Inhibition of sodium release from Zhundong coal via the addition of mineral additives: A combination of online multi-point LIBS and offline experimental measurements

[1]  Jianzhong Liu,et al.  Multi-point LIBS measurement and kinetics modeling of sodium release from a burning Zhundong coal particle , 2018 .

[2]  Zhihua Wang,et al.  Large-eddy Simulation of Pilot-assisted Pulverized-coal Combustion in a Weakly Turbulent Jet , 2017 .

[3]  Jianzhong Liu,et al.  Inhibition of Sodium Release from Zhundong Coal via the Addition of Mineral Additives: Online Combustion Measurement with Laser-Induced Breakdown Spectroscopy (LIBS) , 2017 .

[4]  Zhihua Wang,et al.  Measurement of atomic sodium release during pyrolysis and combustion of sodium-enriched Zhundong coal pellet , 2017 .

[5]  Zhihua Wang,et al.  Online-CPD-Coupled Large-Eddy Simulation of Pulverized-Coal Pyrolysis in a Hot Turbulent Nitrogen Jet , 2017 .

[6]  Jian Zhang,et al.  Ash deposition and slagging behavior of Chinese Xinjiang high-alkali coal in 3 MWth pilot-scale combustion test , 2016 .

[7]  Q. Lu,et al.  Slagging Characteristics of Zhundong Coal during Circulating Fluidized Bed Gasification , 2016 .

[8]  Y. Levendis,et al.  An overview of coal rank influence on ignition and combustion phenomena at the particle level , 2016 .

[9]  Laihong Shen,et al.  Chemical Looping Co-combustion of Sewage Sludge and Zhundong Coal with Natural Hematite as the Oxygen Carrier , 2016 .

[10]  Zhihua Wang,et al.  Release characteristic of different classes of sodium during combustion of Zhun-Dong coal investigated by laser-induced breakdown spectroscopy , 2015 .

[11]  Jianzhong Liu,et al.  Pyrolysis Characteristics of Coal, Biomass, and Coal–Biomass Blends under High Heating Rate Conditions: Effects of Particle Diameter, Fuel Type, and Mixing Conditions , 2015 .

[12]  Zhihua Wang,et al.  Experimental and modeling study of pyrolysis of coal, biomass and blended coal–biomass particles , 2015 .

[13]  Zhihua Wang,et al.  In-situ Measurement of Sodium and Potassium Release during Oxy-Fuel Combustion of Lignite using Laser-Induced Breakdown Spectroscopy: Effects of O-2 and CO2 Concentration , 2013 .

[14]  Liang Wang,et al.  A Critical Review on Additives to Reduce Ash Related Operation Problems in Biomass Combustion Applications , 2012 .

[15]  G. Nathan,et al.  Sodium and Potassium Released from Burning Particles of Brown Coal and Pine Wood in a Laminar Premixed Methane Flame Using Quantitative Laser-Induced Breakdown Spectroscopy , 2011, Applied spectroscopy.

[16]  G. Nathan,et al.  Simultaneous measurements of the release of atomic sodium, particle diameter and particle temperature for a single burning coal particle , 2009 .

[17]  G. Nathan,et al.  Quantitative measurement of atomic sodium in the plume of a single burning coal particle , 2008 .

[18]  A. Jensen,et al.  A kinetic study of gaseous potassium capture by coal minerals in a high temperature fixed-bed reactor , 2008 .

[19]  Michael Müller,et al.  Alkali Removal at about 1400 °C for the Pressurized Pulverized Coal Combustion Combined Cycle. 2. Sorbents and Sorption Mechanisms , 2007 .

[20]  I. Naruse,et al.  Emission control of sodium compounds and their formation mechanisms during coal combustion , 2007 .

[21]  J. Agnew,et al.  Reactions between sodium and kaolin during gasification of a low-rank coal , 2006 .

[22]  O. Lindqvist,et al.  A kinetic study of gaseous alkali capture by kaolin in the fixed bed reactor equipped with an alkali detector , 2005 .

[23]  T. Fernholz,et al.  In situ detection of potassium atoms in high-temperature coal-combustion systems using near-infrared-diode lasers. , 2002, Spectrochimica acta. Part A, Molecular and biomolecular spectroscopy.

[24]  Gunnar Eriksson,et al.  FactSage thermochemical software and databases , 2002 .

[25]  W. Pan,et al.  The Varying Characterization of Alkali Metals (Na, K) from Coal during the Initial Stage of Coal Combustion , 2001 .

[26]  B. Chadwick,et al.  Screening of potential mineral additives for use as fouling preventatives in Victorian brown coal combustion , 1999 .

[27]  Dongke Zhang,et al.  Investigations into the control of agglomeration and defluidisation during fluidised-bed combustion of low-rank coals , 1999 .

[28]  T. Wall,et al.  Reducing fouling from brown coals by sodium-binding additives , 1998 .

[29]  J. D. Winefordner,et al.  Fundamentals and Applications of Laser-Induced Breakdown Spectroscopy , 1997 .

[30]  Joseph Sneddon,et al.  Applications of Laser-Induced Breakdown Spectrometry , 1997 .

[31]  T. Wall,et al.  Reducing fly ash deposition by pretreatment of brown coal: Effect of aluminium on ash character , 1996 .

[32]  J. Wolfrum,et al.  In situ alkali concentration measurements in a pressuried, fluidized-bed coal combustor by excimer laser induced fragmentation fluorescence , 1996 .

[33]  F. Shadman,et al.  The kinetics and mechanism of alkali removal from flue gases by solid sorbents , 1990 .

[34]  Farhang Shadman,et al.  Aluminosilicate Sorbents for Control of Alkali Vapors during Coal Combustion and Gasification , 1988 .

[35]  Steven A. Benson,et al.  Comparison of inorganic constituents in three low-rank coals , 1985 .

[36]  R. J. Quann,et al.  Mineral matter and trace-element vaporization in a laboratory-pulverized coal combustion system. , 1982, Environmental science & technology.

[37]  S. H. Lee,et al.  Removal of Gaseous Alkali Metal Compounds from Hot Flue Gas by Particulate Sorbents , 1980 .