Design and Implementation of a Long-Range RFID Reader for Passive Transponders

This paper presents a long-range RF identification (RFID) reader that has proven to work at up to 5 m with 2-W effective radiated power transmit power at 868 MHz. For the validation, a phase-shift keying backscatter modulator has been implemented, thus complementing the reader to form a complete passive RFID system focused on backscattering communication. The system has been first analyzed by means of a simulation tool, and as a result, reader design considerations are derived. Guidelines for the design of the backscatter modulator are also put forward. The reader and modulator have been fabricated and two measurement setups have been built to validate the reader performance. First, the system has been tested without antennas; -61.6-dBm reader sensitivity with only 11deg phase difference has been measured. Finally, both the reader and modulator have been complemented with their respective antennas and the system has been evaluated in a real scenario. Reflections and interferences are demonstrated to degrade reader performance; nevertheless read ranges up to 8.1 m have been measured.

[1]  Klaus Finkenzeller,et al.  Book Reviews: RFID Handbook: Fundamentals and Applications in Contactless Smart Cards and Identification, 2nd ed. , 2004, ACM Queue.

[2]  C. Dehollain,et al.  Remotely powered addressable UHF RFID integrated system , 2005, IEEE Journal of Solid-State Circuits.

[3]  Martin Fischer,et al.  Fully integrated passive UHF RFID transponder IC with 16.7-μW minimum RF input power , 2003, IEEE J. Solid State Circuits.

[4]  Lixin Ran,et al.  SIGNAL DESCRIPTIONS AND FORMULATIONS FOR LONG RANGE UHF RFID READERS , 2007 .

[5]  Lauri Sydänheimo,et al.  Implementation of Tx/Rx isolation in an RFID reader , 2006, Int. J. Radio Freq. Identif. Technol. Appl..

[6]  Ye Wu,et al.  A Universal UHF RFID Reader IC in 0.18-µm CMOS Technology , 2008, IEEE Journal of Solid-State Circuits.

[7]  G. Iannaccone,et al.  Design criteria for the RF section of UHF and microwave passive RFID transponders , 2005, IEEE Transactions on Microwave Theory and Techniques.

[8]  Roc Berenguer,et al.  Design and Analysis of a Complete RFID System in the UHF Band Focused on the Backscattering Communication and Reader Architecture , 2007 .

[9]  Yunseong Eo,et al.  A Single-Chip CMOS Transceiver for UHF Mobile RFID Reader , 2008, 2007 IEEE International Solid-State Circuits Conference. Digest of Technical Papers.

[10]  Y. Tikhov.  Comments on "Antenna design for UHF RFID tags: a review and a practical application" , 2006 .

[11]  Moon-Que Lee,et al.  A Passive Circulator with High Isolation using a Directional Coupler for RFID , 2006, 2006 IEEE MTT-S International Microwave Symposium Digest.

[12]  H. Yoshida,et al.  A 950-MHz rectifier circuit for sensor network tags with 10-m distance , 2006, IEEE Journal of Solid-State Circuits.

[13]  R. Berenguer,et al.  Simulation and measurement of a long-range passive RFID system focused on reader architecture and backscattering communication , 2008, 2008 38th European Microwave Conference.

[14]  P. Nikitin,et al.  Antenna design for UHF RFID tags: a review and a practical application , 2005, IEEE Transactions on Antennas and Propagation.