Small-Scale Wind Turbines Optimized for Class 2 Wind: A Wind Siting Survey and Annual Energy Production Analysis

A crucial step in evaluating a potential location for a wind turbine, especially small-scale wind turbines, is a proper wind site survey. Eventually the wind site survey is used to calculate the annual energy production (AEP) of the wind turbine and determine if this location will be profitable. Generally, a wind classification of 3 or above is recommended for any wind turbine site, according to the U.S. Department of Energy. Wind Classes of 1–2 are not considered suitable; however, data suggests that a wind site with Class of 2 wind has the potential to be more cost effective than even the least expensive offshore wind and deserves consideration. Wind data usually exists at locations such as local airports; however, the height at which this data are taken is not representative of the heights at which wind turbines will be installed and thus, airport wind data should not be used. Also, with the variability in wind from location to location, the airport data are generally not near the potential site for the wind turbine and thus, are not useful. A local wind site survey generally entails a two year study of the site using a meteorological (MET) tower. Waco, TX is being studied for the application of small-scale wind turbines. Waco is in a Class 2 wind area; however, no proper wind survey had ever been accomplished. Such a study was undertaken using a MET tower of 100 ft with two anemometers at 100 ft, one anemometer at 75 ft and one anemometer at 50 ft. This paper will describe the potential of Class 2 wind as an energy source, the erection of the MET tower, collection of the data and analysis of the data for the potential of locating a small-scale wind turbine at the site. Techniques for analyzing data when two anemometers are present will be discussed. Focus will be on identifying invalid data with an emphasis on correcting this invalid data. The data from two anemometers was then used in a novel way to identify and correct the invalid data found at both the 75 ft and 50 ft elevations. A filtering technique has also been developed to help identify invalid data. Based on the results of the wind survey, it will be shown that it is feasible to purposely design wind turbine blades for Class 2 wind which will perform better than commercially available small-scale wind turbines.Copyright © 2014 by ASME