Closure of "Observed Performance of Long Steel H-Piles Jacked into Sandy Soils"

Full-scale field tests were performed to study the behavior of two steel H-piles jacked into dense sandy soils. The maximum embedded length of the test piles was over 40 m and the maximum jacking force used was in excess of 7,000 kN. The test piles were heavily instrumented with strain gauges along their shafts to measure the load transfer mechanisms during jacking and the subsequent period of static load tests. Piezometers were installed in the vicinity of the piles to monitor the pore pressure responses at different depths. The time effect and the effect of installation of adjacent piles were also investigated in this study. The test results indicated that, although both piles were founded on stiff sandy strata, most of the pile capacity was carried by shaft resistance rather than base resistance. This observation implies that the design concept that piles in dense sandy soils have very large base capacity and small shaft resistance is likely to be inappropriate for jacked piles. It was also found that the variation in pore pressures induced by pile jacking was closely associated with the progress of pile penetration; the pore pressure measured by each piezometer reached a maximum when the pile tip arrived at the piezometer level. A nearby pile jacking was able to produce large tensile stresses dominating in the major portion of an installed pile; both the magnitude and distribution of the induced stresses were related to the penetration depth of the installing pile.

[1]  Jonathan D. Bray,et al.  Effect of Pile Driving on Static and Dynamic Properties of Soft Clay , 2002 .

[2]  Richard J. Jardine,et al.  Effects of installing displacement piles in a high OCR clay , 1991 .

[3]  Harry G. Poulos,et al.  Pile foundation analysis and design , 1980 .

[4]  J. Konrad,et al.  Bearing capacity of friction piles in marine clay , 1987 .

[5]  Mark Randolph,et al.  The plugging behaviour of driven and jacked piles in sand , 1997 .

[6]  Peter Lumb,et al.  The Properties of Decomposed Granite , 1962 .

[7]  H. G. Poulos,et al.  Effect of pile driving on adjacent piles in clay , 1994 .

[8]  Peter Lumb,et al.  The Residual Soils of Hong Kong , 1965 .

[9]  Paul W. Mayne,et al.  Discussion of “Side Resistance in Piles and Drilled Shafts” by Michael W. O’Neill , 2002 .

[10]  Ken Been,et al.  A STATE PARAMETER FOR SANDS , 1985 .

[11]  Richard J. Jardine,et al.  Time-related increases in the shaft capacities of driven piles in sand , 1997 .

[12]  Barry Lehane,et al.  Mechanisms of Shaft Friction in Sand from Instrumented Pile Tests , 1994 .

[13]  Jinglin Yang,et al.  State-dependent strength of sands from the perspective of unified modeling , 2004 .

[14]  R. W. Cooke,et al.  Jacked piles in London Clay: a study of load transfer and settlement under working conditions , 1979 .

[15]  M. Bolton THE STRENGTH AND DILATANCY OF SANDS , 1986 .

[16]  Bengt H. Fellenius Discussion of “Side Resistance in Piles and Drilled Shafts” by Michael W. O’Neill , 2002 .

[17]  Jun Yang Discussion of “Shaft Resistance of Single Vertical and Batter Piles Driven in Sand” by A. Hanna and T. Q. Nguyen , 2005 .

[18]  K. Gavin,et al.  BASE RESISTANCE OF JACKED PIPE PILES IN SAND , 2001 .

[19]  William H. Craig,et al.  Stress-level effects in model tests on piles , 1994 .