maximum is a good indicator for the quantitative evaluation of the transverse crack density in real time.

[1]  Rene-Paul Salathe,et al.  Measurement of stress concentrations using embedded optical fiber Bragg grating sensors , 1999, Smart Structures.

[2]  Nobuo Takeda,et al.  Initiation and growth of delamination from the tips of transverse cracks in CFRP cross-ply laminates , 1994 .

[3]  Hwa-Yaw Tam,et al.  Fundamentals and applications of optical fiber Bragg grating sensors to textile structural composites , 1998 .

[4]  David G. Bellemore,et al.  Distributed fiber Bragg grating strain sensing in reinforced concrete structural components , 1997 .

[5]  Wei-Ping Huang Coupled-mode theory for optical waveguides: an overview , 1994 .

[6]  Yun-Jiang Rao,et al.  Recent progress in applications of in-fibre Bragg grating sensors , 1999 .

[7]  José Manuel Menéndez,et al.  Strain measurements inside thick CFRP laminates at the vicinity of bolted joints , 1999, Smart Structures.

[8]  J. Alfredo Guemes,et al.  Measurement of strain distribution in bonded joints by fiber Bragg gratings , 1998, Smart Structures.

[9]  R. Dändliker,et al.  Determination of the individual strain-optic coefficients in single-mode optical fibres , 1988 .

[10]  M. Yamada,et al.  Analysis of almost-periodic distributed feedback slab waveguides via a fundamental matrix approach. , 1987, Applied optics.

[11]  Nobuo Takeda,et al.  In situ observation and probabilistic prediction of microscopic failure processes in CFRP cross-ply laminates , 1994 .

[12]  Nobuo Takeda,et al.  Experimental characterization of microscopic damage progress in quasi-isotropic CFRP laminates: effect of interlaminar-toughened layers , 1998 .

[13]  L. McCartney Theory of stress transfer in a 0°—90°—0° cross-ply laminate containing a parallel array of transverse cracks , 1992 .

[14]  R. Measures,et al.  Fiber-optic Bragg grating sensors for bridge monitoring , 1997 .

[15]  George S. Springer,et al.  Strain and Temperature Measurement with Fiber Optic Sensors , 1996 .

[16]  M Leblanc,et al.  Distributed strain measurement based on a fiber Bragg grating and its reflection spectrum analysis. , 1996, Optics letters.

[17]  Michael A. Davis,et al.  Fiber grating sensors , 1997 .