Investigating the influence of plastic waste oils and acetone blends on diesel engine combustion, pollutants, morphological and size particles: Dehalogenation and catalytic pyrolysis of plastic waste

[1]  S. Murugan,et al.  Optimization of a low heat rejection engine run on oxy‑hydrogen gas with a biodiesel-diesel blend , 2023, Fuel Processing Technology.

[2]  S. Chakma,et al.  Discernment of Synergism in Co-Pyrolysis of HDPE and PP Waste Plastics for Production of Pyro-oil: Mechanistic Investigation with Economic Analysis and Health Risk Assessment , 2022, Process Safety and Environmental Protection.

[3]  I. M. Rizwanul Fattah,et al.  Combined assessment of injection timing and exhaust gas recirculation strategy on the performance, emission and combustion characteristics of algae biodiesel powered diesel engine , 2022, Energy Sources, Part A: Recovery, Utilization, and Environmental Effects.

[4]  Surya Kanth,et al.  Experimental investigations on the effect of fuel injection parameters on diesel engine fuelled with biodiesel blend in diesel with hydrogen enrichment , 2022, International Journal of Hydrogen Energy.

[5]  A. Elfasakhany,et al.  Effects of hybrid nanoparticle additives in n-butanol/waste plastic oil/diesel blends on combustion, particulate and gaseous emissions from diesel engine evaluated with entropy-weighted PROMETHEE II and TOPSIS: Environmental and health risks of plastic waste , 2022, Energy Conversion and Management.

[6]  J. Koo,et al.  Analysis of volatile organic compounds produced during incineration of non-degradable and biodegradable plastics. , 2022, Chemosphere.

[7]  S. Chakma,et al.  Investigation in Compression Ignition Engine Performance using Alternative Fuels Produced from Waste Packaging Materials , 2022, Resources, Conservation & Recycling Advances.

[8]  Muhammad Sajjad,et al.  Microplastics in the soil environment: A critical review , 2022, Environmental Technology & Innovation.

[9]  A. A. Yusuf,et al.  Effect of low CeO2 nanoparticles dosage in biodiesel-blends on combustion parameters and toxic pollutants from common-rail diesel engine , 2022, Atmospheric Pollution Research.

[10]  Abdulfatah Abdu Yusuf,et al.  The effect of biodiesel and CeO2 nanoparticles blends on CRDI diesel engine: A special focus on combustion, particle number, PM2.5 species, organic compound and gaseous emissions , 2022, Journal of King Saud University - Engineering Sciences.

[11]  Jun Wang,et al.  Interactions of microplastics and main pollutants and environmental behavior in soils. , 2022, The Science of the total environment.

[12]  K. V. Van Geem,et al.  Opportunities and challenges for the application of post-consumer plastic waste pyrolysis oils as steam cracker feedstocks: To decontaminate or not to decontaminate? , 2021, Waste management.

[13]  A. Buettner,et al.  Deodorization of post-consumer plastic waste fractions: A comparison of different washing media. , 2021, The Science of the total environment.

[14]  A. A. Yusuf,et al.  Influence of waste oil-biodiesel on toxic pollutants from marine engine coupled with emission reduction measures at various loads , 2021, Atmospheric Pollution Research.

[15]  Paul Chen,et al.  Catalytic fast pyrolysis of low density polyethylene into naphtha with high selectivity by dual-catalyst tandem catalysis. , 2021, The Science of the total environment.

[16]  F. Berruti,et al.  Pyrolytic Conversion of Plastic Waste to Value-Added Products and Fuels: A Review , 2021, Materials.

[17]  B. D. Hardesty,et al.  Plastic pollution is killing marine megafauna, but how do we prioritize policies to reduce mortality? , 2020, Conservation Letters.

[18]  G. Rothenberg,et al.  Biodegradable Plastics: Standards, Policies, and Impacts , 2020, ChemSusChem.

[19]  K. Ragaert,et al.  Development and application of an analytical method to quantify odour removal in plastic waste recycling processes , 2020, Resources, Conservation and Recycling.

[20]  J. Dewulf,et al.  A detailed analysis of the composition of selected plastic packaging waste products and its implications for mechanical and thermochemical recycling. , 2020, Environmental science & technology.

[21]  Guozhao Ji,et al.  Liquid oils produced from pyrolysis of plastic wastes with heat carrier in rotary kiln , 2020 .

[22]  F. Inambao,et al.  Impact of n-butanol-gasoline-hydrogen blends on combustion reactivity, performance and tailpipe emissions using TGDI engine parameters variation , 2020 .

[23]  M. Martín-Lara,et al.  Novel pre-treatment of dirty post-consumer polyethylene film for its mechanical recycling , 2020 .

[24]  V. Karthickeyan,et al.  Data set on performance and relative exhaust emission (REE) characteristics of fish oil ethyl ester with fuel preheating in diesel engine , 2020, Data in brief.

[25]  A. Buettner,et al.  Odorant composition of post-consumer LDPE bags originating from different collection systems. , 2020, Waste management.

[26]  S. Kumaravel,et al.  Enhancing the fuel properties of tyre oil diesel blends by doping nano additives for green environments , 2019 .

