Optimization of Process Parameters in Wire Electrical Discharge Machining of Inconel X-750 for Dimensional Deviation Using Taguchi Technique

[1]  Mustafa İlhan Gökler,et al.  Experimental investigation of effects of cutting parameters on surface roughness in the WEDM process , 2000 .

[3]  Jun Qu,et al.  Investigation of the spark cycle on material removal rate in wire electrical discharge machining of advanced materials , 2004 .

[4]  Hari Singh,et al.  Effects of process parameters on material removal rate in WEDM , 2009 .

[5]  Yunn-Shiuan Liao,et al.  A study to achieve a fine surface finish in Wire-EDM , 2004 .

[6]  K. Chiang,et al.  Optimization of the WEDM process of particle-reinforced material with multiple performance characteristics using grey relational analysis , 2006 .

[7]  T. A. El-Taweel,et al.  Modelling the machining parameters of wire electrical discharge machining of Inconel 601 using RSM , 2005 .

[8]  M. S. Shunmugam,et al.  Multi-objective optimization of wire-electro discharge machining process by Non-Dominated Sorting Genetic Algorithm , 2005 .

[9]  Asit Baran Puri,et al.  An analysis and optimisation of the geometrical inaccuracy due to wire lag phenomenon in WEDM , 2003 .

[10]  Ulaş Çaydaş,et al.  Experimental study of wire electrical discharge machining of AISI D5 tool steel , 2004 .

[11]  David K. Aspinwall,et al.  PRODUCTIVITY AND WORKPIECE SURFACE INTEGRITY WHEN WEDM AEROSPACE ALLOYS USING COATED WIRES , 2011 .

[12]  L. N. Harris,et al.  Taguchi techniques for quality engineering, Philip J. Ross, Mcgraw-hill book company, 1988 , 1989 .

[13]  Hari Singh,et al.  Parametric Optimization of Cryogenic-Treated D-3 for Cutting Rate in Wire Electrical Discharge Machining , 2011 .

[14]  Zhenlong Wang,et al.  Analysis of kerf width in micro-WEDM , 2009 .