An x-axis micromachined gyroscope with doubly decoupled oscillation modes

In this paper, a doubly decoupled x-axis gyroscope with novel torsional sensing comb capacitors is presented. The doubly decoupled design is more efficient to suppress mechanical coupling of gyroscope. Both driving and sensing modes of the gyroscope are dominated by slide film air damping, then it can work even at atmosphere. Moreover, the sensing capacitors adopt asymmetrical comb fingers so that they can differentially detect out-of-plane torsional movements. The fabrication process of the gyroscope is compatible with z-axis gyroscope process, which makes it potential to realize low cost monolithic MIMU (miniature inertial measurement unit) without vacuum packaging. The gyroscope was fabricated and tested. The sensitivity is 3mV/deg/s while the nonlinearity is 1.1% at atmosphere. The noise floor is 0. 1deg/s/Hz1/2.

[1]  R. Neul,et al.  New surface micromachined angular rate sensor for vehicle stabilizing systems in automotive applications , 2005, The 13th International Conference on Solid-State Sensors, Actuators and Microsystems, 2005. Digest of Technical Papers. TRANSDUCERS '05..

[2]  Yilong Hao,et al.  A bulk micromachined lateral axis gyroscope with vertical sensing comb capacitors , 2005, The 13th International Conference on Solid-State Sensors, Actuators and Microsystems, 2005. Digest of Technical Papers. TRANSDUCERS '05..

[3]  S. E. Alper,et al.  High-Performance SOI-MEMS Gyroscope with Decoupled Oscillation Modes , 2006, 19th IEEE International Conference on Micro Electro Mechanical Systems.

[4]  J. Frech,et al.  Decoupled microgyros and the design principle DAVED , 2001, Technical Digest. MEMS 2001. 14th IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.01CH37090).

[5]  Guizhen Yan,et al.  Design and Fabrication of a lateral axis Gyroscope with Asymmetric Comb-Fingers as Sensing Capacitors , 2006, 2006 1st IEEE International Conference on Nano/Micro Engineered and Molecular Systems.

[6]  Y. Mochida,et al.  A micromachined vibrating rate gyroscope with independent beams for the drive and detection modes , 2000, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[7]  T. Akin,et al.  A single-crystal silicon symmetrical and decoupled MEMS gyroscope on an insulating substrate , 2005, Journal of Microelectromechanical Systems.