Simultaneous thermal and optical imaging of two-phase flow in a micro-model.

In the study of non-equilibrium heat transfer in multiphase flow in porous media, parameters and constitutive relations, like heat transfer coefficients between phases, are unknown. In order to study the temperature development of a relatively hot invading immiscible non-wetting fluid and, ultimately, approximate heat transfer coefficients, a transparent micro-model is used as an artificial porous medium. In the last few decades, micro-models have become popular experimental tools for two-phase flow studies. In this work, the design of an innovative, elongated, PDMS (polydimethylsiloxane) micro-model with dimensions of 14.4 × 39 mm(2) and a constant depth of 100 microns is described. A novel setup for simultaneous thermal and optical imaging of flow through the micro-model is presented. This is the first time that a closed flow cell like a micro-model is used in simultaneous thermal and optical flow imaging. The micro-model is visualized by a novel setup that allowed us to monitor and record the distribution of fluids throughout the length of the micro-model continuously and also record the thermal signature of the fluids. Dynamic drainage and imbibition experiments were conducted in order to obtain information about the heat exchange between the phases. In this paper the setup as well as analysis and qualitative results are presented.

[1]  Philipp Nuske,et al.  Non-equilibrium in multiphase multicomponent flow in porous media: An evaporation example , 2014 .

[2]  Alkiviades C. Payatakes,et al.  Steady-state two-phase flow through planar and nonplanar model porous media , 1994 .

[3]  M. Yavuz Corapcioglu,et al.  Pore-Scale Analysis of NAPL Blob Dissolution and Mobilization in Porous Media , 2009 .

[4]  Rainer Helmig,et al.  Numerical simulation of non-isothermal multiphase multicomponent processes in porous media. 2. Applications for the injection of steam and air , 2002 .

[5]  Jay W. Grate,et al.  Influence of Viscous and Capillary Forces on Immiscible Fluid Displacement: Pore-Scale Experimental Study in a Water-Wet Micromodel Demonstrating Viscous and Capillary Fingering , 2011 .

[6]  Rainer Helmig,et al.  Methods for predicting the spreading of steam below the water table during subsurface remediation , 2010 .

[7]  Thomas Gervais,et al.  Flow-induced deformation of shallow microfluidic channels. , 2006, Lab on a chip.

[8]  S. M. Hassanizadeh,et al.  A Review of Micromodels and Their Use in Two‐Phase Flow Studies , 2012 .

[9]  David D. Nolte,et al.  Linking pressure and saturation through interfacial areas in porous media , 2004 .

[10]  Liang-Cheng Chang,et al.  Experimental study on imbibition displacement mechanisms of two-phase fluid using micro model , 2009 .

[11]  S. Ben Nasrallah,et al.  Experimental study of the effects of hydraulic gradient and injected-gas flow rate on fragmentation in porous media , 2007 .

[12]  M. Musterd,et al.  On the fabrication of PDMS micromodels by rapid prototyping, and their use in two‐phase flow studies , 2013 .

[13]  Naga Siva Kumar Gunda,et al.  Reservoir-on-a-chip (ROC): a new paradigm in reservoir engineering. , 2011, Lab on a chip.

[14]  B. Gutiérrez,et al.  Experimental Study of Gas–Liquid Two-Phase Flow in Glass Micromodels , 2008 .

[15]  Jay W. Grate,et al.  A note on the visualization of wetting film structures and a nonwetting immiscible fluid in a pore network micromodel using a solvatochromic dye , 2010 .

[16]  Goodarz Ahmadi,et al.  Crossover from capillary fingering to viscous fingering for immiscible unstable flow:Experiment and modeling. , 2004, Physical review. E, Statistical, nonlinear, and soft matter physics.

[17]  S. Hassanizadeh,et al.  A novel deep reactive ion etched (DRIE) glass micro-model for two-phase flow experiments. , 2012, Lab on a chip.

[18]  Charles J. Werth,et al.  Visualization and Modeling of Polystyrol Colloid Transport in a Silicon Micromodel , 2004 .

[19]  Vahid Joekar-Niasar,et al.  Non-equilibrium effects in capillarity and interfacial area in two-phase flow: dynamic pore-network modelling , 2010, Journal of Fluid Mechanics.

[20]  Michel Quintard,et al.  The impact of thermal non-equilibrium and large-scale 2D/3D effects on debris bed reflooding and coolability , 2006 .