Lock-In Signal Post-Processing Techniques in Infra-Red Thermography for Materials Structural Evaluation

This paper describes the potential of off-line thermographic signal processing by means of Lock-In Correlation algorithms, in order to implement structural health monitoring and stress analysis techniques. Thermal datasets acquired by infrared thermocameras are locked-in and correlated numerically with opportune reference signals, and amplitude and phase values of various harmonics retrieved by means of a Fast Fourier Transform and time averaging based filtering. This information is then processed for NDT defect probing and for evaluating the Thermoelastic Effect induced temperature changes. Two case studies in particular are discussed, implementing the proposed signal lock-in processing: a Thermoelastic Stress Analysis of a Brazilian disc under cyclic compression, and NDT of a delaminated polymer matrix composite panel. The NDT case study evidences the ability of the lock-in algorithm to analyse the response of the component to multi-frequency modulated heat waves, while both case studies demonstrate the potentials of the off-line signal treatment to enable low cost thermal setups.

[1]  Clemente Ibarra Castanedo,et al.  Quantitative subsurface defect evaluation by pulsed phase thermography: depth retrieval with the phase , 2005 .

[2]  G. Pitarresi,et al.  A review of the general theory of thermoelastic stress analysis , 2003 .

[3]  Maurice G. Cox,et al.  The use of a Monte Carlo method for evaluating uncertainty and expanded uncertainty , 2006 .

[4]  I. D. Hill,et al.  Generating good pseudo-random numbers , 2006, Comput. Stat. Data Anal..

[5]  Giuseppe Pitarresi,et al.  Thermoelastic stress analysis of a 2D stress field using a single detector infrared scanner and lock-in filtering , 2009 .

[6]  Xavier Maldague,et al.  Theory and Practice of Infrared Technology for Nondestructive Testing , 2001 .

[7]  D. S. Mountain,et al.  Stress Pattern Analysis By Thermal Emission (SPATE) , 1979, Other Conferences.

[8]  Raphael Danjoux,et al.  Numerical System For Infrared Scanners And Application To The Subsurface Control Of Materials By Photothermal Radiometry , 1986, Other Conferences.

[9]  A. M. Siddiolo,et al.  Thermoelastic stress analysis by means of an infrared scanner and a two-dimensional fast Fourier transform-based lock-in technique , 2008 .

[10]  Umberto Galietti,et al.  Investigation on the Influence of the Surface Resin Rich Layer on the Thermoelastic Signal from Different Composite Laminate Lay-Ups , 2005 .

[11]  R. Rowlands,et al.  Thermoelastic Stress Analysis , 2008 .

[12]  Boguslaw Wiecek,et al.  Comparison of Fourier and wavelet analyses for defect detection in lock-in and pulse phase thermography , 2007 .

[13]  Y. Jourlin,et al.  Infrared characterization of hot spots in solar cells with high precision due to signal treatment processing , 1998 .

[14]  P Stanley,et al.  Beginnings and Early Development of Thermoelastic Stress Analysis , 2008 .

[15]  P Stanley.  On the isopachic contours in the Brazilian disc specimen , 2011 .

[16]  E. Zanetti,et al.  Thermoelastic and elastoplastic effects measured by means of a standard thermocamera , 2004 .

[17]  P. K. Kuo,et al.  Phase-Locked Image Acquisition In Thermography , 1989, Other Conferences.

[18]  P Stanley,et al.  Development and applications of thermoelastic stress analysis , 1998 .

[19]  Jingmin Dai,et al.  Research on thermal wave processing of lock-in thermography based on analyzing image sequences for NDT , 2010 .

[20]  Andreas Mandelis,et al.  Thermal-wave radar: a novel subsurface imaging modality with extended depth-resolution dynamic range. , 2009, The Review of scientific instruments.

[21]  S. Tuli,et al.  Theory of frequency modulated thermal wave imaging for nondestructive subsurface defect detection , 2006 .

[22]  Ravibabu Mulaveesala,et al.  Pulse compression approach to infrared nondestructive characterization. , 2008, The Review of scientific instruments.

[23]  T. G. Ryall,et al.  Design of a focal-plane array thermographic system for stress analysis , 1995 .

[24]  Suneet Tuli,et al.  A comparison of the pulsed, lock-in and frequency modulated thermography nondestructive evaluation techniques , 2011 .

[25]  Umberto Galietti,et al.  A Quantitative Analysis of the Thermoelastic Effect in CFRP Composite Materials , 2010 .

[26]  Pierre Bremond,et al.  Lock-in thermography: a tool to analyze and locate thermomechanical mechanisms in materials and structures , 2001, SPIE Defense + Commercial Sensing.

[27]  Lars Magne Haldorsen,et al.  Thermoelastic stress analysis system developed for industrial applications , 1998 .

[28]  Giuseppe Pitarresi,et al.  Implementation of Active Infrared NDT Techniques Using Long Square Heating Pulses , 2012 .

[29]  W. M. Cummings,et al.  Thermoelastic stress analysis , 1991 .

[30]  G. Busse,et al.  Thermal wave imaging with phase sensitive modulated thermography , 1992 .

[31]  Peter M. Harris,et al.  Software simulation of a lock-in amplifier with application to the evaluation of uncertainties in real measuring systems , 2010 .

[32]  Wilhelm Warta,et al.  Lock-in thermography , 2003 .

[33]  Gerd Busse,et al.  Lock-in thermography for nondestructive evaluation of materials , 1998 .

[34]  Andreas Mandelis,et al.  Thermophotonic radar imaging: An emissivity-normalized modality with advantages over phase lock-in thermography , 2011 .

[35]  John Leis,et al.  Simplified digital lock-in amplifier algorithm , 2012 .