Characteristics of Salt-Precipitation and the Associated Pressure Build-Up during CO2 Storage in Saline Aquifers

Mitigation and control of borehole pressure at the bottom of an injection well is directly related to the effective management of well injectivity during geologic carbon sequestration activity. Researchers have generally accepted the idea that high rates of CO2 injection into low permeability strata results in increased bottom-hole pressure in a well. However, the results of this study suggested that this is not always the case, due to the occurrence of localized salt precipitation adjacent to the injection well. A series of numerical simulations indicated that in some cases, a low rate of CO2 injection into high permeability formation induced greater pressure build-up. This occurred because of the different types of salt precipitation pattern controlled by buoyancy-driven CO2 plume migration. The first type is non-localized salt precipitation, which is characterized by uniform salt precipitation within the dry-out zone. The second type, localized salt precipitation, is characterized by an abnormally high level of salt precipitation at the dry-out front. This localized salt precipitation acts as a barrier that hampers the propagation of both CO2 and pressure to the far field as well as counter-flowing brine migration toward the injection well. These dynamic processes caused a drastic pressure build-up in the well, which decreased injectivity. By modeling a series of test cases, it was found that low-rate CO2 injection into high permeability formation was likely to cause localized salt precipitation. Sensitivity studies revealed that brine salinity linearly affected the level of salt precipitation, and that vertical permeability enhanced the buoyancy effect which increased the growth of the salt barrier. The porosity also affected both the level of localized salt precipitation and dry-out zone extension depending on injection rates. High temperature injected CO2 promoted the vertical movement of the CO2 plume, which accelerated localized salt precipitation, but at the same time caused a decrease in the density of the injected CO2. The combination of these two effects eventually decreased bottomhole pressure. Considering the injectivity degradation, a method is proposed for decreasing the pressure build-up and increasing injectivity by assigning a ‘skin zone’ that represents a local region with a transmissivity different from that of the surrounding aquifer.

[1]  A. V. Everdingen,et al.  The Skin Effect and Its Influence on the Productive Capacity of a Well , 1953 .

[2]  Van Genuchten,et al.  A closed-form equation for predicting the hydraulic conductivity of unsaturated soils , 1980 .

[3]  Fletcher G. Driscoll,et al.  Groundwater and Wells , 1986 .

[4]  K. Pruess,et al.  Thermohydrological conditions and silica redistribution near high‐level nuclear wastes emplaced in saturated geological formations , 1988 .

[5]  Harry Audus,et al.  Greenhouse gas mitigation technology: An overview of the CO2 capture and sequestration studies and further activities of the IEA Greenhouse Gas R&D Programme , 1997 .

[6]  Steven C. Young.  Impacts of Positive Skin Effects on Borehole Flowmeter Tests in a Heterogeneous Granular Aquifer , 1998 .

[7]  K. Pruess,et al.  TOUGH2 User's Guide Version 2 , 1999 .

[8]  T. Torp,et al.  Demonstrating Storage of CO_2 in Geological Reservoirs : the Sleipner and SACS Projects , 2002 .

[9]  Tore A. Torp,et al.  Demonstrating storage of CO2 in geological reservoirs: The Sleipner and SACS projects , 2004 .

[10]  I. M. Tappel,et al.  CO 2 Underground Storage for Snøhvit Gas Field Development , 2003 .

[11]  Karsten Pruess,et al.  O Mixtures in the Geological Sequestration of CO 2 . II . Partitioning in Chloride Brines at 12 − 100 ° C and up to 600 , 2004 .

[12]  Franklin M. Orr,et al.  Storage of Carbon Dioxide in Geologic Formations , 2004 .

[13]  C. Doughty,et al.  Modeling Supercritical Carbon Dioxide Injection in Heterogeneous Porous Media , 2004, Vadose Zone Journal.

[14]  T Maldal.  CO2 underground storage for Snhvit gas field development , 2004 .

[15]  K. Pruess.  ECO2N: A TOUGH2 Fluid Property Module for Mixtures of Water, NaCl, and CO2 , 2005 .

[16]  Sally M. Benson,et al.  Measuring permanence of CO2 storage in saline formations: the Frio experiment , 2005 .

[17]  Fred Riddiford,et al.  Monitoring geological storage the In Salah Gas CO2 storage project , 2005 .

[18]  Alfredo Battistelli,et al.  2D modeling of salt precipitation during the injection of dry CO2 in a depleted gas reservoir , 2007 .

[19]  L. André,et al.  Numerical modeling of fluid–rock chemical interactions at the supercritical CO2–liquid interface during CO2 injection into a carbonate reservoir, the Dogger aquifer (Paris Basin, France) , 2007 .

[20]  Sean Plasynski,et al.  The United States Department of Energy's Regional Carbon Sequestration Partnerships Program Validation Phase. , 2008, Environment international.

[21]  McMillan Burton,et al.  Time-Dependent Injectivity During CO2 Storage in Aquifers , 2008 .

[22]  Luke D. Connell,et al.  Non-isothermal flow of carbon dioxide in injection wells during geological storage , 2008 .

[23]  Takashi Ohsumi,et al.  Case study of geochemical reactions at the Nagaoka CO2 injection site, Japan , 2008 .

[24]  Stefan Bachu,et al.  CO2 storage in geological media: Role, means, status and barriers to deployment , 2008 .

[25]  Christa Clapp,et al.  Analysis of Geologic Sequestration Costs for the United States and Implications for Climate Change Mitigation , 2009 .

[26]  Karsten Pruess,et al.  CO2 injection impairment due to halite precipitation , 2009 .

[27]  Karsten Pruess,et al.  Formation dry‐out from CO2 injection into saline aquifers: 1. Effects of solids precipitation and their mitigation , 2009 .

[28]  Toby Aiken,et al.  Geological storage of CO2 in saline aquifers—A review of the experience from existing storage operations , 2010 .

[29]  Hilke Würdemann,et al.  Re-establishment of the proper injectivity of the CO2-injection well Ktzi 201 in Ketzin, Germany , 2010 .

[30]  Mohamed Azaroual,et al.  Numerical Simulations of the Thermal Impact of Supercritical CO2 Injection on Chemical Reactivity in a Carbonate Saline Reservoir , 2010 .

[31]  Eungyu Park,et al.  Evaluation of potential nonisothermal processes and heat transport during CO2 sequestration , 2010 .

[32]  Gunter Borm,et al.  CO2SINK—From site characterisation and risk assessment to monitoring and verification: One year of operational experience with the field laboratory for CO2 storage at Ketzin, Germany , 2010 .

[33]  Yildiray Cinar,et al.  Impact of Capillary Pressure, Salinity and In situ Conditions on CO2 Injection into Saline Aquifers , 2010 .

[34]  Cornelia Schmidt-Hattenberger,et al.  Geoelectrical methods for monitoring geological CO2 storage: First results from cross-hole and surface–downhole measurements from the CO2SINK test site at Ketzin (Germany) , 2010 .

[35]  Sevket Durucan,et al.  An experimental and numerical investigation into the impact of dissolution/precipitation mechanisms on CO2 injectivity in the wellbore and far field regions , 2011 .

[36]  S. Durucan,et al.  Experimental investigation into salt precipitation during CO2 injection in saline aquifers , 2011 .

[37]  Hideki Saito,et al.  Monitoring and simulation studies for assessing macro- and meso-scale migration of CO2 sequestered in an onshore aquifer: Experiences from the Nagaoka pilot site, Japan , 2011 .

[38]  Jeffrey A. Cunningham,et al.  Temporal variations in near-wellbore pressures during CO2 injection in saline aquifers , 2011 .