A wire mesh sensor (WMS) is a device used to investigate multi-phase flows. The WMS measures the instantaneous local electrical conductivity of multiphase flows at different measuring points. There is a significant difference in the electrical conductivity of the employed fluids (in this work air and water, conductivity of water is much higher than that of air). Using the difference in the electrical conductivity, the WMS provides the local void fraction. The WMS utilized in this work includes two identical planes of parallel 16×16 grid of wires. The separation distance between these two planes is 32 mm. The WMS was installed in a 76.2 mm (3-inch) diameter vertical pipe to extract information such as void fraction distribution, structure velocity, and slug/churn flow structure. The superficial gas (air) velocity (VSG) ranged from 10 to 38.4 m/s. Liquid (water) superficial velocities (VSL) of 0.30, 0.46, 0.61 and 0.76 m/s were employed. To study the effects of viscosity on the slug/churn flow structure, Carboxyl Methyl Cellulose (CMC) was added to water to increase the liquid viscosity without altering its density. Each experiment was performed for 60 seconds. An operation frequency for the WMS of 10 kHz (totaling 600,000 frames of void fraction measurement per experiment) was used for all experiments.Copyright © 2014 by ASME