On the Use of a Single Beam Acoustic Current Profiler for Multi-Point Velocity Measurement in a Wave and Current Basin

Harnessing the energy of tidal currents has huge potential as a source of clean renewable energy. To do so in a reliable and cost effective way, it is critical to understand the interaction between tidal turbines, waves, and turbulent currents in the ocean. Scaled testing in a tank test provides a controlled, realistic, and highly reproducible down-scaled open ocean environment, and it is a key step in gaining this understanding. Knowledge of the hydrodynamic conditions during tests is critical and measurements at multiple locations are required to accurately characterise spatially varying flow in test tank facilities. The paper presents a laboratory technique using an acoustic velocimetry instrument, the range over-which measurements are acquired being more akin to open water applications. This enables almost simultaneous multi-point measurements of uni-directional velocity along a horizontal profile. Velocity measurements have been obtained from a horizontally mounted Single Beam Acoustic Doppler (SB-ADP) profiler deployed in the FloWave Ocean Energy Research Facility at the University of Edinburgh. These measurements have been statistically compared with point measurements obtained while using a co-located Acoustic Doppler Velocimeter (ADV). Measurements were made with both instruments under flow velocities varying from 0.6 ms−1 to 1.2 ms−1, showing that flow higher than 1 ms−1 was more suitable. Using a SB-ADP has shown the advantage of gaining 54 simultaneous measurement points of uni-directional velocity, covering a significant area with a total distance of 10 m of the test-tank, at a measurement frequency of 16 Hz. Of those measurement points, 41 were compared with co-located ADV measurements covering 8 m of the profile for a tank nominal flow velocity of 0.8 ms−1, and four distributed locations were chosen to to carry out the study at 0.6 ms−1, 1.0 ms−1, and 1.2 ms−1. The comparison with the ADV measurement showed a 2% relative bias on average.

[1]  R. Cabrera,et al.  Direct measurements of Reynolds stress with an acoustic Doppler velocimeter , 1995, Proceedings of the IEEE Fifth Working Conference on Current Measurement.

[2]  V. Venugopal,et al.  Capture and simulation of the ocean environment for offshore renewable energy , 2019, Renewable and Sustainable Energy Reviews.

[3]  Panagiotis D. Kaklis,et al.  Spatial variation in currents generated in the FloWave Ocean Energy Research Facility , 2015 .

[4]  Kevin A. Oberg,et al.  Evaluation of mean velocity and turbulence measurements with ADCPs , 2007 .

[5]  Ian Bryden,et al.  The generation of 3D flows in a combined current and wave tank , 2015 .

[6]  R. Gordon.  Principles of Operation A Practical Primer , 1996 .

[7]  Ramon Cabrera,et al.  New Acoustic Meter for Measuring 3D Laboratory Flows , 1994 .

[8]  Paul Mycek,et al.  Experimental study of the turbulence intensity effects on marine current turbines behaviour. Part II: Two interacting turbines , 2014 .

[9]  G. Germain,et al.  Three tidal turbines in interaction: An experimental study of turbulence intensity effects on wakes and turbine performance , 2020, Renewable Energy.

[10]  David Clelland,et al.  Assessment of an ADCP’s capabilities in laboratory conditions , 2015, 2015 IEEE/OES Eleveth Current, Waves and Turbulence Measurement (CWTM).

[11]  A. Kiprakis,et al.  Experimental Assessment of Flow, Performance, and Loads for Tidal Turbines in a Closely-Spaced Array , 2020, Energies.

[12]  Vengatesan Venugopal,et al.  Characterisation of Tidal Flows at the European Marine Energy Centre in the Absence of Ocean Waves , 2018 .

[13]  K. Theriault.  Incoherent multibeam Doppler current profiler performance: Part II--Spatial response , 1986 .

[14]  Takuma Suzuki,et al.  Noise of Acoustic Doppler Velocimeter Data in Bubbly Flows , 2007 .

[15]  G. Voulgaris,et al.  Evaluation of the Acoustic Doppler Velocimeter (ADV) for Turbulence Measurements , 1998 .

[16]  W. Rodi,et al.  Open‐channel Flow Measurements with a Laser Doppler Anemometer , 1986 .

[17]  Vladimir Nikora,et al.  Despiking Acoustic Doppler Velocimeter Data , 2002 .

[18]  Blair H. Brumley,et al.  Performance of a broad-band acoustic Doppler current profiler , 1991 .

[19]  David M. Ingram,et al.  Single-Beam Acoustic Doppler Profiler and Co-Located Acoustic Doppler Velocimeter Flow Velocity Data , 2020, Data.

[20]  Grégory Pinon,et al.  Experimental characterisation of flow effects on marine current turbine behaviour and on its wake properties , 2010 .

[21]  Paul Mycek,et al.  Experimental study of the turbulence intensity effects on marine current turbines behaviour. Part I: One single turbine , 2014 .

[22]  Stephanie Ordonez-Sanchez,et al.  Experimental optimisation of power for large arrays of cross-flow tidal turbines , 2018 .

[23]  Ian Bryden,et al.  The design and commissioning of the first, circular, combined current and wave test basin , 2014, OCEANS 2014 - TAIPEI.

[24]  K. Theriault.  Incoherent multibeam Doppler current profiler performance: Part I--Estimate variance , 1986 .

[25]  Duncan Sutherland,et al.  Characterisation of current and turbulence in the FloWave Ocean Energy Research Facility , 2017 .

[26]  John L. Lumley,et al.  The laser-Doppler velocimeter and its application to the measurement of turbulence , 1973, Journal of Fluid Mechanics.

[27]  Paul Mycek,et al.  Numerical and experimental study of the interaction between two marine current turbines , 2013 .