Characteristics of air cooling for cold storage and power recovery of compressed air energy storage (CAES) with inter-cooling

Abstract A combined cooling and power (CCP) system driven by the compressed air energy storage (CAES) with inter-cooling is presented, and the air cooling is compared with that of an air compression refrigeration cycle (ACRC). The main objective of this paper is to evaluate the system performance, such as the volumetric flow ratio (VFR), the size parameter (SP), the ambient temperature, the temperature at the expander inlet, the power consumption of the compressor, and the power output of the air expander. The air discharge from the cold storage is used as the heat sink for air inter-cooling. Results show that the air expander can recover most of the power consumed by the air compressor. The air temperature at the expander outlet can be controlled by adjusting the air temperature difference (ATD) between the compressor outlet and the expander inlet, and the ATD is one of the main factors that influence the power output of the air expander and the net power consumption. To realize the air cooling for the cold storage, most of the power consumption of the compressor can be simultaneously recovered by the air expander. Compared with the ACRC, the air cooing by the air expander is superior for the ATD higher than 36 °C. Overall, the CCP can recover most of the power consumption of the air compressor and realize the air cooling as a by-product for cold storage, which can be popularized in engineering applications.

[1]  Jialing Zhu,et al.  Cascade utilization of low temperature geothermal water in oilfield combined power generation, gathering heat tracing and oil recovery , 2012 .

[2]  Jia Yan,et al.  Numerical investigation of geometry parameters for pressure recovery of an adjustable ejector in multi-evaporator refrigeration system , 2013 .

[3]  Lin Lin Xia,et al.  An overview of global ocean wind energy resource evaluations , 2016 .

[4]  Ke Yang,et al.  The thermodynamic effect of air storage chamber model on Advanced Adiabatic Compressed Air Energy Storage System , 2013 .

[5]  Ennio Macchi,et al.  Efficiency Prediction for Axial-Flow Turbines Operating with Nonconventional Fluids , 1981 .

[6]  S. K. Wang,et al.  A Review of Organic Rankine Cycles (ORCs) for the Recovery of Low-grade Waste Heat , 1997 .

[7]  Ming-Jia Li,et al.  A graphical criterion for working fluid selection and thermodynamic system comparison in waste heat recovery , 2015 .

[8]  Viviani C. Onishi,et al.  Retrofit of heat exchanger networks with pressure recovery of process streams at sub-ambient conditions , 2015 .

[9]  Jia Yan,et al.  The characteristics of pressure recovery in an adjustable ejector multi-evaporator refrigeration system , 2012 .

[10]  Hongguang Jin,et al.  Thermodynamics investigation of a solar power system integrated oil and molten salt as heat transfer fluids , 2016 .

[11]  Guangming Chen,et al.  Performance optimization of adiabatic compressed air energy storage with ejector technology , 2016 .

[12]  Robert H. Williams,et al.  Optimization of specific rating for wind turbine arrays coupled to compressed air energy storage , 2012 .

[13]  Wang Shuli,et al.  Theoretical and numerical analysis on pressure recovery of supersonic separators for natural gas dehydration , 2014 .

[14]  Wenjian Cai,et al.  Pressure recovery ratio in a variable cooling loads ejector-based multi-evaporator refrigeration system , 2012 .

[15]  Zaoxiao Zhang,et al.  Optimization of Hydrogen Distribution Network Considering Pressure and heat recovery , 2015 .

[16]  A. Bejan.  Advanced Engineering Thermodynamics , 1988 .

[17]  J. K. Kaldellis,et al.  Autonomous dual-mode CAES systems for maximum wind energy contribution in remote island networks , 2010 .

[18]  Li Zhao,et al.  Dynamic modeling of compressed gas energy storage to complement renewable wind power intermittency , 2013 .

[19]  B. Klagge,et al.  Constructing China’s wind energy innovation system , 2012 .

[20]  M. Nakhamkin,et al.  AEC 110 MW CAES Plant: Status of Project , 1991 .

[21]  Donn Sederstrom,et al.  Maximizing pressure recovery using lobed nozzles in a supersonic ejector , 2012 .