Feasibility of using near-field microwave reflectometry for monitoring autogenous crack healing in cementitious materials

Abstract This study demonstrates the feasibility of using the near-field microwave reflectometry technique to nondestructively monitor the evolution of autogenous crack healing of mortar containing high volume of supplementary cementitious materials. Mortar samples were subjected to controlled compressive loading to generate cracks, and subsequently exposed to wetting/drying cycles to initiate the autogenous crack healing process. Test results indicate that cracked mortar samples exhibit higher point-to-point microwave reflection coefficient variations caused by cracking and moisture ingress (i.e., larger coefficient of variation (COV) values of magnitude of reflection coefficient, |Γ|, obtained from microwave reflectometry). When subjected to wetting/drying cycles, samples with higher crack healing capability are found to undergo less variation in microwave reflection coefficient. Based on the results for cracked samples, the COV trends obtained for microwave reflection properties can be divided into three parts as a function of wetting/drying cycles: part (I) corresponding to a significant point-to-point microwave reflection variations resulting from crack formation and moisture ingress after the first wetting/drying cycle; part (II) indicating the onset of the crack healing process identified by the reduction in the COV values; and part (III) representing slow-down of crack healing process for the regions exposed to microwave radiation as indicated by the relatively constant COV values during additional wetting/drying cycles. Such variations in microwave reflection properties can be linked to changes in moisture transport properties and subsequent crack healing process. To corroborate the microwave reflectometry results, concurrent ultrasonic measurements were conducted on the mortar samples during the self-healing process, and a good correlation was observed between the outcomes of these two test methods. The results of material characterization assessments including capillary water absorption, crack healing quantification, as well as X-ray diffraction and scanning electron microscopy of crack healing products were also used to quantify the crack healing evolution for the investigated mortar samples.

[1]  R. Zoughi,et al.  Microwave detection of carbonation in mortar using dielectric property characterization , 2014, 2014 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Proceedings.

[2]  Nele De Belie,et al.  Mechanical and self-healing properties of cementitious composites reinforced with flax and cottonised flax, and compared with polyvinyl alcohol fibres , 2012 .

[3]  Haoliang Huang.  Thermodynamics of Autogenous Self-healing in Cementitious Materials , 2014 .

[4]  Shunzhi Qian,et al.  Self-healing behavior of strain hardening cementitious composites incorporating local waste materials , 2009 .

[5]  Liberato Ferrara,et al.  Autogenous healing on the recovery of mechanical performance of High Performance Fibre Reinforced Cementitious Composites (HPFRCCs): Part 2 – Correlation between healing of mechanical performance and crack sealing , 2016 .

[6]  D. Robinson,et al.  The Dielectric Permittivity of Calcite and Arid Zone Soils with Carbonate Minerals , 2004 .

[7]  Björn Johannesson,et al.  A review : Self-healing in cementitious materials and engineered cementitious composite as a self-healing material , 2012 .

[8]  Waiching Tang,et al.  Robust evaluation of self-healing efficiency in cementitious materials – A review , 2015 .

[9]  Reza Zoughi,et al.  Comparison of Alkali–Silica Reaction Gel Behavior in Mortar at Microwave Frequencies , 2015, IEEE Transactions on Instrumentation and Measurement.

[10]  F. Cohen Tenoudji,et al.  Mechanical properties of cement pastes and mortars at early ages: Evolution with time and degree of hydration , 1996 .

[11]  Nele De Belie,et al.  Acoustic emission analysis for the quantification of autonomous crack healing in concrete , 2012 .

[12]  Carola Edvardsen,et al.  Water Permeability and Autogenous Healing of Cracks in Concrete , 1999 .

[13]  R. Zoughi,et al.  Use of Near-Field Microwave Reflectometry to Evaluate Steel Fiber Distribution in Cement-Based Mortars , 2017 .

[14]  Masanori Iiba,et al.  Experimental study on enhancement of self-restoration of concrete beams using SMA wire , 2003, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[15]  Reza Zoughi,et al.  Preliminary Study of the Influences of Effective Dielectric Constant and Nonuniform Probe Aperture Field Distribution on near Field Microwave Images , 1997 .

[16]  Nele De Belie,et al.  Chloride penetration in cracked mortar and the influence of autogenous crack healing , 2016 .

[17]  S. Friedman.  A saturation degree‐dependent composite spheres model for describing the effective dielectric constant of unsaturated porous media , 1998 .

[18]  Nele De Belie,et al.  Self-Healing in Cementitious Materials—A Review , 2013 .

[19]  Stefan Jacobsen,et al.  Sem observations of the microstructure of frost deteriorated and self-healed concretes , 1995 .

[20]  Reza Zoughi,et al.  Demonstration of microwave method for detection of alkali–silica reaction (ASR) gel in cement-based materials , 2013 .

[21]  A. Fung,et al.  Microwave Remote Sensing Active and Passive-Volume III: From Theory to Applications , 1986 .

