Extension of Emmons' spot theory to flows on blunt bodies

The transition region is considered to be characterized by the intermittent appearance of turbulent spots, which grow as they move downstream until they finally merge into one another to form the turbulent boundary layer. The intermittency factor for arbitrary axisymmetric body with zero angle of attack has been derived in an expression which can be reduced to the form of universal intermittency distribution of Dhawan and Narasimha in the case of straight tube or flat plate. A key factor to control flow conditions in the transition zone appears to be the spot formation rate, which has been deduced from the available data of the extent of transition zone. It was found that the spot formation rate depends not only on the transition Reynolds number but also on the Mach number. A comparison of the deduced spot formation rate with the neutral stability curves indicated that the neutral stability curves can be used as a guide to relate the spot formation rate to the transitional Reynolds number. Calculations of the transitional heat-transfer rate on a sphere in supersonic flow agree well with the experimental results.

[1]  G. Widhopf,et al.  Transitional and Turbulent Heat-Transfer Measurements on a Yawed Blunt Conical Nosetip , 1972 .

[2]  Eli Reshotko,et al.  Stability theory as a guide to the evaluation of transition data. , 1969 .

[3]  I. Tani,et al.  Boundary-Layer Transition , 1969 .

[4]  M. Masaki,et al.  Transitional Boundary-Layer Considerations for the Heating Analyses of Lifting Re-Entry Vehicles , 1968 .

[5]  Jack D. Whitfield,et al.  Effects of slight nose bluntness and roughness on boundary-layer transition in supersonic flows , 1962, Journal of Fluid Mechanics.

[6]  P. S. Klebanoff,et al.  The three-dimensional nature of boundary-layer instability , 1962, Journal of Fluid Mechanics.

[7]  J. W. Elder.  An experimental investigation of turbulent spots and breakdown to turbulence , 1960, Journal of Fluid Mechanics.

[8]  J. Laufer,et al.  Stability and transition of a supersonic laminar boundary layer on an insulated flat plate , 1960, Journal of Fluid Mechanics.

[9]  Roberto Vaglio-Laurin,et al.  Turbulent Heat Transfer on Blunt-Nosed Bodies in Two-Dimensional and General Three-Dimensional Hypersonic Flow , 1960 .

[10]  Peter H. Rose,et al.  Laminar Heat Transfer Around Blunt Bodies in Dissociated Air , 1959 .

[11]  A. M. O. Smith,et al.  The Smallest Height of Roughness Capable of Affecting Boundary-Layer Transition , 1959 .

[12]  Roddam Narasimha,et al.  Some properties of boundary layer flow during the transition from laminar to turbulent motion , 1958, Journal of Fluid Mechanics.

[13]  H. W. Bennett,et al.  An Experimental Study of Boundary-Layer Transition , 1957 .

[14]  G. B. Schubauer,et al.  Contributions on the Mechanics of Boundary-Layer Transition , 1955 .

[15]  H. Schlichting.  Boundary Layer Theory , 1955 .

[16]  Donald Coles,et al.  Measurements of Turbulent Friction on a Smooth Flat Plate in Supersonic Flow , 1954 .

[17]  H. W. Emmons,et al.  The Laminar-Turbulent Transition in a Boundary Layer-Part I , 1951 .

[18]  G. B. Schubauer,et al.  Laminar Boundary-Layer Oscillations and Stability of Laminar Flow , 1947 .