The sensitivity of cartilage contact pressures in the knee joint to the size and shape of an anatomically shaped meniscal implant.

Since meniscal geometry affects the cartilage contact pressures, it is essential to carefully define the geometry of the synthetic meniscal implant that we developed. Recently, six independent modes of size- and shape-related geometry variation were identified through 3D statistical shape modeling (SSM) of the medial meniscus. However, this model did not provide information on the functional importance of these geometry characteristics. Therefore, in this study finite element simulations were performed to determine the influence of anatomically-based meniscal implant size and shape variations on knee cartilage contact pressures. Finite element simulations of the knee joint were performed for a total medial meniscectomy, an allograft, the average implant geometry, six implant sizes and ten shape variations. The geometries of the allograft and all implant variations were based on the meniscus SSM. Cartilage contact pressures and implant tensile strains were evaluated in full extension under 1200N of axial compression. The average implant induced cartilage peak pressures intermediate between the allograft and meniscectomy and also reduced the cartilage area subjected to pressures >5MPa compared to the meniscectomy. The smaller implant sizes resulted in lower cartilage peak pressures and compressive strains than the allograft, yet high implant tensile strains were observed. Shape modes 2, 3 and 6 affected the cartilage contact stresses but to a lesser extent than the size variations. Shape modes 4 and 5 did not result in changes of the cartilage stress levels. The present study indicates that cartilage contact mechanics are more sensitive to implant size than to implant shape. Down-sizing the implant resulted in more favorable contact mechanics, but caused excessive material strains. Further evaluations are necessary to balance cartilage contact pressures and material strains to ensure cartilage protection and longevity of the implant.

[1]  S. Bin,et al.  Morphologic Changes in Fresh-Frozen Meniscus Allografts Over 1 Year , 2012, The American journal of sports medicine.

[2]  Geoffrey D Abrams,et al.  Trends in Meniscus Repair and Meniscectomy in the United States, 2005-2011 , 2013, The American journal of sports medicine.

[3]  R. Parker,et al.  The Effect of Allograft Meniscal Replacement on Intraarticular Contact Area and Pressures in the Human Knee , 1997, The American journal of sports medicine.

[4]  G. Li,et al.  Variability of a three-dimensional finite element model constructed using magnetic resonance images of a knee for joint contact stress analysis. , 2001, Journal of biomechanical engineering.

[5]  E. Roos,et al.  Impact of type of meniscal tear on radiographic and symptomatic knee osteoarthritis: a sixteen-year followup of meniscectomy with matched controls. , 2003, Arthritis and rheumatism.

[6]  Robert Allaire,et al.  Biomechanical consequences of a tear of the posterior root of the medial meniscus. Similar to total meniscectomy. , 2008, The Journal of bone and joint surgery. American volume.

[7]  C. Harner,et al.  Biomechanical consequences of a tear of the posterior root of the medial meniscus. Surgical technique. , 2009, The Journal of bone and joint surgery. American volume.

[8]  A. Amis,et al.  The consequences of meniscectomy. , 2006, The Journal of bone and joint surgery. British volume.

[9]  S. H. Lo,et al.  Finite element implementation , 1996 .

[10]  G. Komenda,et al.  Changes in articular cartilage after meniscectomy. , 1990, Clinical orthopaedics and related research.

[11]  W. Harris,et al.  Primary cementless acetabular components in hips with severe developmental dysplasia or total dislocation. A concise follow-up, at an average of sixteen years, of a previous report. , 2006, The Journal of bone and joint surgery. American volume.

[12]  Van C. Mow,et al.  Structure and function of articular cartilage and meniscus , 2005 .

[13]  Diego F Villegas,et al.  Failure properties and strain distribution analysis of meniscal attachments. , 2007, Journal of biomechanics.

[14]  D. Griffin,et al.  Finite-Element Analysis , 1975 .