[27]  J. M. Arandes,et al.  Fuel production by cracking of polyolefins pyrolysis waxes under fluid catalytic cracking (FCC) operating conditions. , 2019, Waste management.

[28]  A. S. Aburiazaiza,et al.  Catalytic Pyrolysis of Plastic Waste: Moving Toward Pyrolysis Based Biorefineries , 2019, Front. Energy Res..

[29]  A. J. Hunt,et al.  Catalytic pyrolysis of plastic waste for the production of liquid fuels for engines , 2019, RSC advances.

[30]  D. Sarigiannis,et al.  Morphological and chemical composition of particulate matter in buses exhaust , 2018, Toxicology reports.

[31]  G. Pierce,et al.  Microplastics in the stomach contents of common dolphin (Delphinus delphis) stranded on the Galician coasts (NW Spain, 2005-2010). , 2018, Marine pollution bulletin.

[32]  A. Ranjan,et al.  Experimental investigation on effect of MgO nanoparticles on cold flow properties, performance, emission and combustion characteristics of waste cooking oil biodiesel , 2018 .

[33]  A. P. Sathiyagnanam,et al.  Combined influence of injection timing and EGR on combustion, performance and emissions of DI diesel engine fueled with neat waste plastic oil , 2018 .

[34]  P. Tan,et al.  Exhaust particle properties from a light duty diesel engine using different ash content lubricating oil , 2018 .

[35]  Kim Ragaert,et al.  Mechanical and chemical recycling of solid plastic waste. , 2017, Waste management.

[36]  G. Shu,et al.  Effects of an anti-wear oil additive on the size distribution, morphology, and nanostructure of diesel exhaust particles , 2015 .

[37]  Viswanath K. Kaimal,et al.  A detailed study of combustion characteristics of a DI diesel engine using waste plastic oil and its blends , 2015 .

[38]  B. Moser,et al.  Catalytic Thermal Cracking of Postconsumer Waste Plastics to Fuels. 1. Kinetics and Optimization , 2015 .

[39]  Anh N. Phan,et al.  Kinetic study of municipal plastic waste , 2015 .

[40]  P. Dimopoulos Eggenschwiler,et al.  Metal particle emissions in the exhaust stream of diesel engines: an electron microscope study. , 2013, Environmental science & technology.

[41]  J. Shah,et al.  Catalytic conversion of waste high-density polyethylene into useful hydrocarbons , 2013 .

[42]  Raffaello Cossu,et al.  Waste washing pre-treatment of municipal and special waste. , 2012, Journal of hazardous materials.

[43]  M. Arabiourrutia,et al.  Characterization of the waxes obtained by the pyrolysis of polyolefin plastics in a conical spouted bed reactor , 2012 .

[44]  G. R. Kannan,et al.  Experimental evaluation of DI diesel engine operating with diestrol at varying injection pressure an , 2011 .

[45]  S. Rogak,et al.  Morphology and Raman Spectra of Engine-Emitted Particulates , 2011 .

[46]  Achyut K. Panda,et al.  Catalytic performances of kaoline and silica alumina in the thermal degradation of polypropylene , 2011 .

[47]  Paola Lettieri,et al.  The valorization of plastic solid waste (PSW) by primary to quaternary routes: From re-use to energy and chemicals , 2010 .

[48]  Dave OudeNijeweme,et al.  Cold Start Particulate Emissions from a Second Generation DI Gasoline Engine , 2007 .

[49]  Cherng-Yuan Lin,et al.  Diesel engine performance and emission characteristics of biodiesel produced by the peroxidation process , 2006 .

[50]  M. Ger,et al.  Catalytic degradation of high density polyethylene over mesoporous and microporous catalysts in a fluidised-bed reactor , 2004 .

[51]  Irianto,et al.  Effects of Acetone-Butanol-Ethanol (ABE) addition on HCCI-DI engine performance, combustion and emission , 2023, Fuel.

[52]  Z. Said,et al.  Experimental and feasibility study on nano blended waste plastic oil based diesel engine at various injection pressure: A value addition for disposed plastic food containers , 2023, Fuel Processing Technology.

[53]  F. Inambao,et al.  Evaluation of biodiesel on speciated PM2.5, organic compound, ultrafine particle and gaseous emissions from a low-speed EPA Tier II marine diesel engine coupled with DPF, DEP and SCR filter at various loads , 2022 .

[54]  K. Thangavel,et al.  Performance, emission and combustion characteristics of a diesel engine fuelled with diesel/coconut shell oil blends , 2022, Fuel.

[55]  The environmental impacts of plastics and micro-plastics use, waste and pollution: EU and national measures , 2020 .

[56]  Sun Wanchen,et al.  Characteristics of Particle Size Distributions About Emissions in A Common-rail Diesel Engine with Biodiesel Blends , 2011 .

[57]  W. Kaminsky,et al.  Pyrolysis of mixed polyolefins in a fluidised-bed reactor and on a pyro-GC/MS to yield aliphatic waxes , 2000 .

[58]  F. Matsumura,et al.  Toxic combustion by-products from the incineration of chlorinated hydrocarbons and plastics , 1994 .