A novel two-degree-of-freedom MEMS electromagnetic vibration energy harvester

In this paper, a vibration-based MEMS electromagnetic energy harvester (EM-EH) device with two-degree-of-freedom (2DOF) configuration has been presented, modeled and characterized. The proposed 2DOF system comprises a primary subsystem for power generation, and an accessory subsystem for frequency tuning. A lumped parametric 2DOF model is built and examined in respect of energy harvesting capabilities. By controlling the mass ratio and frequency ratio, the first two resonances of primary mass can be tuned close to each other while maintaining comparable magnitudes. The 2DOF configuration is expected to be more adaptive and efficient than the conventional 1DOF structure, which could only operate near its sole resonance. The 2DOF EM-EH chip is fabricated on silicon-on-insulator (SOI) wafer through double-sided deep reactive-ion etching (DRIE). Induction coil is only patterned on the primary mass for energy conversion. With current prototype at an acceleration of 0.12 g, two resonances of 326 and 391 Hz with output voltages of 3.6 and 6.5 mV are obtained respectively, providing good validation for the modeling results. This paper offers new insights of implementing a multimodal MEMS EM-EH device.

[1]  Jan M. Rabaey,et al.  Improving power output for vibration-based energy scavengers , 2005, IEEE Pervasive Computing.

[2]  R. B. Yates,et al.  Analysis Of A Micro-electric Generator For Microsystems , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[3]  Saibal Roy,et al.  A micro electromagnetic generator for vibration energy harvesting , 2007 .

[4]  Yuji Suzuki,et al.  Recent progress in MEMS electret generator for energy harvesting , 2011 .

[5]  N. G. Stephen,et al.  On energy harvesting from ambient vibration , 2006 .

[6]  Andres F. Arrieta,et al.  An experimentally validated double-mass piezoelectric cantilever model for broadband vibration–based energy harvesting , 2012 .

[7]  Farid Ullah Khan,et al.  Copper foil-type vibration-based electromagnetic energy harvester , 2010 .

[8]  Huan Xue,et al.  Broadband piezoelectric energy harvesting devices using multiple bimorphs with different operating frequencies , 2008, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[9]  Eun Sok Kim,et al.  Micromachined Energy-Harvester Stack With Enhanced Electromagnetic Induction Through Vertical Integration of Magnets , 2015, Journal of Microelectromechanical Systems.

[10]  Henry A. Sodano,et al.  A review of power harvesting using piezoelectric materials (2003–2006) , 2007 .

[11]  H. Kulah,et al.  An Electromagnetic Micro Power Generator for Low-Frequency Environmental Vibrations Based on the Frequency Upconversion Technique , 2009, Journal of Microelectromechanical Systems.

[12]  D.P. Arnold,et al.  Review of Microscale Magnetic Power Generation , 2007, IEEE Transactions on Magnetics.

[13]  Chee Kiong Soh,et al.  Broadband Vibration Energy Harvesting Techniques , 2013 .

[14]  Andreas Vogl,et al.  Fabrication and characterization of a wideband MEMS energy harvester utilizing nonlinear springs , 2010 .

[15]  Xiao Hu,et al.  Sandwich-structured two-dimensional MEMS electret power generator for low-level ambient vibrational energy harvesting , 2015 .

[16]  Chengkuo Lee,et al.  A multi-frequency vibration-based MEMS electromagnetic energy harvesting device , 2013 .

[17]  Tao Dong,et al.  Modeling and experimental verification of low-frequency MEMS energy harvesting from ambient vibrations , 2011 .

[18]  Y. Wang,et al.  Fully integrated micro electromagnetic vibration energy harvesters with micro-patterning of bonded magnets , 2012, 2012 IEEE 25th International Conference on Micro Electro Mechanical Systems (MEMS).

[19]  Duy Son Nguyen,et al.  Nonlinear Behavior of an Electrostatic Energy Harvester Under Wide- and Narrowband Excitation , 2010, Journal of Microelectromechanical Systems.

[20]  Derek G. Chetwynd,et al.  Investigation of a resonance microgenerator , 2003 .

[21]  Dimitri Galayko,et al.  A batch-fabricated and electret-free silicon electrostatic vibration energy harvester , 2009 .

[22]  Tuna Balkan,et al.  An electromagnetic micro energy harvester based on an array of parylene cantilevers , 2009 .

[23]  Yonas Tadesse,et al.  Multimodal Energy Harvesting System: Piezoelectric and Electromagnetic , 2009 .

[24]  Jianmin Miao,et al.  Influence of deep RIE tolerances on comb-drive actuator performance , 2007 .

[25]  Xiao Hu,et al.  Out-of-plane electret-based MEMS energy harvester with the combined nonlinear effect from electrostatic force and a mechanical elastic stopper , 2015 .

[26]  Mani B. Srivastava,et al.  Emerging techniques for long lived wireless sensor networks , 2006, IEEE Communications Magazine.

[27]  Chengkuo Lee,et al.  Feasibility study of a 3D vibration-driven electromagnetic MEMS energy harvester with multiple vibration modes , 2012 .

[28]  Bernard H. Stark,et al.  Mems inertial power generators for biomedical applications , 2006 .

[29]  Jan M. Rabaey,et al.  Energy scavenging for wireless sensor networks , 2003 .

[30]  Guifu Ding,et al.  Tuning of nonlinear vibration via topology variation and its application in energy harvesting , 2012 .

[31]  Yonggang Jiang,et al.  Fabrication of a vibration-driven electromagnetic energy harvester with integrated NdFeB/Ta multilayered micro-magnets , 2011 .

[32]  S. Beeby,et al.  Strategies for increasing the operating frequency range of vibration energy harvesters: a review , 2010 .

[33]  Marco Ferrari,et al.  Piezoelectric multifrequency energy converter for power harvesting in autonomous microsystems , 2008 .

[34]  Di Chen,et al.  A MEMS-based piezoelectric power generator array for vibration energy harvesting , 2008, Microelectron. J..

[35]  David P. Arnold,et al.  FULLY BATCH-FABRICATED MEMS MAGNETIC VIBRATIONAL ENERGY HARVESTERS , 2009 .

[36]  Xiao Hu,et al.  A three-dimensional electret-based micro power generator for low-level ambient vibrational energy harvesting , 2014 .

[37]  Chengkuo Lee,et al.  Electromagnetic energy harvesting from vibrations of multiple frequencies , 2009 .