In this paper, the effect of a pin-by-pin thermal-hydraulic feedback treatment on the core characteristics at a steady-state condition is investigated using a three-dimensional fine-mesh core calculation code. Currently, advanced nodal codes treat the inside of an assembly as homogeneous, and the temperature distribution inside a node is usually ignored. Namely, the fuel temperature is estimated from the assembly average power density, and the moderator temperature is calculated from the nodewise closed-channel model. However, the validity of a flat temperature distribution inside a node has not yet been investigated, because a three-dimensional pin-by-pin whole-core calculation must be done for comparison. A three-dimensional pin-by-pin nodal-transport code for a pressurized water reactor (PWR) core analysis, SCOPE2, was used in this study since it can directly treat the pin-by-pin feedback effect. A whole-core subchannel analysis code was developed to enhance the thermal-hydraulic capability of SCOPE2. The pin-by-pin feedback models for fuel and moderator temperature were established, and their impact on the core characteristics was investigated in a 3 × 3 multiassembly and the whole PWR core geometries. The calculations showed that modeling of the pin-by-pin temperature distribution revealed a negligible effect on core reactivity and only a slight impact on the radial peaking factor. The difference in the radial peaking factor that is exposed by the pin-by-pin temperature modeling is less than 0.005 in the test calculations.
[1]
K. Smith,et al.
ASSEMBLY HOMOGENIZATION TECHNIQUES FOR LIGHT WATER REACTOR ANALYSIS
,
1986
.
[2]
Allan F. Henry,et al.
SIMULATE-3 Pin Power Reconstruction: Methodology and Benchmarking
,
1989
.
[3]
Masahiro Tatsumi,et al.
Advanced PWR Core Calculation Based on Multi-group Nodal-transport Method in Three-dimensional Pin-by-Pin Geometry
,
2003
.
[4]
K. Koebke,et al.
A new approach to homogenization and group condensation
,
1980
.
[5]
D. S. Rowe.
COBRA IIIC: digital computer program for steady state and transient thermal-hydraulic analysis of rod bundle nuclear fuel elements
,
1973
.
[6]
R. D. Lawrence.
PROGRESS IN NODAL METHODS FOR THE SOLUTION OF THE NEUTRON DIFFUSION AND TRANSPORT EQUATIONS
,
1986
.
[7]
L. S. Tong,et al.
SUBCHANNEL THERMAL ANALYSIS OF ROD BUNDLE CORES.
,
1972
.
[8]
T. Takeda,et al.
Effect of Radial Void Distribution within Fuel Assembly on Assembly Neutronic Characteristics
,
2002
.