Applying Taguchi method to combustion characteristics and optimal factors determination in diesel/biodiesel engines with port-injecting LPG

Abstract This paper investigates combustion characteristics and decides the optimal operating factors by a Taguchi method on a diesel engine using diesel/biodiesel mixture with liquefied petroleum gas (LPG) and cooled exhaust gas recirculation (EGR) inducted in the intake port. The optimal operating factors for acquiring the largest fuel consumption time, the lowest smoke and NO X are decided for 1500 rpm and different loads. In addition, this study compares the combustion characteristics (heat release rate and ignition delay) and emissions (NO X and smoke) between the optimum combination of factors and baseline diesel engine. The results display that predictions by Taguchi method are in fair consistence with the confirmation results, and this method decreases the number of experimental runs in this study. The best fuel consumption time, smoke, and NO X at each load is acquired at a combination of B10 ( A 1 ), 40% LPG ( B 3 ) and 20% EGR ratio ( C 1 ). Moreover, the heat release rate for engine conditions is computed using a variable specific heat ratio by the experimental in-cylinder pressure. Furthermore, the best combination decreases both smoke and NO X emissions. The decrease rate is 52% for smoke and 31% for NO X at 60% engine load.

[1]  G. Abd-Alla,et al.  Using exhaust gas recirculation in internal combustion engines: a review , 2002 .

[2]  G. Nagarajan,et al.  Studies on dual fuel operation of rubber seed oil and its bio-diesel with hydrogen as the inducted fuel , 2008 .

[3]  Byungchul Choi,et al.  Emission characteristics of exhaust gases and nanoparticles from a diesel engine with biodiesel-diesel blended fuel (BD20) , 2009 .

[4]  G. A. Karim,et al.  Some Considerations of Cyclic Variations in Spark Ignition Engines Fuelled with Gaseous Fuels , 1984 .

[5]  K. A. Subramanian,et al.  Utilization of liquid biofuels in automotive diesel engines: An Indian perspective , 2005 .

[6]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[7]  Toshio Shudo,et al.  Applicability of heat transfer equations to hydrogen combustion , 2002 .

[8]  K. Murugesan,et al.  Performance optimization of Jatropha biodiesel engine model using Taguchi approach , 2009 .

[9]  S. Saravanan,et al.  Multi response optimization of NOx emission of a stationary diesel engine , 2010 .

[10]  V. P. Arunachalam,et al.  Jptimizing diesel engine parameters for emission reduction using Taguchi method : Variation risk analysis approach - Part II , 2005 .

[11]  S. Jayaraj,et al.  Performance and emission studies on biodiesel-liquefied petroleum gas dual fuel engine with exhaust gas recirculation , 2010 .

[12]  Jyotirmay Mathur,et al.  Effect of LPG Induction on Performance and Emission Characteristics of Bio-diesel in a CI Engine , 2008 .

[13]  Genichi Taguchi,et al.  Introduction to quality engineering.... , 2014 .

[14]  H. E. Saleh.  Effect of variation in LPG composition on emissions and performance in a dual fuel diesel engine , 2008 .

[15]  T. P. A. Babu,et al.  Performance Characteristics of a Dual Fuel Engine Operated with Mahua Biodiesel and Liquefied Petroleum Gas , 2011 .

[16]  Hui Wen Ku,et al.  The optimal parameters estimation for rectangular cylinders installed transversely in the flow channel of PEMFC from a three-dimensional PEMFC model and the Taguchi method , 2011 .

[17]  R. P. Benedict,et al.  ASME Measurement Uncertainty , 1985 .