[22]  Didier Snoeck,et al.  From straw in bricks to modern use of microfibers in cementitious composites for improved autogenous healing – A review , 2015 .

[23]  Veerle Cnudde,et al.  X-ray computed microtomography to study autogenous healing of cementitious materials promoted by superabsorbent polymers , 2016 .

[24]  Kim Van Tittelboom,et al.  Self-Healing Concrete through Incorporation of Encapsulated Bacteria- or Polymer-Based Healing Agents ('Zelfhelend beton door incorporatie van ingekapselde bacteri , 2012 .

[25]  Tomoya Nishiwaki,et al.  Self-Healing Capability of Fiber Reinforced Cementitious Composites , 2011 .

[26]  Mustafa Şahmaran,et al.  Self-healing of mechanically-loaded self consolidating concretes with high volumes of fly ash , 2008 .

[27]  Ali Foudazi,et al.  Evaluation of steel fiber distribution in cement-based mortars using active microwave thermography , 2016, Materials and Structures.

[28]  Aaron R. Sakulich,et al.  Self-Healing Characterization of Engineered Cementitious Composite Materials , 2010 .

[29]  Michael D. Lepech,et al.  Autogenous healing of engineered cementitious composites under wet–dry cycles , 2009 .

[30]  Mohamed Lachemi,et al.  Assessing the self-healing capability of cementitious composites under increasing sustained loading , 2015 .

[31]  Mohamed Lachemi,et al.  Influence of cracking and healing on the gas permeability of cementitious composites , 2015 .

[32]  Reza Zoughi,et al.  Multimodal Solution for a Waveguide Radiating Into Multilayered Structures—Dielectric Property and Thickness Evaluation , 2009, IEEE Transactions on Instrumentation and Measurement.

[33]  Mohamed Lachemi,et al.  Estimating the self-healing capability of cementitious composites through non-destructive electrical-based monitoring , 2015 .

[34]  Norbert J. Delatte,et al.  Effect of supplementary cementitious materials on the compressive strength and durability of short-term cured concrete , 2004 .

[35]  H. Reinhardt,et al.  Permeability and self-healing of cracked concrete as a function of temperature and crack width , 2003 .

[36]  F. A. Silber,et al.  ULTRASONIC TESTING OF MATERIALS , 1978 .

[37]  Laurence J. Jacobs,et al.  Monitoring and evaluation of self-healing in concrete using diffuse ultrasound , 2013 .

[38]  Xiaohua Zhao,et al.  Properties of concrete incorporating fly ash and ground granulated blast-furnace slag , 2003 .

[39]  Yukio Hama,et al.  Experimental Investigation on Reaction Rate and Self-healing Ability in Fly Ash Blended Cement Mixtures , 2012 .

[40]  W. Verstraete,et al.  Use of bacteria to repair cracks in concrete , 2010 .

[41]  John S. Popovics,et al.  EXTENT OF HEALING OF CRACKED NORMAL STRENGTH CONCRETE. TECHNICAL NOTE , 2000 .

[42]  Joseph L. Rose,et al.  The behaviour of ultrasonic pulses in concrete , 1990 .

[43]  M. Lachemi,et al.  Self-Healing of Cementitious Composites to Reduce High CO2 Emissions , 2017 .

[44]  Reza Zoughi,et al.  Microwave Nondestructive Estimation of Cement Paste Compressive Strength , 1995 .

[45]  R. Ferron,et al.  Evaluation of self-healing of internal cracks in biomimetic mortar using coda wave interferometry , 2016 .

[46]  Eduardus A. B. Koenders,et al.  Effect of exposure conditions on self healing behavior of strain hardening cementitious composites incorporating various cementitious materials , 2013 .

[47]  Zhengwu Jiang,et al.  Influence of mineral additives and environmental conditions on the self-healing capabilities of cementitious materials , 2015 .

[48]  Mustafa Sahmaran,et al.  Influence of Hydrated Lime Addition on the Self-Healing Capability of High-Volume Fly Ash Incorporated Cementitious Composites , 2015 .

[49]  Salvatore Salamone,et al.  Multifractal analysis of crack patterns in reinforced concrete shear walls , 2016 .

[50]  Mustafa Sahmaran,et al.  Self-healing capability of cementitious composites incorporating different supplementary cementitious materials , 2013 .

[51]  Wu Yao,et al.  Influence of damage degree on self-healing of concrete , 2008 .

[52]  Mohamed Lachemi,et al.  Repeatability and Pervasiveness of Self-Healing in Engineered Cementitious Composites , 2015 .

[53]  C A Clear,et al.  THE EFFECTS OF AUTOGENOUS HEALING UPON THE LEAKAGE OF WATER THROUGH CRACKS IN CONCRETE , 1985 .

[54]  Stefan Jacobsen,et al.  Effect of cracking and healing on chloride transport in OPC concrete , 1996 .

[55]  Raktipong Sahamitmongkol,et al.  Self-crack closing ability of mortar with different additives , 2011 .