Utilization of RF I-V waveform load-pull information to identify the role FET knee profile has on locating the efficiency maxima

Typically performance maxima in terms of output power, efficiency, etc. are determined from analyzing, effectively “data mining”, load-pull measurements. This approach while identifying relevant design information provides no insight into the origin or location of the relevant maxima. However, if during load-pull measurements the RF I-V waveforms are also measured this insight is available. Measured RF I-V waveform load-pull information from a 10×75μm Gallium Arsenide transistor operating in class-B at 8GHz is used to correctly identify the effect of the knee region of the transistor I-V characteristic on power and efficiency. As a consequence the location of the drain efficiency contours on the Smith Chart are explained in terms of Vmin and current waveform compression.

[1]  J. Benedikt,et al.  Design Approach for Realization of Very High Efficiency Power Amplifiers , 2007, 2007 IEEE/MTT-S International Microwave Symposium.

[2]  A. L. Clarke,et al.  The Continuous Class-F Mode Power Amplifier , 2010, The 5th European Microwave Integrated Circuits Conference.

[3]  S. C. Cripps,et al.  RF Power Amplifiers for Wireless Communications , 1999 .

[4]  A. L. Clarke,et al.  On the Extension of the Continuous Class-F Mode Power Amplifier , 2011, IEEE Transactions on Microwave Theory and Techniques.

[5]  J. Lees,et al.  On the Continuity of High Efficiency Modes in Linear RF Power Amplifiers , 2009, IEEE Microwave and Wireless Components Letters.

[6]  F. Raab.  Class-F power amplifiers with maximally flat waveforms , 1997 .

[7]  J. Lees,et al.  A Methodology for Realizing High Efficiency Class-J in a Linear and Broadband PA , 2009, IEEE Transactions on Microwave Theory and Techniques.

[8]  P. J. Tasker,et al.  Investigation and analysis into device optimization for attaining efficiencies in-excess of 90% when accounting for higher harmonics , 2010, 2010 IEEE MTT-S International Microwave Symposium.