Co-firing straw with coal in a swirl-stabilized dual-feed burner: modelling and experimental validation.

This paper presents a comprehensive computational fluid dynamics (CFD) modelling study of co-firing wheat straw with coal in a 150kW swirl-stabilized dual-feed burner flow reactor, in which the pulverized straw particles (mean diameter of 451microm) and coal particles (mean diameter of 110.4microm) are independently fed into the burner through two concentric injection tubes, i.e., the centre and annular tubes, respectively. Multiple simulations are performed, using three meshes, two global reaction mechanisms for homogeneous combustion, two turbulent combustion models, and two models for fuel particle conversion. It is found that for pulverized biomass particles of a few hundred microns in diameter the intra-particle heat and mass transfer is a secondary issue at most in their conversion, and the global four-step mechanism of Jones and Lindstedt may be better used in modelling volatiles combustion. The baseline CFD models show a good agreement with the measured maps of main species in the reactor. The straw particles, less affected by the swirling secondary air jet due to the large fuel/air jet momentum and large particle response time, travels in a nearly straight line and penetrate through the oxygen-lean core zone; whilst the coal particles are significantly affected by secondary air jet and swirled into the oxygen-rich outer radius with increased residence time (in average, 8.1s for coal particles vs. 5.2s for straw particles in the 3m high reactor). Therefore, a remarkable difference in the overall burnout of the two fuels is predicted: about 93% for coal char vs. 73% for straw char. As the conclusion, a reliable modelling methodology for pulverized biomass/coal co-firing and some useful co-firing design considerations are suggested.

[1]  Peter Glarborg,et al.  Numerical modeling of straw combustion in a fixed bed , 2005 .

[2]  F. C. Lockwood,et al.  The influence of burner injection mode on pulverized coal and biomass co-fired flames , 1994 .

[3]  János M. Beér,et al.  Combustion in swirling flows: A review , 1974 .

[4]  L. Baxter,et al.  Comprehensive Study of Biomass Particle Combustion , 2008 .

[5]  Klaus R. G. Hein,et al.  Effect of co-combustion of biomass on emissions in pulverized fuel furnaces , 1998 .

[6]  A L Robinson,et al.  Assessment of potential carbon dioxide reductions due to biomass-coal cofiring in the United States. , 2003, Environmental science & technology.

[7]  Peter McKendry,et al.  Energy production from biomass (Part 2): Conversion technologies. , 2002, Bioresource technology.

[8]  Jenny M. Jones,et al.  Co-firing pulverised coal and biomass: a modeling approach , 2005 .

[9]  Yong Yan,et al.  Impact of co-firing coal and biomass on flame characteristics and stability , 2008 .

[10]  Filip Johnsson,et al.  Co-firing biomass with coal for electricity generation—An assessment of the potential in EU27 , 2009 .

[11]  A. Robinson,et al.  Effect of Large Aspect Ratio of Biomass Particles on Carbon Burnout in a Utility Boiler , 2002 .

[12]  L. Baxter.  Biomass-coal co-combustion: opportunity for affordable renewable energy , 2005 .

[13]  B. Hjertager,et al.  On mathematical modeling of turbulent combustion with special emphasis on soot formation and combustion , 1977 .

[14]  Margaret S. Wooldridge,et al.  Co-firing of coal and biomass fuel blends , 2001 .

[15]  C. Westbrook,et al.  Simplified Reaction Mechanisms for the Oxidation of Hydrocarbon Fuels in Flames , 1981 .

[16]  P. Glarborg,et al.  Global Combustion Mechanisms for Use in CFD Modeling under Oxy-Fuel Conditions , 2009 .

[17]  Bradley Damstedt.  Structure and Nitrogen Chemistry in Coal, Biomass, and Cofiring Low-NOx Flames , 2007 .

[18]  Søren Knudsen Kær,et al.  Grate-firing of biomass for heat and power production , 2008 .

[19]  B. Magnussen.  On the structure of turbulence and a generalized eddy dissipation concept for chemical reaction in turbulent flow , 1981 .

[20]  Henrik Thunman,et al.  Influence of intra-particle gradients in modelling of fixed bed combustion , 2007 .

[21]  Søren Knudsen Kær,et al.  Use of numerical modeling in design for co-firing biomass in wall-fired burners , 2004 .

[22]  Lin Ma,et al.  Modelling methods for co-fired pulverised fuel furnaces , 2009 .

[23]  A. Gil,et al.  Numerical study of co-firing coal and Cynara cardunculus in a 350 MWe utility boiler , 2009 .

[24]  Larry L. Baxter,et al.  Biomass cofiring impacts on flame structure and emissions , 2007 .

[25]  Yong Yan,et al.  Characterisation of biomass and coal co-firing on a 3 MWth Combustion Test Facility using flame imaging and gas/ash sampling techniques , 2009 .

[26]  Lin Ma,et al.  Modelling the combustion of pulverized biomass in an industrial combustion test furnace , 2007 .

[27]  W. P. Jones,et al.  Global reaction schemes for hydrocarbon combustion , 1988 .

[28]  C. Chao,et al.  Co-firing coal with rice husk and bamboo and the impact on particulate matters and associated polycyclic aromatic hydrocarbon emissions. , 2008, Bioresource technology.