[15]  Miguel Ángel Martínez,et al.  A three-dimensional finite element analysis of the combined behavior of ligaments and menisci in the healthy human knee joint. , 2006, Journal of biomechanics.

[16]  V C Mow,et al.  Contact analysis of biphasic transversely isotropic cartilage layers and correlations with tissue failure. , 1999, Journal of biomechanics.

[17]  Farshid Guilak,et al.  Design of a free-floating polycarbonate-urethane meniscal implant using finite element modeling and experimental validation. , 2010, Journal of biomechanical engineering.

[18]  Edward J. Kolb,et al.  The Effects of Medial Meniscal Transplantation Techniques on Intra-Articular Contact Pressures , 2010, The journal of knee surgery.

[19]  N. Verdonschot,et al.  3D geometry analysis of the medial meniscus – a statistical shape modeling approach , 2014, Journal of anatomy.

[20]  C. McDevitt,et al.  The ultrastructure and biochemistry of meniscal cartilage. , 1990, Clinical orthopaedics and related research.

[21]  H.W.J. Huiskes,et al.  Basic orthopaedic biomechanics and mechano-biology , 2005 .

[22]  M. Hull,et al.  How the stiffness of meniscal attachments and meniscal material properties affect tibio-femoral contact pressure computed using a validated finite element model of the human knee joint. , 2003, Journal of biomechanics.

[23]  D. Amiel,et al.  Architectural remodeling in deep frozen meniscal allografts after total meniscectomy. , 1998, Arthroscopy : the journal of arthroscopic & related surgery : official publication of the Arthroscopy Association of North America and the International Arthroscopy Association.

[24]  R. Warren,et al.  Bone Plug Versus Suture-Only Fixation of Meniscal Grafts , 2014, The American journal of sports medicine.

[25]  J M Huyghe,et al.  A composition-based cartilage model for the assessment of compositional changes during cartilage damage and adaptation. , 2006, Osteoarthritis and cartilage.

[26]  Kent N. Bachus,et al.  Effect of Lateral Meniscal Allograft Sizing on Contact Mechanics of the Lateral Tibial Plateau , 2007, The American journal of sports medicine.

[27]  M. Hull,et al.  A finite element model of the human knee joint for the study of tibio-femoral contact. , 2002, Journal of biomechanical engineering.

[28]  Stephen M Howell,et al.  Identification of cross-sectional parameters of lateral meniscal allografts that predict tibial contact pressure in human cadaveric knees. , 2002, Journal of biomechanical engineering.

[29]  M. Matava.  Meniscal Allograft Transplantation: A Systematic Review , 2007, Clinical orthopaedics and related research.

[30]  T. Fukubayashi,et al.  The contact area and pressure distribution pattern of the knee. A study of normal and osteoarthrotic knee joints. , 1980, Acta orthopaedica Scandinavica.

[31]  J. Weiss,et al.  Finite element implementation of incompressible, transversely isotropic hyperelasticity , 1996 .

[32]  V C Mow,et al.  Material properties and structure-function relationships in the menisci. , 1990, Clinical orthopaedics and related research.

[33]  Gerard A Ateshian,et al.  Equivalence between short-time biphasic and incompressible elastic material responses. , 2007, Journal of biomechanical engineering.

[34]  Hongqiang Guo,et al.  Using a statistically calibrated biphasic finite element model of the human knee joint to identify robust designs for a meniscal substitute. , 2014, Journal of biomechanical engineering.

[35]  Jerry C. Hu,et al.  Structure and Function of Articular Cartilage , 2003 .

[36]  Jack Farr,et al.  Tibiofemoral Contact Mechanics after Serial Medial Meniscectomies in the Human Cadaveric Knee , 2006, The American journal of sports medicine.

[37]  M. Hull,et al.  The sensitivity of tibiofemoral contact pressure to the size and shape of the lateral and medial menisci , 2004, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[38]  Cyril B Frank,et al.  Finite element analysis of the meniscus: the influence of geometry and material properties on its behaviour. , 2003, The Knee.